FMI VDG36C, VDP36C Operating instructions

FMI VDG36C, VDP36C Operating instructions
INSTALLATION INSTRUCTIONS FOR SIDE PANEL
AND BI-FOLD GLASS DOORS
1. To install the glass panel, insert the two pins, located on
the top of the glass panel frame, into the top door track.
2. Push the glass panel as far up as possible so that the two
pins located on the bottom of the glass panel will fit into the
two pivot plate holes located on the bottom of the fireplace
opening. Adjust the glass panel until it is fully seated. Refer
to Figures 1 and 2.
3. Identify the left and right doors. If the door has pins on the
top, one pin on the bottom, and the handle is located on
the lower right side, it is the left side door.
4. For the left side door, insert the far left pin into the top left
spring clip hole. At the same time, make sure the other top
pin is in the top door trck.
5. Push the glass door up as far as possible so the bottom
pin can be placed into the pivot plate hole. Adjust the glass
door until it is fully seated. Refer to Figure 2.
6. Repeat steps 4 and 5 for the right side door.
Top Slot under
Frame
Adjustment Clip
Short Pivot Pin
Holes for
the Glass
Panel
Holes for
the Left
Door
Bottom Pin
Bottom Slot
Adjustment Clip
Figure 1 - Mounting Hole Locations for Side Panel and
Bi-Fold Doors
Figure 2 - Installing side panel and Bi-Fold doors
Manufactured at:
2701 S. Harbor Blvd.
Santa Ana, CA 92704
www.fmiproducts.com
© 2010 FMI PRODUCTS, LLC
All Rights Reserved
107541-01
Rev. B
12/10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement