POS Checklist – New Generation Gas FT or Postcode: Cooker details: Customer Name: Customer Address: Access and parking Route for delivery Questions Can the property be accessed by a 7.5 tonne lorry with a tail lift 2415mm (8ft 3in) wide? Are there any special permissions or permits req? Is there a clear route into the kitchen? The minimum gap needed is 750mm (30in) through doors and hallways. Please give details or any steps, gravel areas, grass areas, uneven surfaces, obstacles, tight turns. Is any floor protection needed? Is there any additional man power or equipment on site? Floor What flooring is under the cooker position? The cooker base must be level and flat and no lower than the finished floor. Please lay your flooring before the cooker is fitted or fit a suitable plinth to bring it level. The flooring must be capable of supporting the weight of the cooker. The cooker base dimensions, weights and clearances can be found on pages 22-24 of your installation instructions Position Will the cooker be positioned between base units? Will the cooker be positioned onto an empty wall? If so please ensure this is marked to enable us to correctly position the cooker. Will the cooker be going into an alcove or recessed area? If so electrical points cannot be located above or behind the cooker. They must be outside of the recess following the distances advised in our instructions. Y N Our shop will discuss this form with you while you are placing your order. If necessary you are welcome to take the form away and discuss the points raised with your contractors. If you take the form away with you, please return the completed copy to your Aga store at your earliest convenience. This will assist us with finalising your installation. Notes Position continued Is there space for a 3mm gap to be left each side of the cooker top plate? Is there space for a 60mm gap to be left above the lid handles to allow for opening? The cooker dimensions can be found between pages 23-24 of the installation instructions. Rear wall Rear wall What type of wall is behind the cooker? If the inner wall is plasterboard or another combustible material, fire board will need to be fitted behind the cooker. Please note pink fire resistant plasterboard is not suitable Details of this are found on page 22 of the installation instructions Is the rear wall clear of pipes, wires, drains and other services? There can be nothing directly above or behind the cooker position. How much gap do you need left behind the cooker position? We will leave a minimum 10mm gap between the cooker and the surface behind. If this is to be increased please inform us prior to delivery or advise the delivery team on the day. Worktop The cooker hotplate height is 913mm off the finished floor. Will your surrounding work surfaces match this height? The cooker dimensions can be found between pages 23-24 of the installation instructions. Electrics A 30amp supply is required which cannot be above or behind the cooker position Details of this are found on page 26 of the installation instructions. Flue system (CF only) This should be completed by a flue specialist prior to the Aga being installed. We will need the flue to be signed off and a data plate completed by the flue specialist. Details of the required flue system are on page 4 of the attached installation instructions Flue system (PF only) lFue system (PF only) contd Has the flue route been thought about? It must be accessible for fitting. Is Aga drilling the hole through your wall for the ventilation pipe? Aga engineers are only equipped to drill standard 300mm thick brick/block walls. Walls that are constructed of other materials or are thicker than 300mm must be drilled prior to the installation. If the hole goes through a wooden frame or partitioned area inside the wall, a metal sleeve will be needed to protect the inside of the wall. If the hole goes through a wooden frame or partitioned area inside the wall, a metal sleeve will be needed to protect the inside of the wall. Details of this are found on page 4-7 of the installation instructions. Air Supply (CF Only) Air Supply (PF Only Gas supply As this cooker is a fuel burning appliance you may need additional air inside the room. Therefore you may need to fit an air vent within the room Details of this are found on page 29 of the installation instructions The room must have a permanent vent of minimum free air area of 36 cm² Details of this are found on page 29 of the installation instructions A suitable domestic gas meter and supply is required to the left hand side the cooker. Details of this are found on page 28 (CF) and 29 (PF) of the installation instructions. Please provide any additional information which may be relevant to the delivery or installation of the appliance Occasionally certain circumstances may dictate that we will be unable to deliver your product using our standard delivery service. Should an external specialist team be required we will advise you in advance of any additional costs you may incur before we proceed with your delivery. A copy of this delivery and installation checklist should be returned to your store at the time of placing your order. Please retain a copy to assist you with preparing for your Aga installation. If you have any queries once your order has been placed please feel free to call our installations team for further assistance. The team can be contacted Monday-Friday 9am till 5pm on 01952 643 534 To assist you further you can view our pre-installation videos by selecting the correct model in the link below: www.agaliving.com/buying-an-aga/pre-installation-information If a delay is required to your installation date we need a minimum of five working days notice before the agreed date. Failure to provide this notice may incur a charge.