Gigaset | DA310 | User guide | Gigaset DA310 User guide

Gigaset DA310 User guide
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
1
en
Gigaset DA310 overview
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Programmable direct dial keys
Insert strip for writing the assignment of programmable direct dial keys and speed dial keys
Speed dial key
Set key
Redial/Pause key
Recall key
Mute key
Handset volume key
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
2
en
Connecting the telephone
¤
Connect the telephone connector (1) to the main phone socket using the
supplied telephone cable.
¤
2
Guide the cable through the
cable channel of the handset
cradle: upwards for operating
the phone on the table (2);
downwards when mounting the phone on the wall
(3).
5
¤
5
1
4
6
Connect the
handset to
the telephone
using the
coiled
cable (4).
3
Wall mounting
Drill two dowel holes into the wall at a distance of 99.4 mm and fix two
screws.
Lift out the handset bracket (5) with a screwdriver and clip it into the handset cradle (6).
Hang the telephone on the projecting screw heads.
Please note: The handset bracket must be placed in the cradle with the slanting edge facing forwards (see graphic), as otherwise the handset will not be
properly secured.
¤
¤
¤
Safety precautions
When installing, connecting and
operating the telephone, always
observe the following precautions:
u Only use the jacks and leads supplied.
u Only connect the connecting
lead to the intended socket.
u Only connect approved accessories.
u Lay the connecting lead where it
will not cause accidents.
u Position the telephone on a nonslip surface.
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
3
en
u For your safety and protection,
the telephone may not be used
in the bath or shower rooms (wet
locations). The telephone is not
splash proof.
u Never expose the telephone to
sources of heat, direct sunlight or
other electrical devices.
u Protect your telephone from
moisture, dust, corrosive liquids
and vapours.
u Never open up the telephone
yourself.
u Do not touch the plug contact
with pointed or metallic objects.
u Do not carry the telephone by
the leads.
u If you give your telephone to
someone else, make sure you
also give them the operating
manual.
Dialling and saving
numbers
Setting up the telephone
for use
Saving number
Recommended installation of telephone:
u Do not expose the telephone to
direct sunlight or other sources
of heat.
u Operate at temperatures of
between +5°C and +40°C.
u Maintain a distance of at least
one metre between the telephone and radio equipment, e.g.
radio telephones, radio paging
equipment or TV sets.
Otherwise, telephone communication could be impaired.
u Do not install the telephone in
dusty rooms as this can limit the
service life of the telephone.
u Furniture lacquer and polish can
be adversely affected by contact
with parts of the unit (e.g. feet).
Dialling a number
c~
Lift the handset, dial
the number.
Last number redial
The last number dialled is automatically saved.
cI
Lift the handset, press
the last number redial
key.
Speed dialling
You can save 4 numbers on the programmable direct dial keys B and
10 numbers for speed dial on the
number keys (0-9) (each with max. 21
digits).
K
Press the set key.
either ... via direct dial key
B
Press the programmable direct dial key.
or ... via speed dial
J
Press the speed dial
key.
Q ... O Define the speed dial
number.
~
Enter the number for
the programmable
direct dial key or speed
dial.
K
Press the set key.
Dialling a number via
programmable direct dial key
cB
Lift the handset, press
the programmable
direct dial key.
You can extend the dialled number
by entering additional digits.
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
4
en
Dialling a speed dial number
cJ
Q ... O
Lift the handset, press
the speed dial key.
Press the speed dial
number key.
Notes on saving and deleting
programmable direct dial and
speed dial numbers
* and # are saved regardless
of the set dialling mode but are only
dialled with tone dialling mode
( page 5).
If the number entered is longer than
21 digits, the saved number is
deleted.
£
Dialling pauses
One or more dialling pauses can be
entered using I (not at 1st digit).
Pauses are transferred to the memory and are necessary for certain
extension systems (e.g.:
0 I 2368).
u Dialling a dialling pause within
the first 5 digits:
The entire number saved is
dialled, including the
2-second dialling pause.
u Dialling a dialling pause after the
first 5 digits:
The portion of the number saved
after the pause is only dialled
after pressing the I key.
Adjusting the telephone
Setting the handset volume
The handset volume can be set to
two levels.
F
Press the handset volume control key.
The primary volume is reset after
hanging up.
Mute
You can deactivate the telephone's
microphone during a call.
C
Press the mute key.
To reactivate microphone: Press the
mute key again or press any other
key.
Setting the ringer
You can set the ringer melody and
volume or turn it off.
c K Lift the handset, press
the set key.
#
Press the hash key.
Q ... O Press one of the
number keys, see
Table.
(0: Ringer off until
handset is next lifted).
K
Press the set key.
Volume
low
Melody 1
Melody 2
Melody 3
medium
2
4 5
M N
high
3
L
O
Operation on a PABX
Special functions/Recall key
During an external call, you can
make an enquiry or forward the call.
To do this, press the recall key H.
The subsequent procedure depends
on your PABX.
To set the recall key, the telephone’s
flash time must be set consistent
with your PABX. Please refer to the
operating instructions for your PABX.
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
5
en
Changing the dialling mode/
flash time
The telephone supports the following dialling modes:
T2: Tone dialling, flash time 280 ms
T1:Tone dialling, flash time 100 ms
P: Pulse dialling
Depending on your PABX, you may
need to change your telephone’s
dialling mode or the flash time.
To do this, use the sliding switch on the
underside of the
device.
Temporary tone dialling switching
in "Pulse" position
To use functions that require tone
dialling (e.g. remote control of
answering machine), you can set the
telephone to tone dialling for the
duration of the call without adjusting the switch.
After the connection is established:
*
Press the star key.
After the connection is broken, the
setting reverts to pulse dialling.
Operation on public
telephone systems
Public telephone systems - in some
cases by special order/request – offer
you a range of useful additional services (e.g. call divert, call back on busy,
three-party conference etc.). These
services can be selected using specified key combinations, which your
network provider will notify you of.
You can save the entire key combination, including the number of a fixed
call divert destination, to your programmable direct dial keys or speed
dial keys just like a normal number.
Recall key
In public telephone systems, the
recall key is required to use certain
additional services; e.g. for "Call back
on busy".
You may need to adjust the flash
time of your telephone to the needs
of the public telephone system. To
do this, use the sliding switch on the
underside of the
telephone( page 5).
£
Appendix
Care
Wipe the unit with a damp cloth or
an antistatic cloth. Do not use solvents or microfibre cloths.
Never use a dry cloth; this can cause
static.
Contact with liquid !
If the device comes into contact with
liquid:
1 Allow the liquid to drain from the
device.
2 Pat all parts dry. Place the device
(the keypad facing down) in a
dry, warm place for at least 72
hours (not in a microwave, oven
etc.).
3 Do not switch on the device
again until it is completely dry.
When it has fully dried out, you will
normally be able to use it again.
In rare cases, contact with chemical
substances can cause changes to the
telephone's exterior. Due to the wide
variety of chemical products available on the market, it was not possible
to test all substances.
Questions and answers
You lift the handset but you hear
no dialling tone: Is the connecting
lead correctly plugged into the telephone and the telephone socket?
The dialling tone is audible but the
telephone will not dial: The con-
Gigaset DA310 / IM1 en/ A30054-M6528-R101-3-6Z19 / DA310_en.fm / 31.03.2016
6
en
nection is OK. Is the dialling mode set
correctly?
The other party cannot hear you:
Mute activated?
Regular pulse noises can be heard
during a call: The connection is
receiving metering pulses from the
exchange, which the telephone cannot interpret. Contact your network
operator.
Protecting our environment
Our environmental statement
We at Gigaset Communications
GmbH are aware of our social
responsibility. That is why we
actively take steps to create a better
world. In all areas of our business from product planning and production to sales and waste of disposal following our environmental conscience in everything we do is of
utmost importance to us. Learn more
about our earth-friendly products
and processes online at
www.gigaset.com.
Environmental management
system
Gigaset Communications GmbH is certified
according to the international standards
ISO 14001 and ISO 9001.
ISO 14001 (Environment): Certified
since September 2007 by TüV SÜD
Management Service GmbH.
ISO 9001 (Quality): Certified since
17/02/1994 by TüV Süd Management Service GmbH.
Contacts
If you should encounter any problems when operating the telephone
connected to a communication system with analogue network access,
please contact the network operator
responsible or your dealer.
Disposal
All electrical and electronic products
should be disposed of separately
from the municipal waste stream via
designated collection facilities
appointed by the government or the
local authorities.
This crossed-out wheeled
bin symbol on the product
means the product is covered by the European Directive
2012/19/EU.
The correct disposal and separate
collection of your old appliance will
help prevent potential negative consequences for the environment and
human health. It is a precondition for
reuse and recycling of used electrical
and electronic equipment.
For more detailed information about
disposal of your old appliance,
please contact your local council
refuse centre or the original supplier
of the product.
Authorisation
This device is intended for analogue
phone lines in the UK and on the Irish
network.
Country-specific requirements have
been taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant regulations laid down in Directive 2014/30/EU and 2014/35/EU.
A copy of the Declaration of Conformity is available at this Internet
address:
www.gigaset.com/docs
Gigaset DA310 /IM1 pt / A30054-M6528-R101-4-6Z19 / DA310_IM1_impressum.fm / 13.04.2016
1
pt
Issued by
Gigaset Communications GmbH
Frankenstrasse 2a, D-46395 Bocholt
© Gigaset Communications GmbH 2016
All rights reserved. Subject to availability.
Rights of modification reserved.
www.gigaset.com
A30054-M6528-R101-4-6Z19
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising