Posiflex | SA-705 \ SA-715 | User manual | Posiflex SA-705 \ SA-715 User Manual

Posiflex SA-705 \ SA-715 User Manual
SA-705/715
2D Image Scanner
Installation Guide
Package Contents



2D image scanner………………........(x1)
Installation guide…….……………....(x1)
2D image scanner quick setup guide...(x1)
Features





Compact 2D image scanner
Scan method: CMOS array sensor
Scan rate: Up to 60 fps (SA-705) / 100 fps (SA-715)
Interface: USB
Cylinder type design
18670900040 Ver. C0
http://www.posiflex.com
1
Views of the 2D Image Scanner
Front View
Rear View
Screw Hole
Trigger Switch1
Buzzer Outlet
USB I/O Cable
Scan Window w/
Object Detector
Knuckle Bearing
Note 1: If you scan the Manual Trigger setting barcode by mistake, please
make the SA-705/715 aim at the Auto Trigger setting barcode and
then insert the tip of a paper clip into the trigger switch to scan the
Auto Trigger setting barcode; the SA-705/715 will beep when the SA705/715 is successfully set back to the Auto Trigger mode.
Hardware Installation
During Installation of the SA-705/715, do NOT power ON your terminal.
Installation of SA-705/715 onto the 15”/17” XT Series Terminals
Start to install SA-705/715 onto the terminal according to the following
steps.
1.
Loosen and remove the two fixing screws
from the side mount cover on the back of
the right side of the terminal.
2.
Remove the side mount cover A from the
back of the right side of the terminal.
2
Cover A
3.
Remove the side mount cover B from the
terminal.
Cover B
4.
Insert the USB I/O cable of the SA-705/715
into the cable connector of the main board.
5.
Determine that the USB I/O cable is
securely connected to the cable connector of
the main board.
6.
Put the large side mount cover back in
place.
7.
Move the USB I/O cable to the middle, as
shown in the right figure.
3
8.
Align the two screw holes of the SA705/715 cover with the two screw holes on
the terminal.
9.
Fix the SA-705/715 onto the terminal with
the two fixing screws.
10.
The installation of SA-705/715 onto the
terminal is completed, as shown in the right
figure.
4
Adjustment of the SA-705/715 for a Better Operation Angle
To facilitate you to operate the 2D image scanner, you can adjust the scanning
direction of the SA-705/715 at three sets of adjusting angle, as described below.

Outward angle of 25 degrees from your XT-Series terminal
Terminal
SA-705/715

Frontward angle of 30 degrees from your XT-Series terminal
Terminal
SA-705/715

Backward angle of 105 degrees from your XT-Series terminal
Terminal
SA-705/715
5
Operating the 2D Image Scanner
SA-705/715 is provided with a 2D image
scanner. This scanner works to scan 1D
barcodes and 2D images. The scanner can work
in USB HID or USB Virtual COM mode. By
default, the scanner works in USB HID mode.
To do detailed settings by operating the
scanner, please refer to the HC/HS/SA-Series
2D Image Scanner Quick Setup Guide or
download the HC/HS/SA-Series 2D Image
Scanner Advanced User Manual from Posiflex Global Website:
(http://www.posiflex.com/en-global/Download/download).
6
Basic Optical Specifications
SA-705
Scan method
Number of effective pixel
Image capture speed
Adjusting angle
View angle
Auxiliary light source
(LED × 2)
Light source for aiming
(LED × 1)
CMOS area sensor
752 (H) × 480 (V) dot
60 fps (frame rate)
(Fastest seed of image capture)
Outward: 25° (approx.)
Frontward: 30° (approx.)
Backward: 105° (approx.)
Horizontal: 40.6° (approx.)
Vertical: 26.4°(approx.)
Red LED
Peak wave length: 617 nm
Directivity angle 2θ1/2: 60°
Maximum radiation output: 15000 mcd
Green LED
Peak wave length: 528 nm
Maximum radiation output: 18700 mcd
 Code 39
75 ~ 140mm (Resolution(0.127))
60 ~ 210mm (Resolution(0.25))
100 ~ 240mm (Resolution(0.33))
 Code 128
75 ~ 220mm (Resolution(0.25))
Depth of field (mm)
 UPC
50 ~ 230mm (Resolution(0.33))
 PDF417
50 ~ 190mm (Resolution(0.25))
 QR Code
40 ~ 200mm (Resolution(0.381))
 DataMatrix
60 ~ 160 (Resolution(0.31))
(Measured from the front end of the scanner)
7
1D barcode support:
JAN/UPC/EAN incl. add on, Codabar/NW-7,
Code 11, Code 39, Code 93, Code128, GS1128 (EAN-128), GS1 DataBar (RSS), IATA,
Industrial 2of5, Interleaved 2of5, ISBNISSNISMN, Matrix 2of5, MSI/Plessey, S-Code,
Telepen, Tri-Optic, UK/Plessey
Decoding capability
2D barcode support:
Aztec Code, Aztec Runes, Chinese Sensible
code, Codablock F, Composite codes, Data
Matrix (ECC200/EC0-140), Maxi Code
(mode 2~5), MicroPDF41, QR & Micro-QR
Code, PDF417
Postal code support:
Chinese Post, Intelligent Mail Barcode,
Korean Postal Authority code
8
SA-715
Scan method
Number of effective pixel
Image capture speed
Adjusting angle
View angle
Auxiliary light source
(LED × 1)
Light source for aiming
(LED × 1)
CMOS area sensor
640 (H) × 480 (V) dot
100 fps (frame rate)
(Fastest seed of image capture)
Outward: 25° (approx.)
Frontward: 30° (approx.)
Backward: 105° (approx.)
Diagonal: 46.4° (approx.)
Horizontal: 38.0° (approx.)
Vertical: 26.4°(approx.)
Warm White LED
Green LED
Peak wave length: 525 nm
 Code 39
45 ~ 120mm (Resolution(0.127))
60 ~ 240mm (Resolution(0.25))
80 ~ 260mm (Resolution(0.33))
 Code 128
65 ~ 210mm (Resolution(0.25))
Depth of field (mm)
 UPC
45 ~ 300mm (Resolution(0.33))
 PDF417
30 ~ 210mm (Resolution(0.25))
 QR Code
30 ~ 240mm (Resolution(0.381))
 DataMatrix
35 ~ 160 (Resolution(0.31))
(Measured from the front end of the scanner)
9
1D barcode support:
JAN/UPC/EAN incl. add on, Codabar/NW-7,
Code 11, Code 39, Code 93, Code128, GS1128 (EAN-128), GS1 DataBar (RSS), IATA,
Industrial 2of5, Interleaved 2of5, ISBNISSNISMN, Matrix 2of5, MSI/Plessey, S-Code,
Telepen, Tri-Optic, UK/Plessey
Decoding capability
2D barcode support:
Aztec Code, Aztec Runes, Chinese Sensible
code, Codablock F, Composite codes, Data
Matrix (ECC200/EC0-140), Maxi Code
(mode 2~5), MicroPDF41, QR & Micro-QR
Code, PDF417
Postal code support:
Chinese Post, Intelligent Mail Barcode,
Korean Postal Authority code
※ The product information and specifications are subject to change without
prior notice. To get the detailed information on SA-705/715, please check
this model from Posiflex Global Website
(http://www.posiflex.com/en-global/Download/download).
10
<MEMO>
11
<MEMO>
12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising