advertisement
▼
Scroll to page 2
of 8
www.hama.de Hama GmbH & Co KG Postfach 80 86651 Monheim/Germany Tel. + 49 (0) 90 91 / 5 02-0 Fax + 49 (0) 90 91 / 5 02-2 74 [email protected] www.hama.de 00050094-09.05 00050094 Laminator »LA02«, DIN A4 Laminator Laminateur l Laminator SICHERHEITSHINWEIS Lesen Sie alle Hinweise vor Benutzung der Maschine durch. Plazieren Sie das Kabel so, dass niemand darüber stolpern kann. Öffnen Sie nicht das Gehäuse. Benutzen Sie das Gerät nicht wenn es nass ist. Schalten Sie das Gerät aus und entfernen Sie den Stecker aus der Steckdose bei Nicht-Benutzung. Verdecken Sie nicht die Wärmeöffnung während der Benutzung. Berühren Sie nicht die Wärmeöffnungen während der Benutzung. Führen Sie keine Gegenstände in die Wärmeöffnungen ein. Benutzen Sie die Maschine nicht im Falle von Beschädigungen des Kabels, des Gehäuses oder der Fassung. Warten Sie bis die Folie abgekühlt ist, sie könnte heiß sein. Laminieren Sie keine Flüssigkeiten, Gelatine oder andere Feuchtstoffe die auslaufen können. BEDIENUNGSANLEITUNG Bevor Sie laminieren ist es empfehlenswert eine Testlaminierung durchzuführen, um sich mit dem Gerät vertraut zu machen und um sicher zu stellen, dass das Gerät ordnungsgemäß funktioniert. 1. Öffnen Sie das linke und rechte Gleitprofile an der Rückseite des Gerätes und vergewissern Sie sich, dass beide Gleitprofile fest in ihrer Verankerung sitzen und nicht die Laminierfolie blockieren. 2. Entfernen Sie alle Verpackungseinheiten und stecken Sie den Stecker in die geeignete Steckdose. 3. Das Gerät erreicht die richtige Temperatur in ungefähr 3 Minuten. 4. Wenn das Signalfeld “ready” leuchtet, führen Sie die Laminierfolie mittig und mit der versiegelten Seite zuerst an der Vorderseite des Gerätes ein. Sie brauchen keinen Laminierträger 5. Die Folie fährt automatisch durch das Gerät. Entfernen Sie die Folie erst, wenn die Laminierung beendet wurde (Folie ist vollständig durchgelaufen). 6. Schalten Sie das Gerät aus und entfernen Sie den Stecker aus der Steckdose, wenn das Gerät nicht in Gebrauch ist. GARANTIE Die Garantiezeit des Gerätes beträgt 2 Jahre (die Garantie beinhaltet nicht durch falsche Einführung der Folien und unsachgemäße Benutzung des Gerätes hervorgerufene Schäden). TECHNISCHE INFORMATIONEN Volt Strom Verbrauch Max. Laminierbreite Max. Laminierstärke Max. Laminierstärke Abmessungen Gewicht 220-240V 300W 230mm/9’’ 2x80mic 0,6 mm 34,5 x 12 x 10,5 cm 1,3 kg L Laminating Machine SAFETY NOTICE Read all instructions before use. Do not leave cable where others may trip. Do not attempt to open casing. Do not use if wet. Switch off and unplug when not in use. Do not cover the heat vents when in use. Do not touch the heat vents when the machine is working. Do not put any items through the heat vents. Do not use if machine, cable, or socket is damaged. Wait for pouches to cool before handling, they may be hot. Do not laminate objects that contain liquids, gels or moisture that could escape. OPERATING INSTRUCTIONS Before laminating it is advisable to carry out a test lamination to familiarise yourself and to make sure that your machine is working correctly. 1. Open pouch supports on the back of the machine, making sure that they are pressed down in to their housings and are not blocking the exit. 2. Remove all packaging and plug the machine into an appropriate socket. 3. The machine will reach the correct temperature in approx 3mins. 4. When the ready light is on, insert the laminating pouch squarely and centrally (with the sealed side first) into the front of the laminator. (You do not need to use a pouch carrier). 5. The pouch will automatically pass through the machine. Remove pouch only when lamination is complete (pouch completely out). 6. Turn off and unplug the machine when not in use. WARRANTY The machine has a warranty of 2 years (the warranty is not applicable if the pouches has been inserted in the wrong position/direction, or the machines has been used for an inappropriate purpose). TECHNICAL DATA Voltage Power consumption Max laminating width Max laminating pouch thickness Maximum laminating thickness pouch + contents Dimension Weight 220-240V 300W 230mm/9’’ 2x80mic 0.6mm 34,5 x 12 x 10,5 cm 1,3 KGS ¬ Laminateur CONSIGNES DE SECURITE Lire attentivement les consignes avant utilisation. Ne pas brancher avec plusieurs fils électriques. Ne pas tenter d’ouvrir le boîtier. Ne pas utiliser dans un environnement humide. Eteindre et débrancher la machine lorsque qu’elle n’est pas utilisée. Ne pas couvrir ni toucher la ventilation lorsque la machine fonctionne. Ne pas insérer d’objet dans la ventilation. Ne pas utiliser la machine, le fil électrique, ou la prise de courant, si ceux-ci sont endommagés. Attendre que les documents plastifiés refroidissent avant de les manipuler, ils peuvent être chauds. Ne pas plastifier les objets humides, ou contenant du liquide ou du gel. CONSIGNES D’UTILISATION Avant de plastifier, il est recommandé de faire un essai pour se familiariser avec la machine et pour s’assurer que celle-ci fonctionne correctement. 1. Retirer l’emballage et branchez la machine sur une prise de courant adéquate. 2. Sortir les languettes à l’arrière de la machine et s’assurer qu’elles sont bien placées dans leur logement et ne bloquent pas la sortie. 3. La machine atteindra la température idéale en approximativement 3 minutes. 4. Lorsque le témoin lumineux s’allume, insérer la pochette de plastification de manière centrée (côté fermé en premier). (Il n’est pas nécessaire d’utiliser un transporteur de pochettes). 5. La pochette passera automatiquement à travers la machine. La retirer uniquement lorsque la plastification est terminée (elle doit être complètement sortie de la machine). 6. Eteindre et débrancher la machine lorsqu’elle n’est pas utilisée. GARANTIE La machine est garantie 2 ans (la garantie ne s’applique pas en cas de mauvaise insertion des pochettes ou si la machine a été utilisée de manière inappropriée). DONNEES TECHNIQUES Voltage Consommation Largeur maximum de plastification Epaisseur maximum des pochettes de plastification Epaisseur maximum de plastification (pochette+contenu) Dimension Poids 220-240V 300W 230mm/9’’ 2x80mic 0.6mm 34, 5 x 12 x 10,5 cm 1,3 KGS
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project