RTS Rt-2m Quick Start Guide

RT-2M (90007891000) Quick Start Guide
INCLUDED PARTS:
•
•
RT-2M Unit
DB-9 Cable
RS-232 Cable Pinout
NOTE:
See the entire system diagram on reverse side.
Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the Step 2. Cable the RT-2M to the Frame.
RT-2M.
To cable the RT-2M to the Frame, do the following:
NOTE:
In Trunk Supervisor, you must designate
1. Using the appropriate connector defined below, connect the
the intercom and port number the RT-2M
RT-2M to the Frame:
sends the test signal over.
CONNECTOR
To cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M, do the following:
1.
RJ-12
Using the included cable, connect a COM port on
the Trunk Supervisor computer to the RS-232
Interface connector on the rear panel of the RT-2M.
DB-9
2.
LIT000306000 Rev. B
CONNECTION
•
•
•
•
Plug pins 2 and 5 into the Ch 1 input connector terminals.
Plug pins 3 and 4 into the Ch 1 output connector terminals.
Plug pins 7 and 8 into the Ch 1 input connector terminals
Plug pins 4 and 5 into the Ch 1output connector terminals.
Connect the other end of the connector to the trunking
connection port as defined in the Trunk Supervisor software.
5/2010