advertisement
▼
Scroll to page 2
Wiremold Electrical Systems conform to and should be properly grounded in compliance with requirements of the current National Code or codes administered by local authorities. 30TP-Series Add-Ons For Tele-Power® Poles INSTALLATION INSTRUCTIONS All electrical products may represent a possible shock or fire hazard if improperly installed or used. Wiremold electrical products are UL listed, made for interior use in dry locations only and should be installed in conformance with current local and/or the National Electrical Code. Components Included: 1 Device Plate/1 Mounting Bracket/1 Cover Section 30TP-4 30TP-2 Communication Capacities Communication Capacities Communication Cables- No. of Pairs 30% Fill 25 4 9 40 No. of Cables Communication Cables- No. of Pairs 25 4 30% Fill 3 20 60% Fill 8 40 No. of Cables 18 60% Fill 80 Power Capacities Power Capacities* Wire Type THHN,THWN Size AWG Size AWG Wire Type No. 12 No. 10 48 30 THHN,THWN No. 12 No. 10 14 9 *With surge/GFCI devices Add-On Covers Cover w/Bezel Communications Plate Installed 30TC-CVR 30TC-3S2 One Gang 30TP-C Single Single Rectangular (1.59 [40.39mm] (1.40 [35.56mm] 30TP-L Diameter) Diameter) 30TP-A 30TP-J Duplex 30TP-B 30TP-4 30TP-2 Communication Cover Power Cover Communication Cover Power Cover Figure 1 1.Remove power cover for electrical applications. Remove communication cover for data/phone applications (Fig. 1). 2.Screw on mounting bracket. 3.Install device per NEC recognized wiring methods. 4.Screw on plate, snap on cover. The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251 Canada: 850 Gartshore Street • Fergus, Ontario N1M 2W8 1-800-741-7957 • FAX 519-843-5980 © Copyright 2001 The Wiremold Company All Rights Reserved 40777R1 901
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project