AGA eR3 Point of Sale Site Form Owner's manual

AGA eR3 Point of Sale Site Form Owner's manual
FT or Postcode:
POS Checklist - ER3
Cooker details:
Customer Name:
Customer Address:
Our shop will discuss
this form with you while
you are placing your
order. If necessary you
are welcome to take the
form away and discuss
the points raised with
your contractors.
If you take the form
away with you, please
return the completed
copy to your Aga store
at your earliest
convenience. This will
assist us with finalising
your installation.
Access and
parking
Questions
Can the property be accessed by a 7.5
tonne lorry with a tail lift 2415mm (8ft 3in)
wide?
Are there any special permissions or
permits req?
Route for
delivery
Is there a clear route into the kitchen?
The minimum gap needed is 650mm
(26in) through doors and hallways.
Please give details or any steps, gravel
areas, grass areas, uneven surfaces,
obstacles, tight turns.
Is any floor protection needed?
Floor
What flooring will be under the cooker
position? The cooker is positioned using
wheels so the cooker must sit on the
finished floor, to allow for installation and
removal in the future. The floor must be
level and capable of holding the weight of
the cooker (<310kg)
The cooker base dimensions, weights
and clearances can be found on pages
28-35 of your installation instructions
Position
Will the cooker be positioned between
base units?
Will the cooker be positioned against a
clear wall? If so please ensure this is
marked to enable us to correctly position
the cooker.
Will the cooker be going into a recess?
Is there space for a 3mm gap to be left
each side of the cooker top plate?
Is there space for a 650mm gap to be left
above the cooker?
The cooker dimensions and
clearances can be found between
pages 30-35 of the installation
instructions
Y
N
Notes
Rear wall
Is the rear wall clear of pipes, wires,
drains and other services? The rear wall
must be clear of any obstructions
How much gap should be left behind the
cooker position?
The minimum gap between the top plate
and wall is set as 14mm, however if tiling
behind or fitting a splash back afterwards
we need to know how much extra forward
the cooker will need to be on the day.
The minimum gap of 14mm must be left
open and uncovered.
The cooker dimensions can be found
between pages 30-35 of the
installation instructions.
Worktop
The cooker hotplate height is 913mm off
the finished floor. Will your surrounding
work surfaces match this height?
The cooker dimensions can be found
between pages 30-35 of the
installation instructions.
Electrics
(Main cooker
incl warming
plate)
Where are you planning on positioning
your electrical connections?
The Aga requires a 32amp cooker switch
within 2m either side of the cooker in the
same room. This cannot be behind the
cooker position.
This then connects to an outlet plate
within 2m either side of the cooker
position or recessed into the wall behind
the cooker within the set areas shown in
the instructions. This is where the mains
cable is connected
The full electrical requirements can be
found on page 36 of the installation
instructions
Electrics
(induction
option only)
Where are you planning on positioning
your electrical connections?
An additional electrical supply is required
for the Induction unit. This connects using
either a three pin plug and socket or a
13amp switched fuse spur. This must be
within 2m either side of the cooker and
within the set areas shown in the
instructions. This cannot be behind the
cooker position. Please note if you wish
to use a plug this is not supplied with the
cooker.
The full electrical requirements can be
found on page 36 of the installation
instructions
Please provide any additional information which may be relevant to the delivery or installation of the appliance
Occasionally certain circumstances may dictate that we will be unable to deliver your product using our standard delivery
service. Should an external specialist team be required we will advise you in advance of any additional costs you may incur
before we proceed with your delivery. A copy of this delivery and installation checklist should be returned to your store at the
time of placing your order. Please retain a copy to assist you with preparing for your Aga installation.
If you have any queries once your order has been placed please feel free to call our installations team for further assistance.
The team can be contacted Monday-Friday 9am till 5pm on 01952 643 534
If a delay is required to your installation date we need a minimum of five working days notice before the agreed date. Failure
to provide this notice may incur a charge.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement