Kicker | Tabor2 Headphones | Owner Manual | Kicker Tabor2 Headphones Owner Manual

Kicker Tabor2 Headphones Owner Manual
TABOR2 BLUETOOTH HEADPHONES
TABOR2 BLUETOOTH AURICULARES
BLUETOOTH ÉCOUTEURS TABOR2
QUICK-START GUIDE | INICIO RÁPIDO | DÉMARRAGE RAPIDE
Connections | Conexiones | Connexions
IMPORTANT: Fully charge
before first use.
IMPORTANTE: Cargue
completamente antes de
usarlo por primera vez.
IMPORTANT : Chargez
entièrement avant la
première utilisation.
USB Micro
AUX
Controls | Controles | Contrôles
=
:01 Voice Assistant
de Voz
= Asistente
Assistant Vocal
:03 Power
= Encendido
Puissance
:07 Pair
= Emparejar
Coupler
WARNING!
Keep out of reach of children. The content of this package includes small parts and cords that can cause
choking or strangulation.
WARRANTY
KICKER products are warranted against defects. Duration and terms of warranty depend on the laws in the
country in which it was purchased. For details see your local KICKER Dealer or
www.kicker.com/warranty.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You
are entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
Los productos KICKER se encuentran cubiertos contra defectos. La duración y los términos de la garantía
dependen de las leyes del país donde fueron adquiridos. Para más información, consulte a su distribuidor
local de KICKER o visite www.kicker.com/warranty.
Les produits KICKER sont garantis contre les défauts. La durée et les termes de la garantie dépendent
des lois en vigueur dans le pays où l’achat a été effectué. Pour plus d’informations, veuillez contacter votre
vendeur KICKER local ou vous rendre sur :
www.kicker.com/warranty.
FCC STATEMENT
FCC ID: RGR-HP4BTB
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation
between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
IC STATEMENT
IC: 11078A-HP4BTB
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’ appareil ne doit pas produire de brouillage;
(2) L’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’ en
compromettre le fonctionnement.
stillwaterdesigns
Tabor2-20190506-C
C22.2 No.60065
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising