RTS Kp-4016pb Manual

RTS Kp-4016pb Manual

Quick Start Guide KP-4016 Push Button Keypanel

Included:

• ASSY KP-4016PB KEYPANEL • POWER SUPPLY 60W 24V @0~2.5A

• KP-OEI2 POWER SUPPLY MOUNTING BRACKET • Safety Instructions • LIT Quick Start Guide F / RP4016 • RTS ADDITIONAL WEBSITE INFORMATION • 2–POSITION, 2–CONTACT TERMINAL PLUG • 6–POSITION, 12–CONTACT TERMINAL PLUG

Requirements:

• AZedit V 5.0.0 or later • IPedit • MCII-e • AIO-16 • FWUT V 3.2.0 or later V 3.2.0 or later V 1.6.0 or later • OMI V 3.0.3 or later • DNS-SD V 3.0.3 or later V 5.1.5 or later

Installation

IMPORTANT

: If you plan to use the Power Supply Mounting Bracket, we recommend you install the mounting bracket before cabling the keypanel. For detailed information, refer to the KP-SeriesTechnical Manual.

To

install the KP-4016PB

, do the following: 1. On the rear panel of the KP-4016PB, plug the

24 Vdc power connector (A)

of the power supply into the power connector on the back panel of the unit.

2. Connect an

RJ-12

or

RJ-45 (568B or USOC) cable (B)

with RTS cabling to the J8 FRAME connector on the rear panel. (analog) OR Connect an

CAT-5e cable (C)

to either J11 or J12 ETHERNET connector on the rear panel. (OMNEO CAT-5e)

IMPORTANT

: If you have the optional J13 fiber connector installed, connect a fiber connector (D) to the OPTICAL fiber connector on the rear panel. (OMNEO Fiber) 3. Once the unit is cabled, plug the other end of

AC power supply cord

into the wall outlet or power strip.

Configuration

Consult the KP-Series Technical Manual (P/N F.01U.304.914) for specific instructions to complete the following steps.

To

configure the KP-4016PB using IPedit

, do the following: Step 1. In IPedit, using Device|Add, add the KP-4016 to the device catalog.

Step 2. Using the Channel Configuration and Status pane, configure the keypanel to communicate with the OMI card.

Step 3. On the keypanel, make a connection using the OMNEO Offers menu item.

To

configure the KP-4016PB using AZedit

, do the following: Step 1. Verify the type of addressing the KP-4016 is using; Static or DHCP.

Step 2. Using the OMNEO Configuration window, configure the keypanel to communicate with the designated OMI card.

Step 3. On the keypanel, make a connection using the OMNEO Offers menu item.

To

configure the KP-4016PB for analog

, do the following: Step 1. Verify the

keypanel is correctly cabled to the matrix

.

Step 2. Plug the

keypanel

into I/O port desired.

NOTE:

If using a SCSI backcard, addressing is necessary.

For the most current user documentation, firmware, and software, visit www.rtisintercoms.com

Bosch Security Systems, Inc. | 12000 Portland Avenue South | Burnsville, Minnesota 55337 Form Number: F.01U.329.753 Rev 01 Date: April 2017 www.rtsintercoms.com

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement