Metra TE-AJPKT Jeep Camera Instructions

TE-AJPKT Manual
1. Box Contents
Camera and wiring
Bracket
2 Push nuts
• Applications
2007-2018* Jeep Wrangler (* 2018 JK trim only)
• Installation of camera
• Run camera wire through stem of bracket, DO NOT pop the camera
into the bracket before confirming visual on monitor.
• Connect the RED wire to a 12V reverse trigger.
• Connect the BLACK wire to a chassis ground.
• If reverse signal is needed in the front of vehicle, RED wire with RCA
will provide that signal from the red wire in the rear of the vehicle.
• If parking lines are needed, please cut the white loop on the harness.
4. Wiring diagram
22 ft
2 ft
5. Specifications
Sensor
Resolution
Field of view
Illumination
IP rating
Parking Lines
Extension cable
TV system
Working Temp
Warranty
CMOS 7080
480 TV Lines
Diagonal 170º, Horizontal 110º, Vertical 90º
0.6 Lux
IP67
Defeatable (white loop on harness)
26’
NTSC
-20ºC ~ 70ºC
3 years
IMPORTANT
If you are having difficulties with the installation of this product, please call out
Tech Support line at 386-257-1187. Before doing so, looks over the instructions a
second time, and make sure the installation was performed exactly as the
instructions are stated. Please have the vehicle apart and ready to perform
troubleshooting steps before calling.
386-257-1187
REV. 02/21/2020