CyberPower CSB6012 User Manual
6-Outlet Surge Protector
CSB6012
1
CONGRATULATIONS ON YOUR PURCHASE
CAUTION
Thank you for selecting the CyberPower CSB6012 Surge
Protector. This manual explains the features and operation
of the CSB6012. Please take a few moments to read
this manual.
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only in
dry locations and only indoors. DO NOT plug into another
relocatable power tap. DO NOT “daisy chain” surge
protectors. DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not
available. DO NOT install this device if there is less than 10
meters (30 feet) or more of wire between the electrical
outlet and electrical service panel. DO NOT use for
medical or life support equipment. This device features an
internal protection that will disconnect the surge
protective component at the end of its useful life, but it
will maintain unprotected power to the load. If this
situation is undesirable for the application, follow the
manufacturer’s instructions for replacing the device.
FEATURES
1. ON/OFF Reset Control Switch and Circuit Breaker
Controls power to all outlets. The switch is also a 15 A
breaker. When an overload occurs, it will automatically
switch off. To resume operation, ensure the overload
condition is removed and reset the surge protector by
switching the unit ON.
2. Standard Grounded Outlets (6)
SPECIFICATIONS
•
•
•
•
•
•
•
2
•
•
•
•
Model Number: CSB6012
Outlets: Standard Grounded Outlets (6)
Surge Protection: 1,200 Joules
Electrical Rating: 125 V/15 A/1875 W
UL Clamping Voltage: UL 1449 3rd/400 V (H-N, H-G, N-G)
Maximum Peak Current: 60,000A
3 AC Lines Protected:
H-N: 30,000 A
H-G: 15,000 A
N-G: 15,000 A
The maximum surge possible on household wiring is
6,000 volts)
Response Time: Less than 1 nanosecond
Attenuation: Up to 32 dB
Circuit Breaker: Resettable 15 Amp
EMI/RFI Filtration: 150 kHz to 100 MHz
TROUBLESHOOTING
▪ If the ON/OFF is switched OFF, the 15 Amp circuit
breaker may have tripped. Examine your connected
equipment and remove the device that is overloading the
circuit. Then, turn the ON/OFF switch back to RESET.
TECHNICAL SUPPORT
Please contact our Tech Support Department with
installation, troubleshooting, or general product questions.
• Phone: 1-877-297-6937
• Email: tech@cpsww.com
• Hours of Operation:
Monday – Friday 7:00am – 6:00pm CST
USER MANUAL
1
Copyright © 2019 Cyber Power Systems (USA), Inc. All rights reserved.
2
LIMITED WARRANTY AND CONNECTED
EQUIPMENT GUARANTEE
Read the following terms and conditions carefully before
using the CyberPower CSB6012 (the “product”). By using the
product, you consent to be bound by the terms and
conditions of this limited warranty and connected equipment
guarantee (together referred to as this “warranty”). IF YOU
DO NOT AGREE TO THE TERMS AND CONDITIONS OF THIS
WARRANTY, YOU SHOULD RETURN THE PRODUCT FOR A
FULL REFUND PRIOR TO USING IT.
Who is providing this warranty, and what does it cover?
Cyber Power Systems (USA), Inc. (“CyberPower”) provides
this limited warranty. It only covers the original purchaser
and ends if you no longer own the product. This warranty
covers defects in materials and workmanship in the product
under normal use and conditions. It also covers equipment
connected to the product damaged because of the failure of
the product. This warranty covers the product and
connected equipment for as long as you own the product.
How do you open a connected equipment claim?
1. Call us at (877) 297-6937, or write to us at:
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400
Shakopee, MN 55379,
or send us an email at claims@cpsww.com within 10 days
of the occurrence for instructions.
2. When you contact CyberPower, identify the product, the
purchase date, and the item(s) of connected equipment.
Have information on all applicable insurance or other
resources of recovery/payment that are available to the
initial customer, and request a claim number.
3. You must provide a dated purchase receipt (or other proof
of the original purchase) for the CyberPower unit and
connected equipment. You also need to provide a
description of the damage to your connected equipment.
4. Pack and ship the product to CyberPower and the item(s)
of connected equipment, a repair cost estimate for the
damage to the connected equipment, and all claim forms
that CyberPower provides to you. Show the claim number
on the shipping label, or include it with the product. You
must prepay all shipping costs. You are responsible for
packaging and shipment, and you must pay the cost of
the repair estimate.
What will CyberPower do to correct problems?
CyberPower will inspect and examine the product. If the
product is defective in material or workmanship, CyberPower
will replace it at CyberPower’s expense, or CyberPower will
refund the full purchase price you paid for the product
(purchase receipt showing price paid is required). If the
product failed to protect any equipment plugged into it, we
will also send you forms for making your claim for the
3
connected equipment. We will replace the equipment that was
damaged because of the failure of the product or pay you the
fair market value (NOT REPLACEMENT COST) of the
equipment at of the time of the damage. We will use Orion
Blue Book, another third-party valuation guide, eBay, Craigslist,
or other source to establish that amount. Our maximum liability
is limited to $75,000 for the CSB6012.
Who pays for shipping?
We pay shipping when we send items to you; you pay when
you send items to us.
What are some things this Warranty does not cover?
1. THIS WARRANTY DOES NOT COVER: ANY SOFTWARE THAT
WAS DAMAGED, SOFTWARE THAT NEEDS TO BE REPLACED
DUE TO THE FAILURE OF THE PRODUCT, OR ANY DATA THAT
IS LOST AS A RESULT OF THE FAILURE. THIS WARRANTY
DOES NOT COVER THE RESTORATION OF DATA OR
RECORDS, OR THE REINSTALLATION OF SOFTWARE.
2. This warranty does not cover: misuse, modification, operation
or storage outside of the environmental limits of the product
or the equipment connected to it. It does not cover damage
while in transit or in storage; if there has been improper
operation or maintenance, or use with items not designed or
intended for use with the product, such as laser printers,
appliances, aquariums, medical, or life support devices, etc.
What are the other limitations?
The sole and exclusive remedies of the initial customer are
those provided by this warranty.
1. This warranty does not apply unless the product and the
connected equipment were connected to properly wired and
grounded outlets (including compliance with electrical and
safety codes of the most current electrical code), without the
use of any adapters or other connectors.
2. The product must have been plugged directly into the power
source. The equipment connected to the product must be
directly connected in the product, not “daisy chained”
together in serial fashion with any extension cords, another
product, or device similar to the product, surge suppressor,
or power tap. Any such installation voids the warranty.
3. The product and connected equipment must have been used
properly in a suitable environment, in conformance with any
applicable license, instruction manual, or warnings.
4. The product must have been used at all times within the
limitations on the product’s maximum rated wattage.
Where can I get more information?
Contact us at:
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400
Shakopee, MN 55379;
Call us at (877) 297-6937;
Send us an email message at claims@cpsww.com.
4
PRODUCT REGISTRATION
Prompt product registration assures coverage under the limited
warranty, and also allows the opportunity of notifications for
product enhancements, upgrades, and other announcements.
Registration is quick and easy. Go to the Product Registration
Page at CyberPowerSystems.com/registration.
CONTACT INFORMATION
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400
Shakopee, MN 55379
Toll-free: 1-877-297-6937 | CyberPowerSystems.com
WARNING: This product can expose you to chemicals including bisphenol A (BPA)
and styrene (ABS), which is known to the State of California to cause reproductive
harm and cancer. For more information, go to www.P65Warnings.ca.gov.
Please join CyberPower in caring for the environment by recycling.
This device is manufactured using environmentally-safe procedures in
compliance with the Restriction of Hazardous Substances (RoHS) directive.
UL Listed to U.S. and Canadian Safety Standards UL 1449. This product
is listed to applicable U.S. and Canadian safety standards by
Underwriters Laboratories Inc.
© 2019 Cyber Power Systems (USA), Inc. All rights reserved.
All other trademarks are the property of their respective owners.
CyberPowerSystems.com
K01-0000665-01
K01-0000723-01
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising