Technika | TAR1200S | Instruction manual | Technika TAR1200S Rangehood Instruction Manual

Technika TAR1200S Rangehood Instruction Manual
Instructions for Use and Installation
Alfresco Rangehood
TAR1200S
Contents
For Your Safety
Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Before Connecting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Use and Care
Use and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Cleaning your Rangehood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Installation
Electrical Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Instructions for Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
3
For Your Safety
Carefully read the following important information regarding
installation safety and maintenance. Keep this information booklet
accessible for future reference.
The appliance has been designed for use in a Ducted installation,
see diagram below:
Safety Precautions
Take care when the Range Hood is operating simultaneously with
an open fireplace or burner that depend on natural ventilation as
the Range Hood removes air from the room, which a burner or
fireplace may need for combustion.
Provide adequate ventilation for safe operation of the Range
Hood. Follow any local laws that apply to external air evacuation.
Before connecting to the electricity network:
Look at the data plate (located inside the appliance) to ascertain
that the voltage and power correspond to the available power
supply and the power outlet is suitable. If in doubt ask a qualified
electrician.
If the appliance is used intensively for a long period of time, you
may need to opening a window to improve airflow.
4
For Your Safety
WARNINGS!
· Do not check the status of the filters while the Range Hood
is operating.
· Do not touch bulbs or adjacent areas, during or straight
after use.
· CAUTION: Accessible parts may become hot when used
with cooking appliances.
· Do not flambé under the Range Hood.
· Avoid free flame, as it is damaging to the filters and can
cause fire hazard.
· Constantly check food frying, overheated oil may become a
fire hazard.
· Disconnect the electrical plug prior to any maintenance.
· This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
· Children should be supervised to ensure that they do not
play with the appliance.
· There shall be adequate ventilation in the room when the
Range Hood is used at the same time as appliances
burning gas or other fuels.
· There is a fire risk if cleaning is not carried out in
accordance with the instructions.
· WARNING: DO NOT penetrate any screws into the range
hood as this may result in electrical hazards.
· WARNING: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical
hazards.
5
For Your Safety
WARNINGS!
· If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
· The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other
fuels.
· The minimum distance between the cooktop hob and the
lowest part of the range hood shall be at least 120cm. If the
instructions for installation of the gas hob specify a
greater distance, this has to be taken into account.
· Regulation concerning the discharge of air has to be
fulfilled.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
DAMAGES CAUSED BY BREACHING THE ABOVE WARNINGS.
6
Use and Care
It is recommended to start the Range Hood prior to commencing to
cook and leave the Range Hood in operation for 15 minutes after
cooking is finished in order to completely eliminate cooking vapours
and odours.
To ensure the Range Hood continues to operate effectively, regular
maintenance and cleaning is required. Clean the fan and other
surfaces of the Range Hood regularly using a cloth moistened with
warm water or non abrasive liquid detergent.
Lights
LED lamps are a spare part and are not repairable. However LED
lamps can be easily removed and replacements installed, note plug
and socket connection. Please contact Technika spare parts
department for replacements.
Controls
The control panel has five functions as shown below.
Low
Mid
High
Light
Timer
Power on: After you have connected the cooker hood to the mains
supply the backlight will turn on. The backlight will turn off after 5
seconds without any operation and hood will enter stand-by mode.
Push the low button, indicated by a fan with 3 blades, and the motor
will run at a low speed. An indicator light will also illuminate. Push it
again and the motor will stop.
Push the medium button, indicated by a fan with 4 blades and the
motor will run at a medium speed. An indicator light will also
illuminate. Push it again and the motor will stop.
Push the high button, indicated by a fan with 5 blades and the
motor will run at a high speed. An indicator light will also illuminate.
Push it again and the motor will stop.
Press the Light button once; lights will come on. Press the button
again and the lights will turn off.
Whilst the cooker hood is in use, if you press the timer button once
the hood will run for 5 minutes and then cut off.
7
Use and Care
Cleaning your rangehood
The proper function of the rangehood requires regular
maintenance operations.
The anti-grease filters capture the grease particles suspended in
the air, and are therefore subject to clogging according to the
frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the
filter at a minimum of every 2 months by carrying out the following
instructions:
- Remove the filters from the cooker hood and wash them in a
solution of water and neutral liquid detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This
is not cause for customer complaint nor replacement of panels.
Clean the fan and other surfaces of the cooker hood regularly
using a cloth moistened with denatured alcohol or non abrasive
liquid detergent.
Keep motor and other parts free from water as this will cause
damage to the appliance.
Stainless steel care
Stainless steel gets its protective coating from the chromium
oxidizing in the air to form a protective surface of chromium oxide.
This can be attacked by different substances, such as salt water
or sea air. The stainless steel will start to show pit marks which
are referred to in the industry as tea staining. This will happen to
marine grade stainless steel type 316 in the same way it will
happen to stainless steel type 304, it will just take longer to occur.
The way to overcome this is to clean the stainless steel with warm
soapy water and then polish it with a cloth so that the chromium
will oxidize again.
When exposed to sea water or sea side conditions this is only a
stop gap measure as the attack will start again.With stainless
steel rangehoods exposed in Alfresco areas we recommend
spraying the hood with vegetable oil and rubbing it all over the
rangehood, if it is going to be unused over a period of time.
8
Use and Care
Troubleshooting
No electricity supply
Check that the main switch/circuit
breaker/safety switch is turned on
Contact service department
Motor turns off after
a few minutes
Refer to installation instructions for
correct clearances
Contact service department
Disposal
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The symbol on the product indicates that this product may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city council
office.
9
Installation
Assembly and electrical connections must be carried out by
authorised personnel.
Electrical Connection
The Range Hood is fitted with a power cord and 3 pin plug. Install
the Range Hood so that the plug is easily accessible. Plug the 3pin plug into a properly earthed, 10A general purpose power
outlet.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
The appliance has been manufactured as a class I, therefore
earth cable is necessary.
The connection to the mains is carried out as follow:
IEC227
North America
L = Live
Brown
Black
N = Neutral
Blue
White
E = Earth
Green/Yellow
Green
If not provided, connect a plug for the electrical load indicated on
the description label. Where a plug is provided, the cooker hood
must be installed so that the plug is easily accessible after
installation.
An omnipolar switch with a minimum aperture of 3mm between
contacts, in line with the electrical load and local standards, must
be placed between the appliance and the network in the case of
direct connection to the electrical network.
10
Installation
Instructions for Installation
To be installed in an undercover alfresco area and/or indoor
kitchen only. If the unit is not adequately covered or sheltered from
the outside elements the warranty will be null and void.
Ensure that the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure
that it is structurally sound and will support the weight of the
appliance.
Install Range Hoods in accordance with the manufacturer's
instructions. A minimum clearance of 1200mm is required from the
top of the cooking surface to the underside of the rangehood.
1. Refer to the notes and required clearances above.
2. After deciding the installation height of the hood, drill 6 holes
according to figure 1. Please note: The top holes are for the flue
cover bracket. The bracket determines the height of the flue cover.
3a. For Masonry walls, install appropriate plugs into the 2 bracket
holes and 2 safety holes (top and bottom) and appropriate
masonry anchors into the 2 key holes (middle holes). Fix the flue
cover bracket onto the wall with 2 screws. See figure 2.
3b. For Timber walls, install appropriate screws into the 2 key
holes (middle holes). Fix the flue cover bracket onto the wall with 2
screws. See figure 2.
Fig. 1
Fig. 2
11
Installation
Instructions for Installation (cont.)
4. Remove the 8 filters. See figure 3.
5. Hang the hood on the two Masonry anchors / Screws and make
sure rangehood is level. See figure 4.
Fig. 3
Fig. 4
6. Install 2 screws through the back of the hood. See figure 5.
7. Install flue/ductwork and make sure it is pulled taut with no
creases to maximise airflow. See figure 6.
Fig. 6
12
Installation
Instructions for Installation (cont.)
8. Slide the inner flue cover into the outer flue cover. Take them
together and put them on the top of the hood. See figure 7.
9. Slide the inner flue cover upwards, then connect the inner flue
cover to the bracket with 2 ST 4 x 8 screws. See figure 8.
Fig. 7
Fig. 8
WARNING: DO NOT penetrate any screws into the range hood
as this may result in electrical hazards.
WARNING: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical
hazards.
If a connection flue/ductwork composed of two parts is used, the
upper part must be placed outside the lower part.
Exhaust air must not be discharged into a flue/ductwork which is
used for exhausting fumes from appliances burning gas or other
fuels. Installation must comply with any local regulations
concerning the discharge of exhaust air.
Before proceeding with the assembly, remove the anti-grease filter
so that the unit is easier to handle. Prepare the hole in the ceiling
or wall for the evacuation of the air.
13
Installation
Dimensions
14
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE
APPLIANCE.
The manufacturer will not be responsible for any damage to property or to persons
caused by incorrect installation or improper use of the appliance.
The manufacturer is not responsible for any inaccuracies, due to printing or
transcription errors, contained in this handout. In addition, the appearance of the
figures reported is also purely indicative.
The manufacturer reserves the right to make changes to its products when
considered necessary and useful, without affecting the essential safety and
operating characteristics.
Technika constantly seeks ways to improve the specifications and designs of their
products.
Whilst every effort is made to produce up to date literature, this document should
not be regarded as an infallible guide.
Actual product only should be used to derive cut out sizes.
All Technika Appliances must be installed by a qualified person/s with adherence
to the relevant electrical, plumbing and gas codes, with compliance being issued
as required by state or national legislation.
Additionally all Technika Upright cookers must have chains installed correctly in
adherence to the relevant gas and plumbing codes by a Licenced installer.
For maximum effectiveness and efficiency all rangehoods should be installed with
the use of ductwork, by a licenced installer with adherence to the relevant state
and national building codes and regulations.
All Technika appliances are for Domestic use only, and must be installed by a
licenced installer into Domestic Applications only, without exception and to the
required Authorities guidelines. Any installation outside of this will VOID warranty.
TOMORROWS TECHNOLOGY TODAY
TECHNIKA PTY LTD ACN 069 686 326
77 FILLO DRIVE SOMERTON VIC 3062
General : 1800 649 969 - Service : 1800 333 244
Technika After Sales Service - P.O. Box 543 SOMERTON VIC 3061
Version 1 Revision 20170509
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising