Clearone COLLABORATE Live 200 Guide

Clearone COLLABORATE Live 200 Guide
COLLABORATE® Live 200
Quick-Start Guide
COLLABORATE LIVE 200
COMPONENTS INCLUDED
COLLABORATE Live 200
COLLABORATE
Live 200 codec with
power supply, VESA
Mounting Plate, and
COLLABORATE
Remote Control with
USB dongle
910-2100-006
UNITE 50 EPTZ
camera, USB cable,
camera remote control
Note: The remote control
inside the camera box
is only for any advanced
configuration in the
camera, if required.
For the camera’s control,
use the COLLABORATE
Codec Appliance’s remote
control.
910-3001-200
CHAT 150C with USB
cable
2
QUICK-START GUIDE
CONNECTING PERIPHERALS
Connect the CHAT 150C, UNITE Camera, monitor(s), and network to the
COLLABORATE Live 200 codec as shown.
DC In
HDMI 1080P or 720P
Video/Audio Out (for
Primary Monitor)
USB Port for
UNITE Camera
Mini Display
Port (for 2nd
Monitor)
DC In
Ethernet
Connection
to Network
USB 3.0 Port for
CHAT 150C
CONNECTING REMOTE CONTROL DONGLE
Install batteries in the remote control and plug in the USB dongle into the
codec.
Note: To maximize range of the remote, verify that the dongle and the
UNITE camera USB are plugged into opposite sides of the codec.
3
COLLABORATE LIVE 200
Remote control
dongle only
7.1 digital L+R
audio output jack
SECURITY
A lock support feature allows you to secure your codec.
Lock Support
4
SD Card Slot
(Do Not Use)
QUICK-START GUIDE
CONFIGURING DISPLAY SETTINGS
After all peripherals are connected to the unit, turn the unit on.
Once COLLABORATE Live is loaded, the Setup Wizard appears. The
Setup Wizard lets you configure the system name, time, and network,
proxy, and COLLABORATE Space settings. After the Setup Wizard is
complete, using the remote control, navigate to the display settings:
Settings > Advanced > Display
According to your monitor capabilities, set to the maximum supported
resolution. If 2 monitors are connected to the unit, the display mode is
automatically changed to dual mode and you can set both monitors’
resolutions.
5
COLLABORATE LIVE 200
CONFIGURING AUDIO SETTINGS
The COLLABORATE Live 200 audio input and output are set to the CHAT
150C.
Verify this in COLLABORATE Settings > Audio & Video
6
QUICK-START GUIDE
CONFIGURING NETWORK SETTINGS
Using your remote control, navigate into the network settings:
Settings > Advanced > Network
The COLLABORATE Live 200 obtains its IP automatically by default from
a DHCP server.
Set “Obtain Address From DHCP” to “Disabled” to manually configure
network settings.
7
COLLABORATE LIVE 200
CLEARONE CONTACTS
Headquarters
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Sales
Tel: 801.975.7200
e-mail: sales@clearone.com
US & Canada
Tel: 801.975.7200
TollFree: 800.945.7730
Fax: 801.303.5711
TechSupport
Tel: 801.974.3760
e-mail: collaborate.support@clearone.com
International
Tel: +1.801.975.7200
e-mail: global@clearone.com
Website
www.clearone.com
© 2019 ClearOne, Inc. All rights reserved.
Information in this document is subject to change without notice. QSG-0078-001 Revision 1.0 February 2019
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement