Shure | AXT651 | User guide | Shure AXT651 User guide

Shure AXT651 User guide
AXT651
Talk Switch
AXT651 Talk Switch
Installing the talk switch on an AXT200 transmitter adds remote push-button
audio routing of the XLR and TRS analog audio outputs of a linked AXT400
receiver. The transmitter must be within range of a synced AXT400 receiver
to enable talk switch operation. To activate audio routing, press and hold the
talk switch button.
Installation
1. Thread the microphone cartridge into the talk switch body.
2. Thread the talk switch into the transmitter body.
3. The switch ring can be rotated to align with the menu screen.
Talk Switch Mode
Selecting Talk Switch mode from the Audio menu of a synced AXT400 receiver enables remote push-button audio routing of the XLR and TRS outputs
from an AXT100 bodypack transmitter or AXT200 handheld transmitter with
the AXT651 Talk Switch installed. In Talk Switch mode, press and hold the
transmitter button to route the audio output of a synced AXT400 receiver.
The Audio menu of the AXT400 receiver has three Talk Switch modes that
determine how the audio is routed to the XLR and TRS connectors.
Push to Add TRS Output
Audio is routed to the TRS connector when the button is pressed, audio at
the XLR connector is always on.
Push to Toggle TRS Output
In Toggle mode, the button routes the audio to either the XLR connector or
to the TRS connector.
Release
XLR = On
TRS = Off
Press
XLR = Off
TRS = On
Selecting a Talk Switch Mode
1. The talk switch mode is selected from the AXT400 receiver audio menu:
Audio>Talk Switch
2. Use the control wheel to select the mode. Press enter to save.
mic
line
3. Use the IR Sync function to link the transmitter and receiver.
lift
GND
On
4. Press and hold the talk switch button to activate audio routing.
Switched
When using Talk Switch mode, the following options are available for routing
the AES3 output:
Push to Add XLR Output
Audio is routed to the XLR connector when the button is pressed, audio at
the TRS connector is always on.
mic
line
Routing AES3 Output
•
Always On: The AES3 output is always active and is independent of the
talk switch button
•
Follow TRS: The AES3 output follows the TRS output when the talk
switch button is pressed and held.
•
Follow XLR: The AES3 output follows the XLR output when the talk switch
button is pressed and held.
lift
GND
Switched
On
Specifications
©2017 Shure Incorporated
1/2
AXT651 Talk Switch
Shure Incorporated
Diameter
37 mm
(1.46
in.)
(OD)
36 mm
(1.43
in.)
51 g
(1.8
oz.)
Aluminum
ABS
Plastic
Height
Weight
Housing Material
Switch Material
Certifications
Meets essential requirements of the following European Directives:
•
EMC Directive 2004/108/EC
•
Battery Directive 2006/66/EC
Please follow your regional recycling scheme for battery disposal.
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com
2/2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising