Generac 15kW RD01523JDAE Standby Generator Manual

Generac 15kW RD01523JDAE Standby Generator Manual
4
REMOVE PANEL TO ALLOW
TANK VENTS TO TERMINATE OUTSIDE
OF THE GENERATOR ENCLOSURE
(CHECK LOCAL AND
STATE CODE FOR APPLICABILITY)
SH
3
879 [34.6]
CENTER OF GRAVITY
(SEE NOTE 5)
580 [22.8]
212
[8.3]
2.3L
REV
A
WINDCHILL VERSION
WEIGHT DATA WITH EMPTY BASETANK
(SEE NOTE 5)
OIL FILL CAP
RIGHT SIDE
RIGHT SIDE
GENERATOR AS SHOWN
626 [1380]
OIL FILTER
RIGHT SIDE
WITH WODDEN SHIPPING SKID
665 [1465]
OIL DRAIN HOSE
RIGHT SIDE
RADIATOR DRAIN HOSE
LEFT SIDE
COOLANT RECOVERY BOTTLE
LEFT SIDE
RADIATOR FILL CAP ACCESS
ROOF TOP
AIR CLEANER ELEMENT
EITHER SIDE
MUFFLER
FRONT
FAN BELT
EITHER SIDE
BATTERY
LEFT SIDE
WEIGHT: KG [LBS]
DIMENSIONS: MM [INCH]
REFERENCE OWNERS MANUAL FOR PERIODIC
REPLACEMENT PART LISTINGS.
B
2" O.D. EXHAUST
OUTLET
INTERNAL DIVIDER PANEL
SEPARATES FUEL TANK VENTILATION
DUCT FROM THE ENGINE,
ALTERNATOR AND EXHAUST SYSTEM.
RADIATOR/EXHAUST
DISCHARGE AIR
REMOVE COVER
FOR ACCESS TO
RADIATOR FILL CAP
TOP VIEW
BATTERY 12 VOLT
NEGATIVE GROUND
P/N: 058665
A.1
1
NOTES:
OIL DIP STICK
AIR INTAKE
(BOTH SIDES)
RADIATOR/EXHAUST
DISCHARGE AIR
(BOTH SIDES)
SERVICE ITEM
1/2
1. MINIMUM RECOMMENDED CONCRETE PAD SIZE: 1092 (43") WIDE X 2355 (93") LONG.
REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT FOR CONCRETE PAD GUIDELINES.
2. ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE
AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT
APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL,
STATE, AND LOCAL CODES.
3. CONTROL PANEL / CIRCUIT BREAKER INFORMATION:
- SEE SPECIFICATION SHEET OR OWNERS MANUAL
- ACCESSIBLE THROUGH CUSTOMER ACCESS ASSEMBLY DOOR ON REAR OF GENERATOR.
4. REMOVE THE REAR STUB-UP AND REAR ENCLOSURE COVER PANEL TO ACCESS
THE STUB-UP AREAS AS FOLLOWS:
- HIGH VOLTAGE CONNECTION INCLUDING AC LOAD LEAD CONDUIT CONNECTION,
NEUTRAL CONNECTION, AND BATTERY CHARGER 120 VOLT AC (0.5 AMP MAX) CONNECTION.
- LOW VOLTAGE CONNECTION INCLUDING TRANSFER SWITCH CONTROL WIRES
AND ACCESSORY RELAY CONNECTION (QTY 4)
5. CENTER OF GRAVITY AND WEIGHT MAY CHANGE DUE TO UNIT OPTIONS.
6. BOTTOM OF GENERATOR SET MUST BE ENCLOSED TO PREVENT PEST INTRUSION AND
RECIRCULATION OF DISCHARGE AIR AND/OR IMPROPER COOLING AIR FLOW.
7. EXHAUST SYSTEM MAXIMUM BACK PRESSURE: 24 INCHES H2O.
8. REFERENCE OWNERS MANUAL FOR LIFTING WARNINGS.
9. MOUNTING BOLTS OR STUDS TO MOUNTING SURFACE SHALL BE 5/8-11 GRADE 5
(USE STANDARD SAE TORQUE SPECS)
10. MUST ALLOW FREE FLOW OF INTAKE AIR, DISCHARGE AIR AND EXHAUST. SEE SPEC
SHEET FOR MINIMUM AIR FLOW RESTRICTION REQUIREMENTS.
11. GENERATOR MUST BE INSTALLED SUCH THAT FRESH COOLING AIR IS AVAILABLE
AND THAT DISCHARGE AIR FROM RADIATOR IS NOT RECIRCULATED.
VISE ACTION LATCH,
ONE PER DOOR, ONE LIFT-OFF
DOOR ON FRONT, RIGHT, AND LEFT SIDES
630 [24.8]
SIDE DOOR TYP
B
LIFT OFF DOOR PROVIDES ACCESS TO:
FUEL FILL, FUEL LEVEL GAUGE,
NORMAL VENT, INNER TANK EMERGENCY
VENT, OUTER TANK EMERGENCY VENT,
OPTIONAL 90% ALARM ASSEMBLY,
OPTIONAL 5 GALLON SPILL BOX
REAR ENCLOSURE
COVER PANEL
SEE NOTE 4
CIRCUIT BREAKER
SEE NOTE 3
1276
[50.2]
OVERALL
HEIGHT
CUSTOMER ACCESS
ASSEMBLY. CONTROL
PANEL ACCESS.
BATTERY CHARGER
LOCATED WITHIN
SEE NOTE 4
342
[13.5]
REMOVABLE STUB-UP COVER
SEE NOTE 4
FUEL TANK
VENTILATION DUCT
A
LEFT SIDE VIEW
EXHAUST MUFFLER ENCLOSED WITHIN
GENERATOR ENCLOSURE
OPEN PUNCHED LOUVERS TYPICAL
ON BOTH SIDES OF
FUEL TANK VENTILATION
DUCT TO PROVIDE ADEQUATE
CROSS-FLOW OF AIR VENTILATION
776 [30.6]
OVERALL VIEW
REAR VIEW
177
[7.0]
2052 [80.8]
OVERALL LENGTH
LIFTING PROVISION (4 PLACES)
SEE NOTES 5, 8 AND
CENTER OF GRAVITY
DIMENSIONS
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
3
2
A
RIGHT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
4
1525 [60.0]
INSTALL PROTECTOR D2.3L G16
EXT TANK
ISSUE DATE: 06/2014
SIZE
B
SCALE
CAGE NO
DWG NO
N/A
0.050
WT-KG
0K7025
SEE ABOVE SHEET
1
REV
1 of 2
A
4
SH
3
2/2
REV
A
WINDCHILL VERSION
A.1
1
1722 [67.8]
1632 [64.2]
HIGH AND LOW
VOLTAGE
STUB-UP AREA
1249 [49.2]
OUTER TANK
LEAK DETECTOR
907 [35.7]
357 [14.0]
233 [9.2]
107 [4.2]
CIRCUIT BREAKER
NEUTRAL AND CUSTOMER
CONNECTION OPENING
CUSTOMER OPTION
(2"NPT FEMALE)
FUEL
SUPPLY
FUEL
RETURN
INNER TANK NORMAL VENT
(2"NPT FEMALE)
FUEL TANK
TOTAL CAPACITY
127 [33.5]
USABLE CAPACITY
121 [32]
CAPACITY: LITER [GALLON]
DIMENSIONS: MM [INCH]
OUTER TANK
EMERGENCY VENT
(2"NPT FEMALE)
TANK IS LISTED TO UL142 AND ULC/ORD-C142.18
B
B
624
[24.6]
TYP
574
[22.6]
TYP
464
[18.3]
105
[4.1]
639
[25.2]
559
[22.0]
674
[26.5]
STUB-UP
AREA
292
[11.5]
213
[8.4]
269
[10.6]
FUEL FILL
(2" NPT FEMALE)
INNER TANK EMERGENCY VENT
(2"NPT FEMALE)
FUEL LEVEL
GAUGE/SENDER
19
[.7]
9
[.4]
100
[3.9]
1838 [72.4]
51
[2.0]
169
[6.7]
STUB-UP
AREA
TOP VIEW
738 [29.1]
REMOVABLE STUB-UP COVER
SEE NOTE 4 ON
SHEET 1 OF 2
393
[15.5]
290 [11.4]
FUEL TANK HT.
110 TYP
[4.3]
A
19
[.7]
739 [29.1] TYP
739 [29.1]
MOUNTING CENTERS
16.66 [.66]
MOUNTING HOLES
8X
776 [30.6]
1368 [53.9] TYP
A
REAR VIEW
1950 [76.8] TYP
2052 [80.8]
LEFT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
INSTALL STUB-UP VIEW PROTECTOR D2.3L
EXTENDED TANK
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
3
2
ISSUE DATE: 06/2014
SIZE
B
SCALE
CAGE NO
DWG NO
N/A
0.075
WT-KG
0K7025
SEE SHEET 1 SHEET
1
REV
2 of 2
A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement