Grizzly T23160 Replacement Blade Owner Manual

Grizzly T23160 Replacement Blade Owner Manual
Model G0490/G0490X
***IMPORTANT UPDATE***
Installation of Pulleys
& Ribbed V-Belt
(T21360 Kit)
Introduction
The grooved aluminum pulleys and ribbed V-belt
included with this jointer provide more efficient
power transfer, reduced vibration, and quieter
operation than standard belts.
To install the pulleys and V-belt, perform the
following installation procedure after completing Step 16 on Page 17 in the G0490/G0490X
owner's manual.
The cutterhead blade
edges are extremely sharp
and can quickly slice your
hands or fingers. Stay clear
of the cutterhead when
performing this procedure.
Installation
Tools Needed
Qty
Hex Wrench 3mm............................................... 1
Hex Wrench 6mm............................................... 1
Rubber Mallet..................................................... 1
Box Contents
A
To install the pulleys and V-belt:
1.
B
H
G
C
F
E
D
Perform the assembly steps as instructed in
the owner's manual through Step 16 on Page
17.
2.Slide the cutterhead shaft key into the keyway of the cutterhead shaft so that the flat
end of the key is facing out (see Figure 2 on
the next page for reference).
Figure 1. Box inventory.
Description
Qty
A. Ribbed V-Belt 8PK1172............................... 1
B. Cutterhead Pulley........................................ 1
C. Cutterhead Shaft Key 6 x 6 x 35mm........... 1
D. Cap Screw M8-1.25 x 25............................. 1
E. Fender Washer 8mm................................... 1
F. Set Screws M6-1 x 10................................. 2
G. Motor Shaft Key 5 x 5 x 25.......................... 1
H. Motor Pulley................................................. 1
Refer to Section: 9 in the owner's manual
for information of the parts listed in this
update.
Copyright © FEBRUARY, 2011 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape
or form without the written approval of Grizzly Industrial, inc.
#TS13766 printed in USA
3.
Align the internal keyway of the cutterhead
pulley with the shaft key, then slide the pulley
onto the shaft, as shown in Figure 2.
6.
Note: To fully seat the pulley, it may be necessary to lightly tap on it with a rubber mallet.
Align the internal keyway of the motor pulley with the shaft key, then slide the pulley
onto the shaft until the shaft is even with the
protruding face of the pulley, as shown in
Figure 3.
Set Screw
(1 of 2)
Shaft Key
& Keyway
Shaft Key
& Keyway
Cap Screw
& Flat Washer
Figure 2. Cutterhead pulley mounted on the
cutterhead shaft.
4.Secure the cutterhead pulley to the shaft with
the M8-1.25 x 25 cap screw and 8mm flat
washer.
Figure 3. Motor pulley installed.
7.Secure the motor pulley with the two M6-1 x
10 set screws.
8.
Continue the assembly with Step 17 on Page
18 of the owner's manual.
5.Slide the motor shaft key into the motor shaft
keyway so that the flat end of the key faces
out.
-2-
G0490/G0490X Manual Update
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement