ESAB | Analogue remote retrofit kit | Assembly Instruction | ESAB Analogue remote retrofit kit User manual

ESAB Analogue remote retrofit kit User manual
Analogue remote retrofit kit
0445 840 880
Renegade™
For contact information visit esab.com
http://manuals.esab.com
Assembly instruction
0463 608 001 GB 20180413
8
1
1
7
Software update after installation of the analogue remote kit
1. Copy the correct secondary boot upgrade file (version 2.3 or later)
to a USB flash drive.
2. Rename the file sparc.fcf.
3. Disconnect any digital remote control or foot pedal from the
welding power source that is going to be upgraded.
4. Insert the USB flash drive into the power source USB connector.
5. Wait until the boot upgrade process is completed.
2
6. Power off the welding power source and wait for at least 1 minute.
7. Copy the correct system software upgrade file
(version 1.13.x or later) to an empty USB flash drive.
8. Insert the USB flash drive into the power source USB connector.
9. Wait until the system software upgrade is completed.
For additional guidelines, such as location of software files,
see “SOFTWARE UPDATE AND CONFIGURATION”
in the service manual.
Verify the installation of the remote functionality by connecting
an analogue remote to the power source and control that the
remote and power source display are synchronized.
2
7
CN11
CN6
CN7
CN2
CN1
CN 29
6
3
3 Nm /
26.6 in. lb
6
3
5
4
4
5
CN 6
CN 29
CN 1
CN 7
CN 2
CN 11
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising