Ideal | WingTwist® Wire Connector, Model WT41 Tan | Instructions | Ideal WingTwist® Wire Connector, Model WT52 Red instructions

Ideal WingTwist® Wire Connector, Model WT52 Red instructions
WingTwist Wire Connector Instructions
WARNING:
Improper use or installation of this product may cause fire, electrocution, serious personal injury or death. Shut off power to the
circuit or remove fuse before using this product. Use only connectors properly sized to the wires being used. Consult local building
codes for installation requirements.
To be sold only with installation instructions.
Installation Instructions
1. Turn off power before removing or installing connectors.
2. Strip connectors to the correct strip length per the chart below:
Connector
WT51
WT41
WT52
WT54
3.
4.
5.
6.
Strip length
Strip wires 3/8”
Strip wires 1/2”
Strip wires 1/2”
Strip wires 5/8”
(9.5mm)
(13mm)
(13mm)
(16mm)
Straighten and align frayed strands.
Hold wires together with ends even. Lead stranded wires slightly ahead of solid wires.
Pre-twisting acceptable, but not required. For pre-twisting; strip wires long, hold wires together with insulation even, twist
wire ends together, trim to recommended strip length.
Insert bundle into connector and twist clockwise until tight.
Use only on Copper to Copper (Cu/Cu) wire combinations.
For use in dry locations only.
Temperature rating: 105◦C (221◦F) maximum.
600 volts maximum building wire; 1000 volts signs or lighting fixtures.
UL 486C Listed and CSA C22.2 #188 Certified
Complies with Federal Specification W-S-61D
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising