JennAir JMW3430IL RISE 30" Microwave/Wall Oven Dimension Guide

JennAir JMW3430IL RISE 30" Microwave/Wall Oven Dimension Guide
JENNAIR ® DETAILED PLANNING DIMENSIONS
30" COMBINATION MICROWAVE/WALL OVENS
JMW2430I, JMW3430I – 30" x 43-3/4" x 25-5/16"
PRODUCT DIMENSIONS
G
F
30" (76.2 CM) MODELS
A. 43-3/4" (111 cm) overall height
B. 30" (76.2 cm) overall width
A
E
C. JMW2430IM – 26-3/8" (67 cm)
JMW2430IL – 27-3/16" (69 cm)
JMW3430IM – 26-3/8" (67 cm)
JMW3430IL – 27-3/16" (69 cm)
D. 23-1/4" (59.1 cm) max. recessed depth
E. 41" (104.1 cm) recessed height
F. 4
8" (121.9 cm) flexible conduit length measured
from the conduit clamp located at the rear of the
oven. Do not remove the conduit clamp.
B
D
C
G. 28-7⁄16" (72.2 cm) recessed width
OPENING/CLEARANCE DIMENSIONS
30" (76.2 CM) MODELS
A. 30" (76.2 cm) min. cabinet width
B. 2
-1/4" (5.7 cm) top of cutout to bottom of upper cabinet door
C. 19-1/4" (48.9 cm) bottom of cutout to floor is recommended.
4"–19-1/4" (10.2– 48.9 cm) bottom of cutout to floor is acceptable.
D. 28-1/2" (72.4 cm) cutout width
E. 1-1/2" (3.8 cm) min. bottom of cutout to top of cabinet door
F. 4
1-5⁄16" (105 cm)* recommended cutout height
G. 24" (60.7 cm) cutout depth
*NOTE: The cutout height can be between 41" and 41-1/2"
(104.1 cm and 105.6 cm) for microwave/oven combination.
IMPORTANT: Dimensional specifications are provided for planning purposes only.
Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide
before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation.
All JennAir® appliances are appropriately UL, CUL or CSA approved.
®/ ™ © 2018 JennAir. All rights reserved. JEN 25280-006.
1 of 2
JENNAIR ® DETAILED PLANNING DIMENSIONS
2 of 2
30" COMBINATION MICROWAVE/WALL OVENS
JMW2430I, JMW3430I – 30" x 43-3/4" x 25-5/16"
ELECTRICAL REQUIREMENTS
If codes permit and a separate ground wire is used, it is recommended
that a qualified electrical installer determine that the ground path and
the wire gauge are in accordance with local codes.
•
Models rated from 7.3 to 9.6 kW at 240 V (5.4 to 7.4 kW at
A. Model/Serial/Rating Plate 208 V) require a separate 40 A
circuit.
Check with a qualified electrical installer if you are not sure the oven
is properly grounded.
•
A circuit breaker is recommended.
•
Connect directly to the fused disconnect (or circuit breaker box)
through flexible, armored or nonmetallic sheathed, copper cable
(with grounding wire).
•
Flexible conduit from the oven should be connected directly
to the junction box.
•
Do not cut the conduit. The length of conduit provided is for
serviceability of the oven.
•
A UL listed or CSA approved conduit connector must be provided.
•
If the house has aluminum wiring, follow the procedure below:
This oven must be connected to a grounded metal, permanent
wiring system.
Be sure that the electrical connection and wire size are adequate and
in conformance with the National Electrical Code, ANSI/NFPA 70-latest
edition or CSA Standards C22.1-94, Canadian Electrical Code, Part 1
and C22.2 No. O-M91-latest edition, and all local codes
and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
ELECTRICAL CONNECTION
To properly install your oven, you must determine the type of electrical
connection you will be using and follow the instructions provided for
it here.
•
Connect the aluminum wiring using special connectors and/or
tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer’s recommended
procedure. Aluminum/copper connection must conform with
local codes and industry-accepted wiring practices.
For power requirements, refer to the following table:
240 VAC
208 VAC
Model
kW
kW
JMW2430I
8.0
6.6
JMW3430I
8.2
6.6
Oven must be connected to the proper electrical voltage,
amperage and frequency as specified on the model/serial/rating
plate. See the following illustration.
A
A. Model/Serial/Rating Plate
IMPORTANT: Dimensional specifications are provided for planning purposes only.
Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide
before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation.
All JennAir® appliances are appropriately UL, CUL or CSA approved.
®/ ™ © 2018 JennAir. All rights reserved. JEN 25280-006.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement