Generac 50kW RD05034GDSS Standby Generator Manual

Generac 50kW RD05034GDSS Standby Generator Manual
4
SH
3
NOTES:
B
1. MINIMUM RECOMMENDED CONCRETE PAD SIZE: 1092 (43") WIDE X 1887 (74.3") LONG.
REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT FOR CONCRETE PAD GUIDELINES.
2. ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE
AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT
APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL,
STATE, AND LOCAL CODES.
3. CONTROL PANEL / CIRCUIT BREAKER INFORMATION:
- SEE SPECIFICATION SHEET OR OWNERS MANUAL
- ACCESSIBLE THROUGH CUSTOMER ACCESS ASSEMBLY DOOR ON REAR OF GENERATOR.
4. REMOVE THE REAR TANK AND REAR ENCLOSURE COVER PANEL TO ACCESS
THE STUB-UP AREAS AS FOLLOWS:
- HIGH VOLTAGE CONNECTION INCLUDING AC LOAD LEAD CONDUIT CONNECTION
NEUTRAL CONNECTION, BATTERY CHARGER 120 VOLT AC (0.5 AMP MAX) CONNECTION.
- LOW VOLTAGE CONNECTION INCLUDING TRANSFER SWITCH CONTROL WIRES
AND ACCESSORY RELAY CONNECTION (QTY 4)
5. CENTER OF GRAVITY AND WEIGHT MAY CHANGE DUE TO UNIT OPTIONS.
6. BOTTOM OF GENERATOR SET MUST BE ENCLOSED TO PREVENT PEST INTRUSION AND
RECIRCULATION OF DISCHARGE AIR AND/OR IMPROPER COOLING AIR FLOW.
7. EXHAUST SYSTEM MAXIMUM BACK PRESSURE: 24 INCHES H2O.
8. REFERENCE OWNERS MANUAL FOR LIFTING WARNINGS.
9. MOUNTING BOLTS OR STUDS TO MOUNTING SURFACE SHALL BE 5/8-11 GRADE 5
(USE STANDARD SAE TORQUE SPECS)
1/2
REV
WINDCHILL VERSION
SERVICE ITEM
2.3L
OIL FILL CAP
RIGHT SIDE
OIL DIP STICK
RIGHT SIDE
GENERATOR AS SHOWN (STEEL ENCL)
581 [1281]
OIL FILTER
RIGHT SIDE
WITH WODDEN SHIPPING SKID
621 [1369]
OIL DRAIN HOSE
RIGHT SIDE
RADIATOR DRAIN HOSE
LEFT SIDE
AIR CLEANER ELEMENT EITHER SIDE
MUFFLER
FRONT
FAN BELT
EITHER SIDE
BATTERY
LEFT SIDE
1
WEIGHT DATA WITH EMPTY BASETANK
(SEE NOTE 5)
735 [28.9]
CENTER OF GRAVITY
(SEE NOTE 5)
WEIGHT: KG [LBS]
DIMENSIONS: MM [INCH]
2" O.D. EXHAUST
OUTLET
RADIATOR/EXHAUST
DISCHARGE AIR
(BOTH SIDES)
AIR INTAKE
(BOTH SIDES)
REFERENCE OWNERS MANUAL FOR PERIODIC
REPLACEMENT PART LISTINGS.
B
212
[8.3]
REMOVE COVER
FOR ACCESS TO
RADIATOR FILL CAP
111
[4.4]
BATTERY 12 VOLT
NEGATIVE GROUND
TOP VIEW
VISE ACTION LATCH,
ONE PER DOOR, ONE LIFT-OFF
DOOR PER SIDE OF GENERATOR
RADIATOR/EXHAUST
DISCHARGE AIR
ENCLOSURE PANEL MUST
BE REMOVED TO FACILITATE
BATTERY INSTALLATION AND REMOVAL
630 [24.8]
DOOR TYP
REAR ENCLOSURE COVER
PANEL
SEE NOTE 4
CIRCUIT BREAKER
SEE NOTE 3
1236
[48.7]
OVERALL
HEIGHT
CUSTOMER ACCESS
ASSEMBLY, CONTROL PANEL
ACCESS, BATTERY CHARGER
LOCATED WITHIN
SEE NOTE 4
RADIATOR/EXHAUST
DISCHARGE AIR
REAR TANK COVER
SEE NOTE 4
358
[14.1]
102
[4.0]
1380 [54.3]
1582 [62.3]
OVERALL LENGTH
A
RIGHT SIDE VIEW
EXHAUST MUFFLER ENCLOSED WITHIN
GENERATOR ENCLOSURE
776 [30.6]
OVERALL WIDTH
LIFTING PROVISION (4 PLACES)
SEE NOTE 5, 8 & CENTER OF GRAVITY DIMENSIONS
FRONT VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
INSTALL PROTECTOR D2.3L G16 SW
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
A
LEFT SIDE VIEW
3
2
ISSUE DATE:
SIZE
B
SCALE
1/2014
CAGE NO
DWG NO
N/A
0.050
WT-KG
0K4894A
SEE ABOVE SHEET
1
REV
1 of 2
4
SH
3
2/2
REV
WINDCHILL VERSION
1
FUEL FILL
(2" NPT FEMALE)
1109 [43.7]
FUEL LEVEL
GAUGE/SENDER
997 [39.3]
841 [33.1]
FUEL SUPPLY
776 [30.6]
FUEL TANK
EMERGENCY TANK VENT
(2' NPT FEMALE)
684 [26.9]
NORMAL TANK VENT
(2" NPT FEMALE)
436 [17.2]
TOTAL CAPACITY
169 [44]
USABLE CAPACITY
151 [40]
CAPACITY: LITER [GALLONS]
DIMENSIONS: MM [INCH]
HIGH AND LOW
VOLTAGE STUB-UP
B
B
FUEL RETURN
CIRCUIT BREAKER,
NEUTRAL AND CUSTOMER
CONNECTION OPENING
625
[24.6]
TYP
674 [26.5]
STUB-UP
AREA
105 [4.1]
41 [1.6]
16.7 [.66] MOUNTING HOLES
(6 PLACES)
11 [.4]
51 [2.0]
100 [3.9]
1346 [53.0]
191 [7.5]
STUB-UP
AREA
TOP VIEW
738 [29.1]
REMOVABLE
STUB-UP COVER
456 [18.0]
100 [3.9]
TYP
739 [29.1]
MOUNTING CENTERS
790 [31.1]
TYP
776 [30.6]
1480 [58.3]
TYP
A
A
REAR VIEW
1582 [62.3]
LEFT SIDE VIEW
TITLE
DRAWING CREATED FROM PRO/ENGINEER
3D FILE. ECO MODIFICATION TO BE
APPLIED TO SOLID MODEL ONLY.
INSTALL STUB-UP VIEW PROTECTOR D2.3L
SINGLE WALL TANK
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING
WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR
ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT
THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS.
c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
4
3
2
ISSUE DATE:
SIZE
CAGE NO
SCALE
0.075
B
1/2014
DWG NO
WT-KG
0K4894A
SEE SHEET 1 SHEET
1
REV
2 of 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement