• • • Low profile bracket Driver CD Installation guide
Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer case for a few seconds. Avoid any contact with internal parts and handle cards only by their external edges.
For slim desktop PCs, replace the pre installed bracket by the included low profile bracket.
Turn OFF the power to your computer and any other connected peripheral devices.
Unplug the power cord from the computer.
Remove your computer cover.
Remove the slot bracket from an available PCIe slot.
Carefully align the card's bus connector with the selected PCI Express slot on the motherboard. Push the card down firmly, but gently, until it is well seated.
Replace the slot bracket holding screw to secure the card.
Replace the computer cover and reconnect the power cord.
Windows Driver Installation
Windows 10 and 8.x have built-in driver support for this adapter. Just install the board and Windows will automatically detect and install the correct drivers for it. No additional driver is needed.
For earlier versions, follow below instructions to install the driver: 1.
After Hardware Installation, start the computer and insert the driver CD.
The AutoPlay window will show automatically, and select
. If not, browse the CD manually.
At "Intel(R) Network Connections" window, select
Install Drivers and Software
, then follow on-screen steps to install the driver.
When "Install wizard Completed" message shows, click
Restart the computer and it's ready for use now.
To Verify Installation
on the desktop, click
, then click
, and below should be displayed.
* 2-port: * 4-port:
For more details, please go to the Support section at www.siig.com.
* Your assessment is very important for improving the work
of artificial intelligence, which forms the content of this project