SPT 40039 Door Handles (Set of 2) for WC-2461H Installation Instructions

INSTRUCTION

How to install the door handles?

1. Tool required: Phillip screwdriver 2. Locate the handles. They are tied on the backside of the wine cooler. 3. Open the doors and locate the door seal 4. Pull the door seal to expose two screw holes for the door handle (

DO NOT

remove the entire door seal). 5. Position the door handle and screw both screws from the other side. Do not over tighten the screws. 6. Push the seal back in position. Test if the seal is installed properly by closing and opening the door. You should feel a bit of suction when you open the door. 7. Please contact us at 1-800-330-0388 or [email protected]

if any question. Handle Screw hole Handle Screw hole Handle Screw hole Handle Screw hole