advertisement
▼
Scroll to page 2
AVR486S_E3.qxd 06.3.28 10:57 AM Page 1 A/V Receiver AVR-486 DTS-ES Discrete 6.1 and Dolby Digital EX with Power Amps for 7 Channels ■ High-Quality Surround Sound Reproduction • High Resolution 32bit Floating Point DSP • 96 kHz Processing Circuit • 3 Sets of Component Video Inputs • 3 Sets of S-Video Switching ■ Fully Discrete, Equal Power 7 Amplifier Channels, 75 Watts Each Front 75 W + 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) Center 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) Surround 75 W + 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) Surround Back 75 W + 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) For optimum Dolby Digital and DTS reproduction, the AVR-486 features high quality, wideband audio amplification, providing 75 watts power output for each of the 7 main channels. A large capacity power supply includes a high current power transformer along with discrete power output devices on all 7 amplifier channels for highest dynamic range and superb reproduction clarity. ■ DENON's Basic Design for High-Quality Sound Reproduction • Power Transformer for High Power Driven The chassis that supports the large transformer has been designed to absorb vibration, and the transformer is housed inside a highly rigid frame to secure it more solidly to the chassis. In addition, a cushioning material has been placed around the core of the transformer to minimize interference on the signal and enable more faithful reproduction of the original sound. The AVR-486 inherits these low-noise design from higher-end models not to mention the use of short ring. • Twin Drive Rectifier DENON's Twin Drive Rectifier design uses two rectifying diodes in parallel to bring out the maximum potential of the large transformer. Since the rectifiers recharge the large block capacitors at low impedance, they are able to supply ample current to reproduce deep basses as well as sudden bursts of sound from percussion or other musical instruments. • Large Aluminum Extruded Heatsink DENON uses large heatsink made of extruded aluminum. They have been placed in a design that ensures mostly uniform temperatures throughout the heatsink so that the output transistors for all channels can be driven under uniform conditions. This in turn ensures that all channels respond with equal performance to the demands of the audio signals. ■ Wide-Range Play Capability for DVD-Audio and Super Audio CD The power amp circuits of the AVR-486 have been meticulously designed to reproduce the exceptionally high sound quality with wide frequency response from 10 Hz to 100 kHz. ■ Dual Channel Surround Back Power Amp for 7.1 Surround The AVR-486 is equipped with a total of 7 power amps including 2 for the Surround Back channel speaker to give you more clearly defined sound localization at the rear for 6.1-channel surround sources such as DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, Dolby Digital EX, and DTS-ES NEO:6. ■ Cinema Equalizer The sound from movie sources recorded in Dolby Digital, DTS or other formats emphasizes high-frequency range due to a theater’s front speakers being placed behind the movie screen. If this sound is reproduced in the home theater without correction, the high-frequency range is too strong. The AVR-486 features a Cinema Equalizer to correct these high-frequency components so that the sound is clearer and easier to listen to. (For Dolby Digital, Dolby Pro Logic IIx, Dolby Digital EX and DTS surround modes) ■ Assignable surround back (L/R) amplifiers for Multi-zone playback Amplifiers initially reserved for Surround back (L/R) channels can be assigned to Zone 2 speakers. ■ Personal Memory Plus, for Easy Operation The AVR-486 includes the Personal Memory Plus function that automatically remembers the surround mode you last used for each program source, so that you do not need to select the mode again for that program. ■ Acclaimed Customization Feature As with all of DENON’s high-grade A/V receiver, the AVR-486 lets you adjust delay times and other parameters so that you can customize the performance of the AVR-486 to suit your own home theater and enhance operating ease. The adjustments are easy to make via a dialog format on the fluorescent display on the front panel. These customized features are then stored, for each source input and surround mode, in Personal Memory Plus so constant readjustments are not required. ■ Multi-Function Preset Memory Remote Controller with Glo-keys ■ DENON's Latest Surround Technology Faithfully Recreates the Surround Sound Produced at the Dubbing Stage. • DTS 96/24 Decoding for DVD-Video • DTS-ES Discrete 6.1 and Matrix 6.1 • DTS NEO:6 • Dolby Digital EX • Dolby Pro Logic IIx ■ 5 Channel/ 7 Channel Stereo Mode DENON's popular 7 Channel Stereo mode transforms your favorite 2-channel sources such as CD, tape, stereo radio and stereo video sources into exciting surround sound, free of delay effects and unnatural artifacts, from all 7 speakers. This 7 Channel Stereo mode was originally developed by DENON to enhance music lovers' enjoyment with home theater ambience. ■ DENON DSP Surround Modes Add Listening Excitement Put yourself in the middle of your favorite concert hall and music environments with DENON's DSP acoustic environment simulation modes. These DSP modes add spacious surround sound enhancements to your favorite music and video sources, and include these distinctly different sounding effects: 1. 5 / 7 Channel Stereo 2. Virtual Surround 3. Rock Arena 4. Jazz Club 5. Video Game 6. Matrix 7. Mono Movie ■ Adjustable Cross-Over Switching The AVR-486 supports subwoofer cross-over switching with a choice of 8 cross-over frequencies: 40/60/80/100/120/150/200/250Hz. This lets you more accurately match the performance characteristics of the subwoofer to the main speaker system. ■ Component video circuits which maintain flat response up to 100MHz, ensuring sharp image quality Other features ■ Night Mode for not disturbing others ■ Front Panel Inputs ■ Front A/B Speaker Terminals ■ High-grade Speaker Terminals (All ch) ■ Frequency Synthesis Tuning • 56-Station AM/FM Random Preset Memory Tuning • Auto Preset Memory AVR486S_E3.qxd 06.3.28 10:57 AM Page 2 AVR-486 Input/Output Terminals for Every A/V System Audio Inputs 8 Analog Inputs CD, (TUNER), DVD/VDP, TV/DBS, AUX, VCR, CDR/TAPE, V.AUX(FRONT) 6 Analog EXT. Inputs FRONT L/R, CENTER, SURROUND L/R, SUBWOOFER 3 Digital Inputs OPTICAL X 1 COAXIAL X 2 Audio Outputs 1 Analog PRE OUT Terminal 2 Analog REC OUT Terminals SUBWOOFER VCR, CDR/TAPE Video Inputs 3 Component Video Inputs 4 Composite Inputs 3 S-Video Inputs DVD/VDP, TV/DBS, VCR DVD/VDP, TV/DBS, VCR, V.AUX(FRONT) DVD/VDP, TV/DBS, VCR Video Outputs 1 Component Video Output 2 Composite Outputs 2 S-Video Outputs MONITOR VCR, MONITOR VCR, MONITOR Specifications Power Amplifier Section Rated output Front Center Surround Surround Back *THD figures are power amp stage values. 75 W + 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) 110 W + 110 W (6 ohms, 1 kHz, 0.7 % THD) 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) 110 W (6 ohms, 1 kHz, 0.7 % THD) 75 W + 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) 110 W + 110 W (6 ohms, 1 kHz, 0.7 % THD) 75 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD) 110 W (6 ohms, 1 kHz, 0.7 % THD) Preamplifier Section Input sensitivity/Impedance CD, DVD/VDP, TV/DBS, VCR, CDR/TAPE, AUX,V.AUX(FRONT) 200 mV/47 kohms Output level/Load impedance SUBWOOFER CDR/TAPE, VCR Frequency response Signal-to-noise ratio Tone control FM Section Tuning frequency range Usable sensitivity AM Section Tuning frequency range Usable sensitivity General Power supply Power consumption Dimensions Weight 1.2 V/10 kohms 200 mV/47 kohms 10 Hz - 100 kHz (+1, -3 dB) (Tone Defeat On) 98 dB (IHF-A weighted) (Tone Defeat On) Treble: ±10 dB at 10 kHz Bass: ±10 dB at 100 Hz 87.5 - 107.9 MHz 1.0 µV (11.2 dBf) 520 - 1710 kHz 18 µV AC 120 V, 60 Hz 4.3 A 17-3/32” (W) x 5-25/32” (H) x 1-23/64” (D) 434 (W) x 147 (H) x 417 (D) mm 24 lbs 8 oz, 11.1 kg * Design and specifications are subject to change without notice. * ”Dolby”, “Dolby Digital”, “Pro Logic II”, “Dolby Digital EX” and the double-D device are registered trademarks of Dolby Laboratories Licensing Corporation. * DTS is registered trademarks of DTS Technology. * Kodak is a trademark of Eastman Kodak Company. * "WMA"(Windows Media Audio) is a new audio codec developed by Microsoft® in the United States of America. * “Windows Media™” , “Windows®” are trademarks of Microsoft Corporation, Inc. Denon Electronics (USA), LLC. 19C Chapin Road, Suite 205 Pine Brook, N.J. 07058-9385 USA TEL: 973-396-0810 usa.denon.com Denon Canada Inc. 505 Apple Creek Blvd, Unit 5, Markham, Ontario, Canada L3R 5B1 TEL: 905-475-4085 ca.denon.com Denon Brand Company D&M Building, 2-1 Nisshin-cho, Kawasaki-ku, Kanagawa 210-8569, Japan www.denon.com
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project