Shure | SBC902 | User guide | Shure SBC902 Battery Charger User guide

Shure SBC902 Battery Charger User guide
SBC902
Battery Charger
Charging Batteries
The charger can be powered from AC power sources or from USB ports. The
charger LED indicates battery status during charging.
Charging Status LED
Charging from an AC Power Source
1. Plug the AC adapter into an AC power source. Connect the battery
charger cable to the AC adapter.
LED Color
Charging Status
Red
Battery Charging
Green
Charging Complete
Amber Flashing
Charging Fault: check connections
and battery position
Off
No battery or power disconnected
Input Current (AC Adapter)
1.0 A
2. Insert a battery into the charging bay.
3. Monitor the charging status LED until charging is complete.
Charging from a USB Port
1. Plug the USB cable into an USB port.
2. Insert a battery into the charging bay.
3. Monitor the charging status LED until charging is complete.
Specifications
AC Adapter
Input Current (USB Power)
500 mA
Input Voltage
100 to 240 V AC
Output Voltage and Current
3.0 to 4.2 V DC @ 1.0 A
Input Frequency
50 to 60 Hz
Operating Temperature
0 to 40 C (32 to 104 F)
Input Current
200 mA @ 100 V AC (full load)
Dimensions (H x W x L)
Output Voltage and Current
5.0 V DC @ 1.0A
26.7 x 36.6 x 111.0 mm (1.05 x 1.44
x 4.37 in.)
Operating Temperature
0 to 40 C (32 to 104 F)
Weight (without battery)
46.0 g (1.62 oz.)
Housing Material
ABS Plastic
Battery Charger
Input Connector Type
USB Micro-B
Input Voltage
4.75-5.25 V DC
WARNING
•
Battery packs may explode or release toxic materials. Risk of fire or
burns. Do not open, crush, modify, disassemble, heat above 140°F
(60°C), or incinerate.
•
Do not short circuit; may cause burns or catch fire
•
Do not charge or use battery packs other than Shure rechargeable batteries
•
Follow instructions from manufacturer
•
•
Only use Shure charger to recharge Shure rechargeable batteries
Dispose of battery packs properly. Check with local vendor for proper
disposal of used battery packs.
•
WARNING: Danger of explosion if battery incorrectly replaced. Replace
only with same or equivalent type.
•
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like
•
Never put batteries in mouth. If swallowed, contact your physician or local
poison control center
Certifications
Approved per Australian Standard requirements of AS/NZS 4665.1:2005 and
AS/NZS 4665.2:2005.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Conforms to electrical safety requirements based on IEC 60950-1
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
Meets essential requirements of all applicable European Directives.
Eligible for CE marking.
©2017 Shure Incorporated
1/2
SBC902 Battery Charger
Shure Incorporated
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3 (B)
Information to the user
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate this equipment.
Please consider the environment, electric products and packaging are part
of regional recycling schemes and do not belong to regular household waste.
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com
2/2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising