Cyberdata 011406 InformaCast® Enabled Loudspeaker Amplifier (AC-Powered) Quick Reference
Add to my manuals2 Pages
advertisement
▼
Scroll to page 2
Mounting the Enclosure Installation Quick Reference To mount the enclosure: 1. Prepare holes for the screws. The IP Endpoint Company 2. Plug in the power adapter and use the Power (PWR) LED to verify that the power is on. 3. Plug the ethernet cable into the device. The Link/Activity (Link/Act.) LED verifies the network connection. Singlewire InformaCast Loudspeaker Amplifier (AC-Powered) SIP Compliant 011406 Parameter Factory Default Setting IP Addressing DHCP a 10.10.10.10 IP Address 4. For wall mounting, use the three #8 x 1-1/4-inch Pan Head Phillips SelfTapping Screws. Web Access Username admin Web Access Password admin Subnet Maska 255.0.0.0 a 10.0.0.1 Default Gateway a. Default if there is not a DHCP server present. Getting Started • Download the Operations Guide PDF file from the Documents tab at the following webpage: http://www.cyberdata.net/voip/011406/ • Create a plan for the locations of your paging amplifiers. • WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes. • WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation instructions. • WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant. • WARNING: The Singlewire InformaCast Loudspeaker Amplifier enclosure is not rated for any AC voltages! Wiring the 125V AC Plug The green wire with the yellow stripe is a ground connection for electrostatic discharge (ESD) protection, and should not be removed. To wire the 125V AC plug, consult a licensed electrician and the local building codes in your area. Parts (1) Assembly (1) Wall Mounting Kit (3) #8 Plastic Anchors (3) #8 x 1-1/4" Pan Head Phillips Self-Tapping Screws Contacting CyberData (1) Enclosure Corporate Headquarters CyberData Corporation 3 Justin Court Monterey, CA 93940, USA Phone: 831-373-2601 Fax: 831-373-4193 http://www.cyberdata.net/ Sales: (831) 373-2601 ext. 334 Support: 831-373-2601 ext. 333 Support Website: http://support.cyberdata.net/ RMA Department: (831) 373-2601 ext. 136 RMA Email: [email protected] RMA Status: http://support.cyberdata.net/ Warranty Information: http://support.cyberdata.net/ © 2018, CyberData Corporation, ALL RIGHTS RESERVED 931279C Additional Parts (1) CAT 5e/CAT6 cable Quick Reference Quick Reference 931279C (1) PoE Power Injector © 2018, CyberData Corporation, ALL RIGHTS RESERVED Features Dimensions and Mounting Template RTFM Switch VoIP Loudspeaker 6.281 [159.54] Dimensions are in Inches [Millimeters] To broadcast the device’s current IP address, press and hold the RTFM switch for a couple of seconds and then release it. To restore the factory defaults, complete the following steps: RTFM 1. Press and hold the RTFM switch until you hear the device announce the words, “restoring defaults” and “rebooting”. 2. Release the RTFM switch. The device will be restored to the factory default settings. Speaker Volume Volume Speed (SPD) LED (AMBER) The Speed (SPD) LED illuminates AMBER for a 100Mb link or is off for a 10MB link when the network link to the device is established. SPD Link/Act. 14.500 [368.30] Link/Activity (Link/Act.) LED (GREEN) The GREEN Link/Activity (Link/Act.) LED blinks to indicate network traffic. 7.938 [201.63] PWR Status Status LED (GREEN) The GREEN Status LED illuminates after supplying power to the device. Power (PWR) LED (GREEN/BLUE) The Power (PWR) LED is GREEN in low power mode (802.3af) and BLUE during high power mode (802.3at). 10.875 [276.23] Dimensions are in Inches [Millimeters] *See the Operations Guide for more information about the features in this section. 4.375 [111.13] Cable Grommets (3 PLCS) © 2018, CyberData Corporation, ALL RIGHTS RESERVED 931279C Quick Reference Quick Reference 931279C © 2018, CyberData Corporation, ALL RIGHTS RESERVED
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project