Shure | IH6500 | User guide | Shure IH6500 Interpreter Headset User guide

Shure IH6500 Interpreter Headset User guide
IH 6500 -- IH 6500 Interpreter Headset
SAFETY PRECAUTIONS
The possible results of incorrect use are marked by one of the two symbols—"WARNING" and "CAUTION"—de­
pending on the imminence of the danger and the severity of the damage.
WARNING: Ignoring these warnings may cause severe injury or death as a result of incorrect
operation.
CAUTION: Ignoring these cautions may cause moderate injury or property damage as a result
of incorrect operation.
CAUTION
• Never disassemble or modify the device, as failures may result.
• Do not subject to extreme force and do not pull on the cable or failures may result.
• Keep the product dry and avoid exposure to extreme temperatures and humidity.
WARNING
• If water or other foreign objects enter the inside of the device, fire or electric shock may result.
• Do not attempt to modify this product. Doing so could result in personal injury and/or product failure.
This device is able to produce sound volume higher than 85 dB SPL. Please check your maximum allowed contin­
uous noise exposure level based on your national employment protection requirements.
WARNING
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS
LOW A VOLUME AS POSSIBLE. Over exposure to excessive sound levels can damage your ears resulting in
permanent noise­induced hearing loss (NIHL). Please use the following guidelines established by the Occupation­
al Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing dam­
age occurs.
1/8
Shure Incorporated
90 dB SPL
at 8 hours
95 dB SPL
at 4 hours
100 dB SPL
at 2 hours
110 dB SPL
at ½ hour
115 dB SPL
at 15 minutes
120 dB SPL
Avoid or damage may occur
105 dB SPL
at 1 hour
IH 6500 Interpreter Headset
The IH 6500 Interpreter Headset provides exceptional audio quality, comfort, and durability for interpreters. The
condenser microphone delivers natural, highly-intelligible vocal reproduction.
•
•
•
•
•
•
•
Dual-sided headset designed for use with Shure DIS interpreter stations
Supra-aural design with comfortable, lightweight construction
Directional condenser microphone for clear, intelligible speech during important events
Meets the European Union ISO requirement for interpreter headsets
Flexible boom microphone pivots 270 degrees for left or right side wear and precise positioning
Removable ear pads allow easy cleaning and are optional during use
Terminates to two 3.5 mm connectors and includes adapter for backwards compatibility with older DIS inter­
preter stations
• Legendary Shure durability designed under rigorous quality standards to withstand the demands of everyday
professional use
Care and Maintenance
Clean using a soft, damp cloth.
CAUTION: Do not use cleansers that contain solvents. Keep liquid and foreign objects out of the driver openings.
Wearing the Headset
Adjust the headband for a comfortable fit.
2/8
Shure Incorporated
Position the boom so the microphone is within 13 mm (1/2 inch) of the corner of your mouth. To avoid "popping" or
other breath noise, do not place directly in front of mouth.
The boom swivel allows the headset to be worn on either side of your face.
Find More Information Online
For more information, visit http://www.shure.com
Replacement Parts
1 pair of replacement earcup pads for IH6500
IHAEC6500
Replacement windscreen for IH6500
IHAWS1
Cable adapter for two 1/8" (3.5 mm) female jacks to 9­pin DIN connector. Com­
patible with DIS legacy interpreter stations.
IHAC3.5MM-DIN
Cable adapter for two 1/8" (3.5 mm) female jacks to one 1/8" (3.5 mm) TRRS
male plug
IHAC3.5MM-TRRS
Specifications
Weight
Net (without cable)
135 g (4.75 oz.)
Packaged
455 kg (16.0 lbs)
3/8
Shure Incorporated
Cable
2 m, 5-conductor, 2x 3.5 mm (1/8") TRS
Environmental Conditions
Operating Temperature
-20° to 60° C (-4° to 140° F)
Storage Temperature
-30° to 75° C (-22° to 167° F)
Relative Humidity
45 to 85%
Type
Electret Condenser
Polar Pattern
Supercardioid
Frequency Response
20 to 20,000 Hz
Output Impedance
2,000 Ω
Sensitivity
at 1 kHz
−48 dBV/Pa* (4 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on tip with respect to sleeve (ground) of microphone
output phone plug connector
Headphone
Transducer Type
Dynamic, Neodymium magnet
Driver Size
40 mm
Frequency Response
20 to 20,000 Hz
Sensitivity
@ 1 kHz
4/8
Shure Incorporated
116 dB SPL/mW
Impedance
@ 1 kHz
120 Ω
Maximum Input Power
200 mW
Cable Wiring
Dual 3.5 mm (1/8") Connectors
Connector
Color
Contact
Signal
Microphone
Pink
Sleeve
Mic -
Tip/Ring
Mic +
Sleeve
Ground
Tip
Headphone +
Ring
Headphone -
Headphone
Green
5/8
Shure Incorporated
Performance Characteristics
6/8
Shure Incorporated
Certifications
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
LIMITED WARRANTY
Shure Incorporated (“Shure”) hereby warrants to the original consumer purchaser only that, except as otherwise
specified below, this product will be free in normal use of any defects in materials and workmanship for a period of
two (2) years from the consumer’s original date of purchase directly from Shure or from a Shure­authorized re­
seller.
Any rechargeable batteries contained in or packaged with this product are so warranted for a period of one (1)
year from the consumer’s original date of purchase. However, rechargeable batteries are consumable and their
capacity will be reduced over time based on temperature, amount of time in storage, charging cycles, and other
factors; hence reduction in battery capacity does not constitute a defect in material or workmanship.
At its sole option, Shure will repair or replace the defective product and promptly return it to you. In order for this
warranty to be valid, the consumer must, at the time the product is returned, provide proof of purchase in the form
of the original purchase receipt directly from Shure or from a Shure-authorized reseller. If Shure elects to replace
the defective product, then Shure reserves the right to replace the defective product with another product of the
same model or a model of at least comparable quality and features in Shure’s sole determination.
If you believe this product is defective within the warranty period, carefully repack the unit, insure it and return it
with proof of purchase, postage prepaid, to Shure Incorporated, Attention: Service Department, at the address be­
low.
Outside of the United States, return the product to your dealer or Authorized Service Center. Addresses are listed
on www.Shure.com or can be obtained by contacting Shure at the address listed below.
This warranty is not transferable. This warranty does not apply in cases of abuse or misuse of the product, use
contrary to Shure’s instruction, ordinary wear and tear, an act of God, negligent use, purchase from a party other
than Shure or a Shure-authorized reseller, unauthorized repair, or modification of the product.
7/8
Shure Incorporated
ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE
HEREBY DISCLAIMED TO THE EXTENT PERMITTED UNDER APPLICABLE LAWS AND, TO THE EXTENT
NOT PERMITTED, ARE HEREBY LIMITED TO THE DURATION AND TERMS OF THIS WARRANTY. SHURE
ALSO HEREBY DISCLAIMS ALL LIABILITY FOR INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of inciden­
tal or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal
rights, and you may have other rights which vary from state to state.
This warranty does not restrict the rights of the consumer mandated under applicable laws.
THIS WARRANTY SUPERSEDES ALL OTHER WARRANTIES THAT ARE ASSOCIATED OR INCLUDED WITH
THIS PRODUCT, EXCEPT THAT ANY SOFTWARE CONTAINED IN OR PACKAGED WITH THIS PRODUCT IS
EXCLUDED FROM THIS WARRANTY AND INSTEAD SHALL BE COVERED BY THE WARRANTY, IF ANY,
PROVIDED IN SHURE’S END USER LICENSE AGREEMENT ACCOMPANYING SUCH SOFTWARE.
Service Centers
United States, Canada, Latin America, Caribbean
Shure Incorporated
Attn: Service Department
945 Chaddick Dr.
Wheeling, IL 60090-6449 U.S.A.
Europe, Middle East, and Africa
Shure Europe GmbH
Attn: Service
Jakob-Dieffenbacher-Str. 12,
75031 Eppingen, Germany
IndonesiaService Center Resmi:
Jakarta Hotline (021) 612 6388
Medan (061) 6612550
Surabaya (031) 5032219
Jogjakarta (0274) 371710
Denpasar (0361) 766788
Makasar (0411) 324652
8/8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising