Legrand 6 Room Audio Distribution Module - 364454-01 Installation Instruction

Legrand 6 Room Audio Distribution Module - 364454-01 Installation Instruction

OnQ Technologies, Inc.

P.O. Box 60907 Harrisburg, PA 17106-0907 800-321-2343 www.onqtech.com

Installation/Instruction Sheet OnQ 6 Room Audio Distribution Module IS-0132 Rev. O 6 Room Audio Distribution Module - P/N 364454-01 1.

2.

3.

Introduction

The OnQ 6 Room Audio Distribution Module provides the distribution of an amplified stereo and audio source to six (6) pairs of speakers through impedance matching volume controls. The module can be mounted in any OnQ service center enclosure and can accommodate up to 14 AWG speaker cable.

NOTE: Failure to ensure proper impedance to the source my result in damage to audio equipment and speakers.

Description

The 6 Room Audio Distribution Module has fourteen (14) removable two-position terminal blocks which are connected in parallel on a printed circuit board. The terminal blocks can be removed to allow for easier wire termination. The module is half an enclosure width and occupies three (3) vertical inches of space.

Installation

A.

Mounting in enclosure - Refer to Figure 2 1) 2) Align tabs on module with slots on the rear of the enclosure.

Insert tabs by angling module away from the back of the 3) 4) enclosure.

Rotate the module and insert fasteners on module into corresponding holes on the rear of the enclosure. (Plunger must be in a pulled position for fastener to engage hole.) Push plunger in to lock module in place. Pull on module to ensure module is locked properly in place.

B.

Connecting Wiring 1) Identify the source (from media center) pair of speaker wires. Position loosely along the side of the enclosure and position over terminal block marked source. Trim with 2-3 inches of 2) 3) 4) 5) excess.

Strips ends 1/4 to 3/8 inch.

Insert into appropriate terminal, keeping left and right “+” and “-” identified.

Figure 2

Repeat steps 1-3 for each set of speakers.

Record source and speaker locations on wiring layout label on enclosure cover.

IS-0132 Rev. O

Ref. P/N 100224-32

Page 1 of 1

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement