Groen | Flanged Feet Kit | Installation instructions | Groen Flanged Feet Kit Installation Instructions

Groen Flanged Feet Kit Installation Instructions
PART NUMBER 176996, REV. A (11/18)
This manual provides information for:
OPERATOR MANUAL
IMPORTANT INFORMATION, KEEP FOR OPERATOR
1055 Mendell Davis Drive, Jackson, MS 39272
888-994-7636, fax 888-864-7636
unifiedbrands.net
OPERATORS AND INSTALLATION TECHNICIANS SHOULD READ, UNDERSTAND
AND FOLLOW ALL WARNINGS AND INSTRUCTIONS PROVIDED IN THIS SHEET.
NOTIFY CARRIER OF DAMAGE AT ONCE It is the responsibility of the
consignee to inspect the container upon receipt of same and to determine
the possibility of any damage, including concealed damage. Unified
Brands suggests that if you are suspicious of damage to make a notation
on the delivery receipt. It will be the responsibility of the consignee to file
a claim with the carrier. We recommend that you do so at once.
FLANGED FEET KIT
INSTALLATION
The following instructions are applicable to the flanged feet kits supplied as optional equipment for Groen Braising Pans; Groen Steamers:
Vortex100™, SmartSteam100™, HyPerSteam™, and Intek™; Groen
ComboEase™ Steamer/Ovens; and small kettles/small braising pan
mounted on Groen TS/10 Stands.
A RESTRAINING DEVICE IS REQUIRED FOR ALL UNITS WITH CASTERS PER EITHER OF
THE FOLLOWING STANDARDS: UL/ANS1 197, ANSI Z83.11/CSA 1.8
Manufacture Service/Questions 888-994-7636.
146221 KIT FOR BPM AND BPP MODELS,
ELECTRIC OR GAS, AND TS/10 STANDS
1. Raise the Braising Pan about 8” above the floor.
156249 KIT FOR VORTEX100, SMARTSTEAM100,
HYPERSTEAM, AND INTEK STEAMER STANDS
2. Unscrew the installed bullet feet adapters from the four legs of the Braising Pan.
CAUTION: DO NOT TILT THE STEAMER AND INSTALL (2) FEET, THEN TILT TO THE
OTHER SIDE TO INSTALL THE LAST PAIR THIS WILL DAMAGE THE STAND.
3. Screw the two flanged feet into the front legs of the Braising Pan.
WARNING: SUPPORT THE STEAMER AND STAND SECURELY BEFORE LIFTING SO THAT
IT DOES NOT TIP OVER DURING INSTALLATION.
4. Level the Braising Pan front-to-back and left-to-right by adjusting the feet.
1. On Steamer(s), all four legs must be raised at the same time to properly
install flanged feet.
2. Remove the four bullet foot inserts from the stand legs. They are force-fit
into the ends of the legs and can be driven out with a small hammer and a
screwdriver.
3. Insert the flanged feet into the legs of the stand.
Information contained in this document is known to be current and accurate at the time of printing/creation. Unified Brands recommends referencing our product line websites, unifiedbrands.net,
for the most updated product information and specifications. © 2018 Unified Brands. All Rights Reserved. Unified Brands is a wholly-owned subsidiary of Dover Corporation.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising