RTS Dkp-3016 keypanel Manual

RTS Dkp-3016 keypanel Manual
Quick Start Guide
DKP-3016 Keypanel
Included:
• DKP-3016 Desktop Unit
OR
DKP-3016 Wallmount Unit
• 3-pan head wood screw, M5 x 25
• RTS Additonal Website Information
• Safety Instructions
• LIT Quick Start Guide F / DKP-3016
• Notice, Open Source
Requirements:
•
•
•
•
•
•
•
AZedit
IPedit
MCII-e
AIO-16
FWUT
DNS-SD
OMI
V 5.0.0 or later
V 3.2.0 or later
V 3.2.0 or later
V 1.6.0 or later
V 3.3.0 or later
V 3.3.0 or later
V 5.2.0 or later
Installation
To install the DKP-3016, do the following:
1.
On the rear panel of the DKP-3016, plug the AC power cord (A) into the power connector on the back panel of the unit.
IMPORTANT: Only one matrix connection may be active at a time.
2.
Connect a RJ-12, RJ-45 (USOC or 568B) or Ethercon cable (B) with RTS cabling to the J8 FRAME connector on the rear
panel.
OR
Connect an CAT-5e cable (C) to J11 ETHERNET connector on the rear panel.
NOTE:
3.
For OMNEO channel setup, see the DKP-3016 User Manual.
Once the unit is cabled, plug the other end of AC power cord into the wall outlet or power strip.
For the most current user documentation, firmware, and software,
visit www.rtsintercoms.com
Bosch Security Systems, Inc. | 12000 Portland Avenue South | Burnsville, Minnesota 55337
Form Number: F.01U.331.572 Rev 01
Date: March 2017
w w w. r t si n te r c o ms . c o m
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement