Webasto | Base Plate / Slide Assembly | Installation manual | Webasto Base Plate / Slide Assembly Installation guide

Webasto Base Plate / Slide Assembly Installation guide
Cargo Silder Attachment Bracket Installation and Service Parts
a
Jeep Wrangler (JL) – 4 Door, 2018 and up
a
Kit Contents:
Part Number
Description
Quantity
5012122A
Hardware
1
5012989A
Bracket – Slider
Mount Front JL
1
5012990A
Bracket – Slider
Mount Rear JL
1
Image
Required Tools:
Description
Image
Socket Wrench
10 mm Socket (if installing slider)
T-40 Driver Handle or Socket
Original 7/2018 /
Rev N/A
/
PN: 5012163A
INSTALLATION
NOTE: Before proceeding, make sure to remove and relocate the Factory
Jack Assembly located in the Rear Storage Compartment to ensure ease
of access during an emergency situation.
Figure 1
Step 1 Remove Existing Hardware: Use a T40 Torx to remove the two
front and two rear Luggage Retainers from the both Bin Trim Systems
(Figure 1). In case of Trail Rail (not shown) remove the front and rear
Attachment Bolts from both Rails, depending on the number and position
of Slide Systems to be installed you may also need to reposition and/or
remove the Trail Rail Trolleys
Step 2 Install Brackets: Position the Front and Rear Slider Brackets as
shown (Figure 2), Be sure the larger Bracket is in the forward vehicle
position and the arrows on both Brackets are pointing forward to the
front of the vehicle. Use the M8 Hex Bolts to secure the Brackets to the vehicle.
Step 3 Install Slider (Sold Separately): Align the Slider in the desired position over the attachment points on the Slider Brackets
(Figure 2), make sure the Slider is positioned so it will extend rearward in the vehicle. Use the M6 Hex Bolts to secure the Slider
to the Brackets.
Figure 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising