ICP DAS USA | PET-7019Z/S2 | Quick start manual | ICP DAS USA PET-7019Z/S2 Quick Start Manual

ICP DAS USA PET-7019Z/S2 Quick Start Manual
PET-7000/ET-7000
Quick Start
V1.4, March 2018
Supported Products
 ET-7000 Series
 PET-7000 Series
 ET-7000-UT Series
Technical Support
PET-7000 / ET-7000 User Manual
http://ftp.icpdas.com/pub/cd/6000cd/napdos/et7000_et7200/document/
What’s in the Box?
PET-7000/ET-7000 Module
1
Plastic Rail
Quick Start
Factory Default Settings
Network
Connection
Default
Authentication
Default
IP Address:
192.168.255.1
User name:
Admin
Subnet Mask:
255.255.0.0
Password:
Admin
Gateway:
192.168.0.1
Technical Support: service@icpdas.com
P1
2
Connecting to Network, Computer and Power
Non-PoE
Switch
Power Supply
+10 ~ 30 VDC for ET-7000
+12 ~ 48 VDC for PET-7000
PoE
PoE Switch
+12 ~ 48 VDC Power Supply
3-1
Assigning a Valid IP Address - Method 1
1) Install eSearch from
http://ftp.icpdas.com/pub/cd/6000cd/napdos/software/esearch/
2) Launch eSearch and click “Search Server”
Technical Support: service@icpdas.com
P2
3) Double-click the name for your module on the list
4) Enter the network configuration and click “OK”
5) Repeat Step 2. to search the module again
To make sure your modifications take effect.
3-2
Assigning a Valid IP Address - Method 2
1) Set the IP configuration on your computer
The ET-7000 module comes with the default IP address of
192.168.255.1, you must chose an IP address for the computer in
the range of 192.168.255.2 – 192.168.255.253 that is not in use.
2) Launch your web browser to go to the ET-7000 web interface
Enter the factory default IP address 192.168.255.1 for the
ET-7000 as the URL in browser and press Enter.
Technical Support: service@icpdas.com
P3
3) Fill out the User name and Password
Fill out the factory default user name and password “Admin” and
then click “OK”.
4) Assign a valid IP address for your ET-7000 module
1. Click “Configuration”
2. Click “Network Settings” in the sub-menu
3. Enter a valid IP address for your ET-7000 module.
4. Click the “SUBMIT” button.




5) Restore the original IP address to your computer
4
Logging in to the ET-7000 Module
1) Enter the new IP for the ET-7000 as the URL in browser
2) Fill out the User name and Password “Admin” again
3) Welcome to ET-7000 web site
Technical Support: service@icpdas.com
P4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising