Shure | BRH31M | User guide | Shure BRH31M Lightweight Single-Sided Broadcast Headset User guide

Shure BRH31M Lightweight Single-Sided Broadcast Headset User guide
BRH31M
Lightweight Single-Sided Broadcast Headset
The Shure broadcast headsets, BRH31M, user guide.
Version: 4 (2019-G)
Shure Incorporated
Table of Contents
Model Variations
5
Wearing the Headset
5
Specifications
6
BRH31MLightweight Single-Sided Broadcast Headset 3
LIMITED WARRANTY
Service Centers
3
3
Wiring Diagram
SAFETY PRECAUTIONS
4
CAUTION
4
WARNING
4
WARNING
4
General Description
8
5
Care and Maintenance
9
Furnished Accessories
9
Certifications
10
Trademarks
10
2/10
Shure Incorporated
BRH31M
Lightweight Single-Sided Broadcast Headset
LIMITED WARRANTY
Shure Incorporated (“Shure”) hereby warrants to the original consumer purchaser only that, except as otherwise specified be­
low, this product will be free in normal use of any defects in materials and workmanship for a period of two (2) years from the
consumer’s original date of purchase directly from Shure or from a Shure­authorized reseller.
Any rechargeable batteries contained in or packaged with this product are so warranted for a period of one (1) year from the
consumer’s original date of purchase. However, rechargeable batteries are consumable and their capacity will be reduced over
time based on temperature, amount of time in storage, charging cycles, and other factors; hence reduction in battery capacity
does not constitute a defect in material or workmanship.
At its sole option, Shure will repair or replace the defective product and promptly return it to you. In order for this warranty to be
valid, the consumer must, at the time the product is returned, provide proof of purchase in the form of the original purchase re­
ceipt directly from Shure or from a Shure­authorized reseller. If Shure elects to replace the defective product, then Shure re­
serves the right to replace the defective product with another product of the same model or a model of at least comparable
quality and features in Shure’s sole determination.
If you believe this product is defective within the warranty period, carefully repack the unit, insure it and return it with proof of
purchase, postage prepaid, to Shure Incorporated, Attention: Service Department, at the address below.
Outside of the United States, return the product to your dealer or Authorized Service Center. Addresses are listed on
www.Shure.com or can be obtained by contacting Shure at the address listed below.
This warranty is not transferable. This warranty does not apply in cases of abuse or misuse of the product, use contrary to
Shure’s instruction, ordinary wear and tear, an act of God, negligent use, purchase from a party other than Shure or a Shure­
authorized reseller, unauthorized repair, or modification of the product.
ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DIS­
CLAIMED TO THE EXTENT PERMITTED UNDER APPLICABLE LAWS AND, TO THE EXTENT NOT PERMITTED, ARE
HEREBY LIMITED TO THE DURATION AND TERMS OF THIS WARRANTY. SHURE ALSO HEREBY DISCLAIMS ALL
LIABILITY FOR INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or conse­
quential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may
have other rights which vary from state to state.
This warranty does not restrict the rights of the consumer mandated under applicable laws.
THIS WARRANTY SUPERSEDES ALL OTHER WARRANTIES THAT ARE ASSOCIATED OR INCLUDED WITH THIS PROD­
UCT, EXCEPT THAT ANY SOFTWARE CONTAINED IN OR PACKAGED WITH THIS PRODUCT IS EXCLUDED FROM THIS
WARRANTY AND INSTEAD SHALL BE COVERED BY THE WARRANTY, IF ANY, PROVIDED IN SHURE’S END USER LI­
CENSE AGREEMENT ACCOMPANYING SUCH SOFTWARE.
Service Centers
United States, Canada, Latin America, Caribbean
Shure Incorporated
Attn: Service Department
945 Chaddick Dr.
Wheeling, IL 60090-6449 U.S.A.
3/10
Shure Incorporated
Europe, Middle East, and Africa
Shure Europe GmbH
Attn: Service
Jakob-Dieffenbacher-Str. 12,
75031 Eppingen, Germany
IndonesiaService Center Resmi:
Jakarta Hotline (021) 612 6388
Medan (061) 6612550
Surabaya (031) 5032219
Jogjakarta (0274) 371710
Denpasar (0361) 766788
Makasar (0411) 324652
SAFETY PRECAUTIONS
The possible results of incorrect use are marked by one of the two symbols—"WARNING" and "CAUTION"—depending on the
imminence of the danger and the severity of the damage.
WARNING: Ignoring these warnings may cause severe injury or death as a result of incorrect operation.
CAUTION: Ignoring these cautions may cause moderate injury or property damage as a result of incor­
rect operation.
CAUTION
• Never disassemble or modify the device, as failures may result.
• Do not subject to extreme force and do not pull on the cable or failures may result.
• Keep the product dry and avoid exposure to extreme temperatures and humidity.
WARNING
• If water or other foreign objects enter the inside of the device, fire or electric shock may result.
• Do not attempt to modify this product. Doing so could result in personal injury and/or product failure.
This device is able to produce sound volume higher than 85 dB SPL. Please check your maximum allowed continuous noise exposure level based on your na­
tional employment protection requirements.
WARNING
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOL­
UME AS POSSIBLE. Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced
hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA)
on maximum time exposure to sound pressure levels before hearing damage occurs.
90 dB SPL
95 dB SPL
100 dB SPL
105 dB SPL
at 8 hours
at 4 hours
at 2 hours
at 1 hour
110 dB SPL
115 dB SPL
120 dB SPL
4/10
Shure Incorporated
at ½ hour
at 15 minutes
Avoid or damage may occur
General Description
The BRH31M Broadcast Headset provides exceptional audio quality, comfort, and durability for broadcast and media produc­
tion applications. A dynamic microphone delivers clear, natural vocal reproduction in an ultra­lightweight design. With user­re­
placeable parts and multiple connector options, the BRH31M is a versatile headset with a long product life.
• Supra-aural design with ultra-lightweight construction
• Dynamic microphone with cardioid polar pattern and frequency response optimized for communication in loud environ­
ments
• Adjustable headband with cushioned temple pad for comfortable, ergonomic fit
• Flexible boom microphone with 270-degree pivot range for left- or right-side wear and precise positioning
®
• Single-side, Kevlar -reinforced cable for increased durability
• Robust design created under rigorous Shure quality standards to withstand the demands of everyday professional use
• User-replaceable earcup pad and windscreen for a long product life
Model Variations
Model
Connector
BRH31M
Unterminated
BRH31M-NXLR4F
Neutrik™ XLR 4-Pin Female
BRH31M-NXLR4M
Neutrik XLR 4-Pin Male
BRH31M-NXLR5M
Neutrik XLR 5-Pin Male
Wearing the Headset
Adjust the headband for a comfortable fit.
5/10
Shure Incorporated
Position the boom so the microphone is within 13 mm (1/2 inch) of the corner of your mouth. To avoid "popping" or
other breath noise, do not place directly in front of mouth.
The boom swivel allows the headset to be worn on either side of your face.
Specifications
Weight , without cable
Net
81 g (2.9 oz.)
Packaged
0.4 kg (0.9 lbs)
Weight , with connector
Net
125 g (4.4 oz.)
Packaged
0.45 kg (0.99 lbs)
Cable
BRH31M
1.8 m, non-PVC, unterminated
BRH31M-NXLR4F
1.75 m, non-PVC, terminated at a 4-pin female XLR
BRH31M-NXLR4M
1.75 m, non-PVC, terminated at a 4-pin male XLR
BRH31M-NXLR5M
1.75 m, non-PVC, terminated at a 5-pin male XLR
Environmental Conditions
Operating Temperature
18° to 60° C (0° to 140° F)
6/10
Shure Incorporated
Storage Temperature
-29° to 74° C (-20° to 165° F)
Relative Humidity
0 to 95%
Microphone
Type
Dynamic, Neodymium magnet, 12.5 mm
Polar Pattern
Cardioid
Frequency Response
50 to 15,000 Hz
Output Impedance
150 Ω
Sensitivity
at 1 kHz, open circuit voltage
-66.5 dBV/Pa* (0.47 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on red wire with respect to black wire.
Headphone
Transducer Type
Dynamic, Neodymium magnet
Driver Size
30 mm
Frequency Response
150 to 12,000 Hz
Sensitivity
@ 1 kHz
101 dB SPL/mW
Impedance
@ 1 kHz
220 Ω
Maximum Input Power
200 mW
7/10
Shure Incorporated
Wiring Diagram
Signal
Wire
NXLR4
NXLR4-FEM
NXLR5
Microphone +
Red
2
2
2
Microphone −
Black
1
1
1
Microphone Ground
Shield (uncoated)
3
1
3
Audio
Green
4
4
4
Audio Ground
White
3
3
3
Frequency Response
8/10
Shure Incorporated
Polar Pattern
Care and Maintenance
Clean using a soft, damp cloth.
CAUTION: Do not use cleansers that contain solvents. Keep liquid and foreign objects out of the driver openings.
Furnished Accessories
1 Pair of Replacement Earcup Pads
BCAEC31
9/10
Shure Incorporated
Windscreen
BCAWS1
Certifications
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
Trademarks
Neutrik is a registered trademark of Neutrik AG.
10/10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising