Cobra COBRA MARINE JUMPACK H2O - CJSXLH2O Portable Power and JumPack User manual
The Cobra COBRA MARINE JUMPACK H2O - CJSXLH2O is a portable, multipurpose power source designed to jumpstart your vehicle, or charge your devices. It features a built-in LED flashlight, a 12V accessory port, and a USB port for charging devices such as smartphones and tablets. The Jump Pack is easy to use, simply connect the clamps to your vehicle's battery and start your car. It also provides protection against reverse polarity, overcharging, and overheating. With its compact size and powerful performance, the Cobra COBRA MARINE JUMPACK H2O is a must-have for any car owner.
Advertisement
Advertisement
CJSXLH2O Quick Start Card Side 1
4.75”W x 3.5” H
CJSXLH2O
Starting a vehicle by connecting directly to the battery:
Tri-Color Status LED:
The Status LED will illuminate and the color will change if the following conditions are present:
Jump Start:
LED CONDITION
START
1.
For best results, make sure the JumPack is fully charged.
2.
Turn off all vehicle accessories.
3.
Connect the Jump Start Cable to the JumPack (the LED will
turn RED).
4.
Connect the RED clamp to the POSITIVE post of the battery.
5.
Connect the BLACK clamp to the NEGATIVE post of the battery.
6.
Check the Tricolor Status LED. When the LED is
GREEN the JumPack is ready to start the vehicle.
7.
Start the vehicle.
NOTE: If your vehicle does not start after 3 attempts, call a mechanic.
When the engine starts:
1.
Disconnect the Jump Start Cable from the JumPack and the vehicle battery.
2.
Leave the engine running for at least twenty minutes to allow the vehicle’s battery to recharge.
If the engine does not start:
• The LED may flash YELLOW. Wait for the LED to turn
GREEN and try again starting with step 6.
No LED
Red
Red FLASH and FLASH GREEN LIGHT BAR -
The JumPack internal battery is
Yellow
Yellow
Green
NOTE:
©2018 Cobra Electronics Corporation Part Number 480-1132-P Printed in China Version A
Connection not detected or the JumPack battery is depleted. Check the JumPack battery charge level and verify the connection of the Jump Start
Cable to the JumPack.
FLASH - Reverse polarity connection.
Reverse the clamps.
nearly depleted. Charge the JumPack.
FLASH - The JumPack is transferring charge to the vehicle’s battery.
Wait for the LED to turn GREEN.
SLOW FLASH - JumPack internal battery is too hot for a safe jump start attempt. Wait for the battery to cool down and the LED to turn GREEN.
The JumPack is ready to help start your vehicle.
The JumPack will make a clicking sound every 5 seconds. This is part of normal operation.
CJSXLH20 Quick Start Card Side 2
5.5”W x 4” H
CJSXLH2O
Starting a vehicle using the accessory 12V port inside the vehicle:
3 AMP USB
OUTPUT
CHARGE
INPUT
CAR CHARGER
OUTPUT
1.
For best results, make sure the JumPack is fully charged.
2.
Turn off all the vehicle accessories.
3.
Disconnect the JumPack Charge Adapter Cable from the
JumPack Car Charger Cable.
4.
Connect the Car Charger Cable to the JumPack
(the LED will turn RED).
5.
Turn the ignition switch to the Accessory position.
6.
Connect the plug to the 12 Volt accessory port of the vehicle
(once car charging begins, the LED will flash YELLOW).
8.
Wait for the LED to turn GREEN.
9.
Start the vehicle.
If the engine starts:
1.
Disconnect the Car Charger Cable from the 12V accessory port and from the JumPack.
2.
Leave the engine running for at least twenty minutes to allow the vehicle’s battery to recharge.
NOTE: The car charging will take up to 15 minutes. If your vehicle does not start with the inside the car method try to jump start with the direct-to-batery method.
Tri-Color Status LED:
The Status LED will illuminate and the color will change if the following conditions are present:
LED CONDITION
No LED
Red
Connection not detected or the JumPack battery is depleted. Check the JumPack battery charge level and verify the connection of the Car Charger
Cable to the JumPack.
Car charging failed. Check that the vehicle ignition switch is in Accessory position.
Red FLASH - The vehicle battery is too discharged for the
JumPack to charge it sufficiently. Try a jumpstart with the clamps and direct-to-battery method.
Red FLASH and FLASH GREEN LIGHT BAR -
The JumPack internal battery is nearly depleted. Charge the JumPack.
Yellow FLASH - The JumPack is charging the car battery.
Wait for the GREEN LED before attempting to
jumpstart.
Yellow
Green
FAST FLASH - Charging almost complete.
Try to start your vehicle.
NOTE: The JumPack will make a clicking sound every 5 seconds. This is part of normal operation.

Public link updated
The public link to your chat has been updated.
Advertisement