Generac 24kVA 0069500 Standby Generator Manual

Generac 24kVA 0069500 Standby Generator Manual
4
SH
3
RADIATOR/EXHAUST
DISCHARGE AIR
(BOTH SIDES)
892 [35.1]
CENTER OF GRAVITY
SEE NOTE 5
REMOVE COVER
FOR ACCESS TO
RADIATOR FILL CAP
AIR INTAKE
(BOTH SIDES)
SERVICE ITEM
3.4L
1/2
REV
A
WINDCHILL VERSION
WEIGHT DATA WITH EMPTY BASETANK
(SEE NOTE 5)
OIL FILL CAP
RIGHT SIDE
OIL DIP STICK
RIGHT SIDE
GENERATOR AS SHOWN (STEEL ENCL)
886 [1953]
OIL FILTER
RIGHT SIDE
WITH WOODEN SHIPPING SKID
925 [2039]
OIL DRAIN HOSE
RIGHT SIDE
RADIATOR DRAIN HOSE
LEFT SIDE
AIR CLEANER ELEMENT
RIGHT SIDE
MUFFLER
FRONT
FAN BELT
EITHER SIDE
BATTERY
LEFT SIDE
REFERENCE OWNERS MANUAL FOR PERIODIC
REPLACEMENT PART LISTINGS.
B
TOP VIEW
173 [6.8]
A.4
1
NOTES:
1. MINIMUM RECOMMENDED CONCRETE PAD SIZE: 1194 (47") WIDE X 2261
(89") LONG. REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT
FOR CONCRETE PAD GUIDELINES
2. ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE
AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT
APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL,
STATE AND LOCAL CODES.
3. CONTROL PANEL / CIRCUIT BREAKER INFORMATION:
- SEE SPECIFICATION SHEET OR OWNERS MANUEL
- ACCESSIBLE THROUGH CUSTOMER ACCESS ASSEMBLY DOOR ON REAR OF GENERATOR
4. REMOVE THE REAR TANK AND REAR ENCLOSURE COVER PANEL TO ACCESS THE
STUB-UP AREAS AS FOLLOWS:
-HIGH VOLTAGE CONNECTION INCLUDING AC LOAD LEAD CONDUIT CONNECTION
NEUTRAL CONNECTION, BATTERY CHARGER 120 VOLT AC (0.5 AMP MAX) CONNECTION.
-LOW VOLTAGE CONNECTIONS INCLUDE TRANSFER SWITCH CONTROL WIRES
5. CENTER OF GRAVITY AND WEIGHT MAY CHANGE DUE TO UNIT OPTIONS.
6. ENGINE SERVICE CONNECTIONS
OIL DRAIN: 3/8" NPT
EXHAUST OUTLET: 2" O.D.
7. BOTTOM OF GENERATOR SET MUST BE ENCLOSED TO PREVENT PEST INTRUSION AND
RECIRCULATION OF DISCHARGE AIR AND/OR IMPROPER COOLING AIR FLOW.
8. EXHAUST SYSTEM MAXIMUM BACK PRESSURE: 35 INCHES H20.
9. REFERNCE OWNERS MANUAL FOR LIFTING WARNINGS.
10. MOUNTING BOLTS OR STUDS TO CONCRETE PAD SHALL BE 5/8-11 GRADE 5
BATTERY 12 VOLT
NEGATIVE GROUND
146 [5.8]
UNITS: WEIGHT - KG [LBS]
DIMENSION - MM [INCH]
RADIATOR/EXHAUST
DISCHARGE AIR
758 [29.8]
DOOR TYP
B
VISE ACTION LATCH,
ONE PER DOOR, ONE LIFT-OFF
DOOR PER SIDE OF GENERATOR
REAR ENCLOSURE COVER
PANEL
SEE NOTE 4
CIRCUIT BREAKER
SEE NOTE 3
CUSTOMER ACCESS
ASSEMBLY, CONTROL PANEL
ACCESS, BATTERY CHARGER
LOCATED WITHIN
SEE NOTE 4
A
LIFTING PROVISIONS
(4 PLACES)
SEE NOTE 10 AND CENTER
OF GRAVITY DIMENSIONS
1408
[55.4]
OVERALL
HEIGHT
302
[11.9]
REAR TANK COVER
SEE NOTE 4
FRONT TANK
COVER
EXHAUST MUFFLER ENCLOSED WITHIN
GENERATOR ENCLOSURE
888 [35.0]
OVERALL WIDTH
LEFT SIDE VIEW
182
[7.2]
REAR VIEW
RIGHT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
INSTALL CPL PROT D3.4L SW
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
A
1322 [52.0]
1954 [76.9]
OVERALL LENGTH
3
2
ISSUE DATE:
SIZE
CAGE NO
SCALE
0.050
B
DWG NO
WT-KG
0K6968A
SEE ABOVE SHEET
1
REV
1 of 2
A
4
SH
3
1194 [47.0]
1044 [41.1]
2/2
REV
A
WINDCHILL VERSION
A.4
1
FUEL LEVEL
GAUGE/SENDER
FUEL FILL
(2" NPT FEMALE)
FUEL TANK
TOTAL CAPACITY
INNER TANK NORMAL VENT
(2" NPT FEMALE)
923 [36.4] TYP
CAPACITY: LITER [GALLONS]
DIMENSIONS: MM [INCH]
INNER TANK EMERGENCY VENT
(2" NPT FEMALE)
828 [32.6] TYP
253.6 [67]
USABLE CAPACITY 230.9 [61]
HIGH AND LOW
VOLTAGE STUB-UP
B
B
CIRCUIT BREAKER,
NEUTRAL AND CUSTOMER
CONNECTION OPENING
757 [29.8]
TYP
786 [30.9]
STUB-UP
AREA
621 [24.5]
TYP
267 [10.5]
TYP 181 [7.1]
125 [4.9]
TYP
51 [2.0]
FUEL SUPPLY
FUEL RETURN
38 [1.5]
1431 [56.3]
112 [4.4]
1554 [61.2]
1764 [69.4]
187 [7.3]
STUB-UP
AREA
REMOVABLE STUB-UP
COVER
REMOVABLE COVER
353 [13.9]
16.7 [.66] MOUNTING HOLES
(8 PLACES)
A
112 [4.4] TYP
712 [28.0] TYP
A
851 [33.5] TYP
888 [35.0]
1242 [48.9] TYP
1842 [72.5] TYP
1954 [76.9]
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
INSTALL CPL PROT D3.4L SW
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
3
2
ISSUE DATE:
SIZE
CAGE NO
SCALE
0.075
B
DWG NO
WT-KG
0K6968A
SEE ABOVE SHEET
1
REV
2 of 2
A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement