AcuRite | Remote Battery Pack | User manual | Acurite Remote Battery Pack User Manual

Acurite Remote Battery Pack User Manual
Battery Pack for AcuRite® AtlasTM Model 06074:
REMOVE BATTERY
COMPARTMENT COVER
INSERT BATTERY PACK CORD
LOOP CORD AND REPLACE
BATTERY COMPARTMENT COVER
1. Remove battery compartment cover from the
bottom of the AcuRite® AtlasTM outdoor device.
Remove batteries if currently installed.
2. Plug the battery pack cord into the battery
compartment AcuRite® AtlasTM.
3. Loop the cord through the slot, then replace the
battery compartment cover.
4. Remove the battery pack cover by pulling
upward on the cover’s tabs (away from the
battery pack).
INSTALL BATTERIES
REPLACE COVER
MOUNT BATTERY PACK
SECURE CABLE
6. Replace the battery pack cover.
7a. Mount the battery pack using the integrated
hang holes. We recommend mounting on a
pole or a flat surface such as a wall or post.
The battery pack is water-resistant and is
designed for general outdoor use.
7b. Use the included zip ties and hardware to
secure excess cable near the battery pack,
leaving enough slack for a “drip-loop,”
preventing rain water from trailing into the
battery pack. Installation is complete.
5. Insert 4 x AA alkaline or lithium* batteries into
the battery compartment. Heavy duty or
rechargeable batteries are not recommended.
* Cold temperatures can cause alkaline batteries to function improperly. Use lithium batteries for temperatures below -4°F (-20°C).
REMOVE BATTERY PACK COVER
QSG17_06074 082817
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising