Ryobi | RY803300H | Owner Manual | RYOBI RY803300H Owner Manual

RYOBI RY803300H Owner Manual
RY803300H QUICK REFERENCE GUIDE
There may be residual water in the
pump and/or lubricant in the engine
due to performance testing.
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY
1
Install the wheels (see page 7).
6
Connect your garden hose to the pressure washer
(see page 8).
STARTING THE UNIT (COLD START)
1
Add fuel (see page 10).
4
Pull starter grip and rope to start (see page 10).
USING DETERGENT
1
NOTICE:
Attach soap injection hose,
then place end of hose with
filter in the soap container
(see page 12).
2
Install nozzle and rotate
selector to blue
or blue
setting (see page 12).
3
Squeeze trigger and wait
­approx. 5 seconds for soap
(see page 12).
Do not use E15 or E85 fuel in this product. It is a violation of federal law and will
damage the unit and void your warranty.
Only use unleaded gasoline containing
up to 10% ethanol.
5S
2
Install the handle (see page 7).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
Completely uncoil garden hose or remove
­completely from reel to prevent kinks.
• Will void your warranty
• Will damage plants/shrubs
Turn water faucet on fully.
5
Make sure there are no leaks.
3
Connect the spray wand to the trigger handle (see
page 7).
4
This is a 4-cycle engine. Do not mix fuel and
lubricant ­together.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
7
Pour all but 2 oz. of the provided lubricant into
the engine through the oil fill hole. Check and
add additional lubricant as needed until the level
reaches the upper portion of the hatched area on
the dipstick. Do not overfill. (See page 9).
Allow engine to run for several seconds, then move
choke to RUN position (see page 10).
CHOKE LEVER
OFF (RUN)
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
Mix fuel stabilizer with gasoline according to
manufacturer’s directions prior to filling the
tank.
2
Put on/off switch in ON position (see page 10).
ON/OFF
SWITCH ON
Connect the high pressure hose to the trigger
handle (see page 8).
5S
ABRASIVE
5
RESTARTING THE UNIT
(HOT RESTART)
1
Pull starter grip and rope to start (see page 10).
LOW ­PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
(FOR SOAP OR
GENTLE RINSE)
0º
25º
40º









Long Range Short Range
GENTLE
Concrete, Brick, Masonry
Connect the high pressure hose to the pump
(see page 8).
HIGH PRESSURE
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV








 Recommended Nozzle  Use With Caution for Certain Applications
3
Completely uncoil and straighten high pressure
hose to prevent kinks.
BEFORE STORING THE UNIT
Move the choke lever to the START position
(see page 10).
CHOKE LEVER
ON (START)
1
Set unit on flat surface so engine is level.
Remove dipstick, wipe clean, put back in hole
(but don’t screw in) and check lubricant level.
Always add Pump Protector to the unit after each use and before storing. This will significantly
improve pump life. (See page 13)
Pump Protector is available from your local retailer. For further assistance, call customer service
at 1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
PUMP
PROTECTOR
Make the most of your purchase! Go to www.ryobitools.com and
register your new tool online. For questions about operating or
maintaining your product, please call 1-800-860-4050.
DO NOT OVERTILT THE UNIT!
If the engine does not start:
• check for enough fuel;
• may need to adjust choke position;
• try starting again.
995000727
2-22-19 (REV:01)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising