Ryobi | RY141612 | Owner Manual | RYOBI RY141612 Owner Manual

RYOBI RY141612 Owner Manual
RY141612/RY141612VN/RY141612VNM QUICK REFERENCE GUIDE
There may be residual water
in the pump due to performance testing.
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY
1
Connect the spray wand to the trigger handle
(see page 9).
3
Connect the high pressure hose to the pump
(see page 9).
STARTING THE UNIT
1
USING DETERGENT
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 10).
1
Attach soap injection hose,
then place end of hose with
filter in the soap container
(see page 12).
2
Install blue or black soap
nozzle (see page 11).
3
Squeeze trigger and wait
­approx. 5 seconds for soap
(see page 12).
DETERGENT
5S
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 2 and 7).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
4
Connect the garden hose to the pump (see page 9).
Cord Length
Wire Size (A.W.G.)
25 ft.
14
50 ft.
12
100 ft.
Not Allowed
NOTE: A.W.G. = American Wire Gauge
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
2
Connect the high pressure hose to the trigger
handle (see page 9).
2
Press switch ON to start the motor (see page 10).
Concrete, Brick, Masonry
SWITCH
ON
Siding, Gutters, House
Fencing, Deck, Patio
Completely uncoil garden hose or remove
­completely from reel to prevent kinks.
Lawn Equipment, Boat, RV
Turn water faucet on fully.
(FOR SOAP OR
GENTLE RINSE)
Turbo Nozzle
15º
Blue or Black
Soap Nozzle









 Recommended Nozzle
 Use With Caution for Certain Applications
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until
a steady stream of water appears.
LOW
­ RESSURE
P
3
BEFORE STORING THE UNIT
When finished, press switch OFF to stop the motor (see page 10).
1
SWITCH
OFF
Always add Pump Protector to the unit after each use and before storing. This will significantly
­improve pump life. (See page 13)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
PUMP
PROTECTOR
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating
or maintaining your product please call, 1-800-860-4050.
995000188
2-19-19 (REV:05)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising