American Hearth | Renegade Clean-Face Direct-Vent Driftwood Log Set -30 | Owner Manual | White Mountain Hearth Rushmore Clean-Face Direct-Vent Driftwood Log Set-30 Owner Manual

White Mountain Hearth Rushmore Clean-Face Direct-Vent Driftwood Log Set-30 Owner Manual
INSTALLATION INSTRUCTIONS
(SEE HOMEOWNER MANUAL FOR OPERATING INSTRUCTIONS)
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
LOG SET MODEL
LS30DINF
GAS-FIRED
For Use With
DVCT30CB Fireplace Insert
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do
not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
— Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
NOTICE: Ceramic logs may differ in appearance
from those shown in this manual.
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
�
LOG IDENTIFICATION
DVCT30
PART#
FRONT
TOP
Ember Bed (A)
Ember Bed (A)
Log (B)
Log (B)
Ember Bed (C)
Ember Bed (C)
Ember Bed (D)
Ember Bed (D)
Log (E)
Log (E)
Log (F)
Log (F)
Log (G)
Log (G)
38768
38769
38770
38771
38772
38773
38774
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.
Page 2
38800-0-0218
LOG IDENTIFICATION
DVCT30
PART#
FRONT
TOP
Log (H)
Log (H)
Log (I)
Log (I)
Log (J)
Log (J)
Log (K)
Log (K)
Log (L)
Log (L)
Log (M)
Log (M)
Log (N)
Log (N)
38775
38776
38777
38778
38779
38780
38781
36747
Coals (100)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.
38800-0218
Page 3
LOG AND EMBER PLACEMENT
NOTICE: Install liners before logs. See separate Liner Installation
manual for details.
CAUTION
Do not handle these logs with your bare hands. Always
wear gloves to prevent skin irritation from ceramic fibers.
After handling the logs, wash your hands gently with soap
and water to remove any trace of fibers.
Accessing the Interior of the Fireplace
See Homeowners Manual for instruction on how to remove the
barrier screen and glass door.
Glowing Embers Information
1. Carefully separate the ember material into small amounts
(no larger than “quarter-size” pieces).
a. Fluffed up pieces of ember material one layer thick
will produce the best ember glow. Do not place more
than one layer of ember material onto the burner. Excess ember material will decrease the ember
glow effect.
b. Save any remaining ember material for future applications (as needed).
Log Set Installation
The positioning of the logs is critical to the safe and clean
operation of this fireplace. Sooting and other problems may result
if the logs are not properly and firmly positioned in the fireplace.
Please refer to (Figure 1) and the following WARNING when
completing log placement instructions.
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
fireplace may result in property damage or personal injury.
Figure 2
Coal Information
1. Coals may be placed along the front burner as shown in
Figure 3. Coals may not be placed over burner ports.
Figure 3
Figure 1
Page 4
38800-0-0218
LOG AND EMBER PLACEMENT
1.
Place the large charred Ember Bed A onto burner base between the front and rear burner tubes.
TOP VIEW
FRONT VIEW
38800-0218
Page 5
LOG PLACEMENT
2.
Place Log B on the Ember Bed A onto pins 3 and 5.
TOP VIEW
FRONT VIEW
Page 6
38800-0-0218
LOG PLACEMENT
3.
Place Log C on the Ember Bed A onto pin 6.
TOP VIEW
FRONT VIEW
38800-0218
Page 7
LOG PLACEMENT
4.
Place Log D onto the burner base and air shutter box located on the front far right.
TOP VIEW
FRONT VIEW
Page 8
38800-0-0218
LOG PLACEMENT
5.
Place Log E onto burner base located on the rear far right.
TOP VIEW
FRONT VIEW
38800-0218
Page 9
LOG PLACEMENT
6.
Place Log F onto Log E pin.
TOP VIEW
FRONT VIEW
Page 10
38800-0-0218
LOG PLACEMENT
7.
Place Log G onto burner base pins 1 and 2 located behind the rear burner tube.
TOP VIEW
FRONT VIEW
38800-0218
Page 11
DECORATIVE ROCK PLACEMENT
8.
Place Decorative Rocks across the burner base in front of the burner tube. DO NOT cover the burner ports.
TOP VIEW
FRONT VIEW
Page 12
38800-0-0218
GLOWING EMBER PLACEMENT
9.
Place Glowing Embers on the burner tubes covering all ports. You may add additional Embers on Ember Bed for extra glow. You
may press some Embers onto the front side of Log G to help create glow when the fire is burning.
TOP VIEW
FRONT VIEW
38800-0218
Page 13
LOG PLACEMENT
10. Place Log H onto Ember Bed A pins 1 and 2 located on the left.
TOP VIEW
FRONT VIEW
Page 14
38800-0-0218
LOG PLACEMENT
11. Place Log I onto Log E pin.
TOP VIEW
FRONT VIEW
38800-0218
Page 15
LOG PLACEMENT
12. Place Log J onto Log H pin. Log H has 2 pins. Use the rear pin.
TOP VIEW
FRONT VIEW
Page 16
38800-0-0218
LOG PLACEMENT
13. Place Log K onto Log D pin.
TOP VIEW
FRONT VIEW
38800-0218
Page 17
LOG PLACEMENT
14. Place Log L on the Ember Bed A onto pin 4.
TOP VIEW
FRONT VIEW
Page 18
38800-0-0218
LOG PLACEMENT
15. Place Log M into gap of Log H and front burner located on the front left.
TOP VIEW
FRONT VIEW
38800-0218
Page 19
LOG PLACEMENT
16. Place Log N onto Log H pin. Log H has 2 pins. Use the front pin.
TOP VIEW
FRONT VIEW
Page 20
38800-0-0218
ADDITIONAL ROCK & EMBER PLACEMENT
17. Place additional Decorative Rocks and Embers in any empty areas around the burner as desired. DO NOT cover burner ports.
The log set is complete.
TOP VIEW
FRONT VIEW
38800-0218
Page 21
MASTER PARTS DISTRIBUTOR LIST
To Order Parts Under Warranty, please contact your local Empire dealer. See the dealer locator at www.empirecomfort.
com. To provide warranty service, your dealer will need your name and address, purchase date and serial number, and the
nature of the problem with the unit.
To Order Parts After the Warranty Period, please contact your dealer or one of the Master Parts Distributors listed below.
This list changes from time to time. For the current list, please click on the Master Parts button at www.empirecomfort.com.
Please note: Master Parts Distributors are independent businesses that stock the most commonly ordered Original
Equipment repair parts for Heaters, Grills, and Fireplaces manufactured by Empire Comfort Systems Inc.
Dey Distributing
1401 Willow Lake Boulevard
Vadnais Heights, MN 55101
F. W. Webb Company
200 Locust Street
Hartford, CT 06114
Phone: 651-490-9191
Toll Free: 800-397-1339
Website: www.deydistributing.com
Parts: Heater, Hearth and Grills
Phone: 860-722-2433
Toll Free: 800-243-9360
Fax: 860-293-0479
Toll Free Fax: 800-274-2004
Websites: www.fwwebb.com & www.victormfg.com
Parts: Heater, Hearth and Grills
East Coast Energy Products
10 East Route 36
West Long Branch, NJ 07764
Phone: 732-870-8809
Toll Free: 800-755-8809
Fax: 732-870-8811
Website: www.eastcoastenergy.com
Parts: Heater, Hearth and Grills
HOW TO ORDER REPAIR PARTS
Parts Not Under Warranty
Parts can be ordered through your Service Person, Dealer, or a Master Parts Distributor. See this page for the Master Parts Distributors list. For best results, the service person or dealer should order parts through the distributor. Parts can be shipped directly to the
service person/dealer.
Warranty Parts
Warranty parts will need a proof of purchase and can be ordered by your Service Person or Dealer. Proof of purchase is required for
warranty parts.
All parts listed in the Parts List have a Part Number. When ordering parts, first obtain the Model Number and Serial Number from the
name plate on your equipment. Then determine the Part Number (not the Index Number) and the Description of each part from the
following illustration and part list. Be sure to give all this information . . .
Appliance Model Number
Part Description
Appliance Serial Number
Part Number
Type of Gas (Propane or Natural)
Do not order bolts, screws, washers or nuts. They are standard hardware items and can be purchased at any local hardware store.
Shipments contingent upon strikes, fires and all causes beyond our control.
Page 22
38800-0-0218
APPLIANCE SERVICE HISTORY
Date
38800-0218
Dealer Name
Service Technician Name
Service Performed/Notes
Page 23
Empire Comfort Systems Inc.
Belleville, IL
If you have a general question
about our products, please e-mail
us at info@empirecomfort.com.
If you have a service or repair
question, please contact your dealer.
www.empirecomfort.com
Page 24
38800-0-0218
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising