Ryobi | RY80588A | Owner Manual | RYOBI RY80588A Owner Manual

RYOBI RY80588A Owner Manual
RY80588A QUICK REFERENCE GUIDE
There may be residual water in the pump
and/or lubricant in the engine due to
performance testing.
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY
1
Install the wheels (see page 7).
7
STARTING THE UNIT (COLD START)
Connect your garden hose to the pressure washer
(see page 8).
1
4
Add fuel (see page 10).
Move choke lever to START position.
(see page 10).
USING DETERGENT
1
Pour pressure washer
­detergent in soap tank (see
page 12).
2
Install blue or black soap
nozzle (see page 11).
3
Squeeze trigger and wait
­approx. 5 seconds for
detergent (see page 12).
NOTICE:
Do not use E15 or E85 fuel in this product. It is a violation of federal law and will
damage the unit and void your warranty.
Only use unleaded gasoline containing
up to 10% ethanol.
2
DETERGEN
T
5S
CHOKE LEVER
(START)
Install the handle (see page 7).
5
Pull starter grip and rope to start (see page 10).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
Completely uncoil garden hose or remove
­completely from reel to prevent kinks.
3
Install the storage panel and trigger handle
holder (see page 7).
Turn water faucet on fully.
This is a 4-cycle engine. Do not mix fuel and
lubricant ­together.
Make sure there are no leaks.
Mix fuel stabilizer with gasoline according to
manufacturer’s directions prior to filling the
tank.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
8
4
Connect the spray wand to the trigger handle
(see page 7).
2
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
6
(NO SOAP WHEN USING THESE NOZZLES)
Pour all but 2 oz. of the provided lubricant into
the engine through the oil fill hole. Check and
add additional lubricant as needed until the level
reaches the upper portion of the hatched area on
the dipstick. Do not overfill. (See page 9).
Connect the high pressure hose to the trigger
handle (see page 8).
ABRASIVE
CHOKE LEVER
(RUN)
3
Fencing, Deck, Patio
RESTARTING THE UNIT
(HOT RESTART)
1
Connect the high pressure hose to the pump
(see page 8).
Lawn Equipment, Boat, RV
Set unit on flat surface so engine is level.
Remove dipstick, wipe clean, put back in hole
(but don’t screw in) and check lubricant level.
0º Red
25º Green
40º White
Blue or Black
Soap Nozzle













BEFORE STORING THE UNIT
1
Turn the fuel valve to OFF before adding
lubricant.
(FOR SOAP OR
GENTLE RINSE)
 Recommended Nozzle  Use With Caution for Certain Applications
Pull starter grip and rope to start (see page 10).
Always add Pump Protector to the unit after each use and before storing. This will significantly
improve pump life. (See page 13)
Pump Protector is available from your local retailer. For further assistance, call customer service
at 1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
PUMP
PROTECTOR
Make the most of your purchase! Go to www.ryobitools.com and
register your new tool online. For questions about operating or
maintaining your product, please call, 1-800-860-4050.
DO NOT OVERTILT THE UNIT!
Completely uncoil and straighten high pressure
hose to prevent kinks.
Concrete, Brick, Masonry
5S
Put on/off switch in ON position (see page 10).
LOW
­ RESSURE
P
GENTLE
Siding, Gutters, House
ON/OFF
SWITCH (ON)
6
HIGH PRESSURE
Move the fuel valve to OPEN (see page 10).
FUEL VALVE
(OPEN)
5
Allow engine to run for several seconds, then move
choke lever to RUN position (see page 10).
If the engine does not start:
• check for enough fuel;
• may need to adjust choke position;
• try starting again.
995000786
1-23-19 (REV:01)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising