3M 3M-Matic™ Adjustable Case Sealer Stainless Steel 700a-s AccuGlide™ 2 Taping Head, 1 per crate Instruction

Uses:
• Keep track of your productivity.
• Know how many cases you are
processing.
• Know when to perform preventative maintenance on your case
sealer.
Features:
• Low Cost: List price of $275 as a kit or
$435 factory installed
• Simple to install
• Works on any AccuGlide II series taping
head.
• Works on every 3M-Matic™ Case sealer
• Displays 6 digits
• Push button reset to zero
• Non-contact sensing provides years of
operation without mechanical wear
Features continued:
• Battery powered by 2 replaceable
N cells, with a nominal life of 4
years.
• Operating temperature range of 22ºF to 167ºF
• Quick disconnects for easy removal
Kit Contents:
Tools Required:
1 ea. Counter Assembly
1 ea. Sensor Assembly
1 ea. 1/4” Diameter Magnet
1 ea. M5x12 Hex Head Screw
1 ea. M5 Split Washer
1 ea. M5 Flat Washer
Phillips Screw Driver
8mm Nut Driver
Step 1: Turn off and lock out any source of power supply (electrical, pneumatic or other) before installing this kit or performing any
adjustments.
Step 2:
Remove the (4) Philips
head screws that fasten
the tape head guard, and
retain them for reassembly.
Step 3:
Remove the guard and retain for reassembly.
Step 4:
Install the Sensor Assembly onto the rear tape
head spacer. Use the M5x12 hex head screw
along with the M5 split washer and M5 flat
washer to secure the assembly into the middle
hole of the spacer. The sensor assembly should
be mounted on the inside of the tape head.
Step 6:
Route the sensor wires over
the top of the bracket and under the tape head spacer.
Step 7:
Replace the tape head
guard, and hand tighten the
front (2) screws.
Step 8:
Install the Counter assembly on top of the tape head
guard. Use the screws that
originally held the guard in
place. The wires from the
sensor assembly fit in the
gap on the guards side.
Step 9:
Press the quick disconnect
terminals together. It doesn’t matter which wire is
connected to which terminal, there is no polarity to
match.
Step 5:
Install the magnet on the applying mechanism spacer. Pull the
applying mechanism spacer towards the sensor and check the
alignment of the magnet. The
magnet should be to either side
of the sensor, it won’t function
in the center of the sensor.
Step 10:
Press the grey reset
button to return the
count to zero. This
completes the installation of the
Throughput indicator.