Technika | SL20260ISS-3 | Instruction manual | Technika SL20260ISS-3 Rangehood Instruction Manual

Technika SL20260ISS-3 Rangehood Instruction Manual
SL20260ISS-3
TELESCOPIC HOOD
USER’S MANUAL
For original parts & reliable service:
TECHNIKA
1800 333 244
使用指示
安
装
和
INSTRUCTIONS FOR INSTALLATION
AND USE
Schematic Diagram
Table of Contents
2
•
From the Manufacturer
3
•
Specifications
3
•
SAFETY : Read this first !
4
•
Vent System Requirements
5
•
Ducted vs. Re-circulating
6, 7
•
Description of Parts
8
•
Instruction for Use
9
•
Technical Information
10
•
Installation
11
•
Cleaning & Maintenance
12, 13
•
Troubleshooting
14
•
Schematic Diagram
15
15
Troubleshooting
Symptoms
From the Manufacturer
Possible Cause
Action
•
This appliance and it’s packaging are produced by processes that
minimize waste and respect the environment.
Check that the plug is
connected.
Does not function
•
No electrical supply
Please help us to continue the protection of the environment by
disposing of the packaging in a correct manner.
Check that the main switch
is turned on.
Aluminium filters grease
clogged
Clean the filters and replace
when it is dry
Charcoal grease filters
clogged
Replace charcoal filters with
new sets
Butterfly valve jammed
Contact technician
High temperature safety
device activated
The kitchen is not sufficiently
ventilated
The hood is installed too
near the cooking stove
The hood must be at least
65cm from stove
Charcoal filters not installed
In re-circulating mode,
charcoal filters must be
installed
•
Safety!
•
Please do not allow young children to play with the plastic bag
Poor airflow
Motor running but no
airflow
packaging.
Motor cuts after a few
minutes
Strong cooking smell
Aluminium grease filter
saturated
Wash the aluminium grease
filters
Aluminium grease filter
saturated
Wash the aluminium grease
filters
Foreign object in contact with
fan blade
Contact technician
•
Before disposing of any old appliances, be sure to cut off the power
chord so that others will not be endangered by a defective electric
appliance.
Specifications
Input
:
220-240V 50Hz
Absorption
:
2 x 85W
Lamps
:
2 x 40W
External Dimensions
•
60cm version
:
600x280x180mm
•
90cm version
:
900x280x180mm
Oil dripping onto stove
Whirring sound
14
3
SAFETY : Read this First !
Cleaning & Maintenance (continued)
•
Do not connect the appliance if there are obvious signs of transportation
Activated charcoal filter
damage.
To install the charcoal filter, the motor anchorage is made to coincide with the
•
Read this user manual thoroughly before attempting to use this appliance.
anchor points of the activated charcoal filter, inserting and locking into place.
•
Installation and repair should be attempted only by qualified technical personnel.
The carbon filter lasts from three to six months depending on the particular
•
It is dangerous to modify any part of this appliance.
conditions of use.
•
The manufacturer declines all responsibility in case of failure to adopt proper
•
safety measures.
The activated carbon filter can neither be exhausted, it must be changed.
Ensure the location in which this appliance is installed has good, permanent
Once it is exhausted, it must be changed.
ventilation.
•
The distance between the bench top to the lower part of the hood must not be at
Changing Bulbs
less than 65 cm or higher than 75 cm.
Remove the filter support to access the bulbs.
•
Use an electrical connector with earth that is correct for your location.
Take care to disconnect the mains beforehand and that the bulbs to be
•
Check that the voltage in your area is correct before plugging in.
replaces are not hot.
•
The electrical connection of this appliance must be connected to earth.
The maximum bulbs power is 40W.
•
Green & yellow
=
EARTH
Blue
=
NEUTRAL
Brown
=
LIVE
Multiple plugs and extension cables must not be used. Overload is dangerous
and may cause a fire.
•
Ensure that the power supply chord is free from any heat source or sharp
objects.
•
The appliance should be switched off and the electrical supply disconnected
before any cleaning or maintenance work can be carried out.
•
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
4
13
Cleaning & Maintenance
SAFETY : Read this First !
Before carrying out any cleaning or maintenance activities, ensure that the
•
appliances is disconnected from the mains and follow the safety Instructions.
(Continued)
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
•
There shall be adequate ventilation of the room when the range hood is used at
Filter Cleaning
the same time as appliances burning gas or other fuels (not applicable to
To withdraw the filters from their locations release the anchoring points. Clean
appliances that only discharge the air back into he room);
the filter either putting in the dishwasher (refer to notes) or leaving it standing
Clause 7 (60335-2-31)
in hot water to simplify the removal of grease or, if wished, by means of
There is a fire risk if cleaning is not carried out in according with the instructions.
special sprays (protecting the non metallic parts). Once clean, leave it to dry.
The hood use four hob element at most.
Notes: cleaning in the dishwasher with aggressive detergents may blacken
•
Do not flambé under the range hood。
•
The appliance use 4 hob element at most.
the surface of metallic parts, without this affecting its gas retaining properties.
The filter must be cleaned at least once a month depending on how often the
Vent System Requirements
appliances is used. It must be remembered that grease is deposited in the
Determine which venting method is best for your application. Vented (non-
extractor when cooking, whether it is switched on or not.
recirculating) system must be terminate to the outside. Ductwork can extend either
through the wall or the roof. Do not terminate the vent system in an attic or other
Cleaning the appliances body
enclosed area.
The use of (40ºC approx.) soapy water is recommended. A cloth moistened in
this water is used for cleaning the extractor, paying special attention to the
grids and dry it using a lint-free cloth.
The length of the ductwork and the number of elbows should be kept to a minimum to
provide efficient performance. The size of the ductwork should be uniform. Do not
install two elbows together. Use duct tape to seal all joints in the ductwork system. Use
caulking to seal exterior wall or floor opening around the cap.
Note: avoid using abrasive detergents, scourers, acidic cleaners such as lime
scale remover etc. as these could damage the surface and can result in the
Flexible ductwork is not recommended. Flexible ductwork creates back pressure
development of rust and corrosion.
and air turbulence that greatly reduces performance.
Do not use scrapers with metallic surfaces such as knives, scissors etc.
Make sure there is proper clearance within the wall or floor for exhaust duct before
making cutouts. Do not cut a joist or stud unless absolutely necessary. If a joist or stud
must be cut, then a supporting frame must be constructed.
12
5
Ducted vs. Re-circulating
Installation
Your cooker hood can be configured to operate in the ducted or re-circulating
To fix the extractor to the kitchen unit.
mode :-
The lower part of the extractor must be located at a minimum height of 60cm
above the hob for electric cookers and 65cm for gas cookers. If the
A. DUCTED MODE (VENTED MODE)
instructions of a gas cooker indicate a greater distance these must be
•
observed.
In the ducted mode, cooking fumes are vented outdoors through suitable
connection of 125mm diameter. In this mode, only the aluminum filters
are installed.
When the extractor is working at the same time as other non-electrical
cooking equipment, the outlet air pressure must not exceed 4 Pa.
To achieve optimum performance the length of the outlet hose should not
exceed 4 meters, or include more than two 90 angles (elbows)
Although venting to the outside is recommended, activated carbon filters may
be used, which allow the gas to be returned to the kitchen through the outlet
pipe.
The fix
space of appliance at
least:
560*282, as the drawing
of below:
6
The
appliance be fixed by
screw, as
the drawing of below:
11
Instructions for Installation
Ducted vs. Re-circulating (continued)
B. RE-CIRCULATING MODE
Install Range Hoods in accordance with the manufacturer’s instructions.
Technika recommends that all Range Hood clearances be a minimum of
650mm to a maximum of 750mm (between the top of the cooking surface
and to the underside of the rangehood).
Distance may be reduced to 600mm to align with the AGA code.
10
•
Fumes are filtered for grease and odors through the aluminum grease
filters and the charcoal filters respectively and re-introduced into the
kitchen environment. In re-circulating mode, both the aluminum grease
filters and the charcoal filters must be installed.
7
Instructions for Use
Description of Parts
Extractable
Group
By pressing the button shown in the below, you will be able to control the
functions of the extractor.
Light
Switch
Motor
Control
Filters
Lamps
Charcoal
Filter
Light
Speed
ON
Low
Off
Off
Automatic
High
To achieve better extraction, we recommend switching on the extractor a few
minutes before starting to cook (3—5 minutes) so that the air flow is
continuous and stable when extracting fumes.
Likewise, keep the extractor switched on for a few minutes when cooking is
complete to allow all fumes and odors to be expelled.
8
9
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE.
The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or
improper use of the appliance.
The manufacturer is not responsible for any inaccuracies, due to printing or transcription errors, contained in this
handout. In addition, the appearance of the figures reported is also purely indicative.
The manufacturer reserves the right to make changes to its products when considered necessary and useful, without
affecting the essential safety and operating characteristics.
Technika constantly seeks ways to improve the specifications and designs of their products.
Whilst every effort is made to produce up to date literature, this document should not be regarded as an infallible guide.
Actual product only should be used to derive cut out sizes.
All Technika Appliances must be installed by a qualified person/s with adherence to the relevant electrical, plumbing and
AGA codes, with compliance being issued as required by state or national legislation.
Additionally all Technika Upright cookers must have chains installed correctly in adherence to the relevant AGA, and
plumbing codes by the Licenced installer.
For maximum effectiveness and efficiency all rangehoods should be installed with the use of ductwork, by a licenced
installer with adherence to the relevant state and national building codes and regulations.
All Technika appliances are for Domestic use only, and must be installed by a licence installer into Domestic Applications
only, without exception and to the required Authorities guidelines. Any installation outside of this will VOID warranty.
Alfresco areas are not a Domestic application.
TECHNIKA
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising