Generac 30kW RD03022ADAS Standby Generator Manual

Generac 30kW RD03022ADAS Standby Generator Manual
4
SH
3
874 [34.4]
CENTER OF GRAVITY
SERVICE ITEM
2.2L
OIL FILL CAP
RIGHT SIDE
OIL DIP STICK
RIGHT SIDE
OIL FILTER
RADIATOR/EXHAUST
DISCHARGE AIR
(BOTH SIDES)
AIR INTAKE
(BOTH SIDES)
1/2
REV
A
WINDCHILL VERSION
WEIGHT DATA WITH EMPTY BASETANK
(SEE NOTE 5)
GENERATOR AS SHOWN 783 [1726]
RIGHT SIDE WITH WOODEN SHIPPING SKID 819 [1806]
OIL DRAIN HOSE
RIGHT SIDE
RADIATOR DRAIN HOSE
LEFT SIDE
COOLANT RECOVERY BOTTLE
LEFT SIDE
RADIATOR FILL CAP ACCESS
ROOF
AIR CLEANER ELEMENT
RIGHT SIDE
MUFFLER
FRONT SIDE
FAN BELT
EITHER SIDE
BATTERY
LEFT SIDE
WEIGHT: KG [LBS]
DIMENSIONS: MM [INCH]
REFERENCE OWNERS MANUAL FOR
PERIODIC REPLACEMENT PART LISTINGS
B
173 [6.8]
EXHAUST
OUTLET
146 [5.8]
EXHAUST
OUTLET
REMOVE COVER FOR
ACCESS TO RADIATOR
FILL CAP
A.4
BATTERY 12 VOLT
NEGATIVE GROUND
1
NOTES:
1. MINIMUM RECOMMENDED CONCRETE PAD SIZE: 1194 (47") WIDE X 2261 (89") LONG.
REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT
FOR CONCRETE PAD GUIDELINES
2. ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE
AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT
APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL,
STATE, AND LOCAL CODES.
3. CONTROL PANEL / CIRCUIT BREAKER INFORMATION:
- SEE SPECIFICATION SHEET OR OWNERS MANUAL
- ACCESSIBLE THROUGH CUSTOMER ACCESS ASSEMBLY DOOR ON REAR OF
GENERATOR
4. REMOVE THE REAR TANK AND REAR ENCLOSURE COVER PANEL TO ACCESS
THE STUB-UP AREAS AS FOLLOWS:
- HIGH VOLTAGE CONNECTION INCLUDING AC LOAD LEAD CONDUIT CONNECTION
NEUTRAL CONNECTION, BATTERY CHARGER 120 VOLT AC (0.5 AMP MAX) CONNECTION.
- LOW VOLTAGE CONNECTIONS INCLUDING TRANSFER SWITCH CONTROL WIRES
5. CENTER OF GRAVITY AND WEIGHT MAY CHANGE DUE TO UNIT OPTIONS.
6. ENGINE SERVICE CONNECTIONS
OIL DRAIN: 3/8" NPT
EXHAUST OUTLET: 2" O.D.
7. BOTTOM OF GENERATOR SET MUST BE ENCLOSED TO PREVENT PEST INTRUSION AND
AND RECIRCULATION OF DISCHARGE AIR AND/OR IMPROPER COOLING AIR FLOW.
8. REFERENCE OWNERS MANUAL FOR LIFTING WARNINGS.
9. MOUNTING BOLTS OR STUDS TO CONCRETE PAD SHALL BE 5/8-11 GRADE 5
(USE STANDARD SAE TORQUE SPECS)
B
TOP VIEW
RADIATOR/EXHAUST
DISCHARGE AIR
897 [35.3]
DOOR WIDTH
TYP
REAR ENCLOSURE
COVER PANEL
SEE NOTE 4
CUSTOMER ACCESS
ASSEMBLY, CONTROL
PANEL ACCESS,
BATTERY CHARGER
LOCATED WITHIN,
SEE NOTE 4
OPEN PUNCHED LOUVERS
TYPICAL ON BOTH SIDES OF
FUEL TANK VENTILATION
DUCT TO PROVIDE ADEQUATE
CROSS-FLOW OF AIR
VENTILATION
1452 [57.2]
OVERALL
HEIGHT
CIRCUIT BREAKER
SEE NOTE 3
EXHAUST MUFFLER
ENCLOSED WITHIN
GENERATOR ENCLOSURE
324 [12.7]
TYP
REMOVABLE
STUB-UP COVER
SEE NOTE 4
182 [7.2]
TYP
888 [35.0]
OVERALL WIDTH
A
VISE ACTION LATCH, ONE PER
DOOR, ONE LIFT-OFF DOOR
PER SIDE OF GENERATOR
LEFT SIDE VIEW
1954 [76.9]
OVERALL LENGTH
LIFTING PROVISION (4 PLACES)
SEE NOTES 5, 8 AND CENTER
OF GRAVITY DIMENSIONS
REAR VIEW
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
3
2
A
RIGHT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
4
1322 [52.0]
TYP
INSTALL PROTECTOR D2.2L G22
SINGLE WALL TANK
ISSUE DATE:
SIZE
B
SCALE
07/2017
CAGE NO
DWG NO
N/A
0.050
WT-KG
10000018294
SEE ABOVE SHEET
1
REV
1 of 2
A
4
SH
3
2/2
REV
A
WINDCHILL VERSION
A.4
1
1196 [47.1]
1045 [41.2]
926 [36.5]
TYP
844 [33.2]
TYP
FUEL SUPPLY
FUEL FILL
(2" NPT FEMALE)
FUEL LEVEL
GAUGE/SENDER
FUEL RETURN
FUEL TANK
B
267 [10.5]
TYP
230.9 [61]
B
*NOTE: STUB-UP AREA FOR HIGH
AND LOW VOLTAGE CONNECTIONS,
CIRCUIT BREAKER, NEUTRAL AND
CUSTOMER CONNECTION OPENING.
125 [4.9]
STUB-UP
AREA
621 [24.5]
TYP
253.6 [67]
USABLE CAPACITY
CAPACITY: LITER [GALLONS]
DIMENSIONS: MM [INCH]
HIGH AND LOW
VOLTAGE STUB-UP
AREA
786 [30.9]
757 [29.8]
TYP
TOTAL CAPACITY
181 [7.1]
TYP
NORMAL VENT
(2" NPT FEMALE)
1430 [56.3]
51
[2.0]
38
[1.5]
EMERGENCY VENT
(2" NPT FEMALE)
1555 [61.2]
62 [2.5]
1690 [66.5]
253
[10.0]
TOP VIEW
125 [4.9]
STUB-UP
AREA
850 [33.5]
REMOVABLE
STUB-UP COVER
SEE NOTE 4
REMOVABLE COVER
397 [15.6]
250 [9.9]
FUEL TANK
HEIGHT
112 [4.4]
TYP
A
712 [28.0]
TYP
16.7 [0.66]
MOUNTING HOLES
(8 PLACES) SEE
NOTE 9
19 [.7]
TYP
851 [33.5]
MOUNTING CENTERS
TYP
888 [35.0]
1242 [48.9]
TYP
A
REAR VIEW
1842 [72.5]
TYP
1954 [76.9]
LEFT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
3
2
INSTALL PROTECTOR D2.2L G22
SINGLE WALL TANK
ISSUE DATE:
SIZE
B
SCALE
07/2017
CAGE NO
DWG NO
N/A
0.075
WT-KG
10000018294
SEE ABOVE SHEET
1
REV
2 of 2
A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement