Legrand DS4000 Designer Series Large Raceway Tee Fitting - DS4015 Installation Instruction

Legrand DS4000 Designer Series Large Raceway Tee Fitting - DS4015 Installation Instruction

DS4015 Tee Fitting

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 43270 – January 2006

Step 1.

Mount DS4015 Base to wall using minimum #8 fasteners as shown.

Wiremold / Legrand Electrical Systems conform to and should be installed and properly grounded in compliance with requirements of the current National Electrical Code, Canadian Electrical Code, or codes administered by local authorities.

All electrical products may represent possible shock or fire hazard if improperly installed or used. Wiremold electrical products are UL listed to U.S. and Canadian safety standards, made for interior use only, and should be installed in conformance with current local and/or the National Electrical Code.

j

Step 2.

Install Adjust-to-Fit ™ Couplings to mate with Raceway Base. Align screws to Tabs as shown.

Maximum 4" [102mm] gap allowed.

Align with Tab Set Screw Tab Set Screw Tab NOTE: The DS4015 Tee Fitting can be configured two different ways depending on where the communication cables are installed. Electrical wiring is meant to be housed inside the Internal Tunnel. Communication cables are controlled by the Radius Control Inserts.

Step 3.

Assemble the Internal Tunnel as shown and mount to the top or bottom Channel. Secure the Internal Tunnel with supplied screws to the appropriate holes. Make sure End Stops match the Raceway Cover orientation.

Install Radius Control Inserts as shown.

Internal Tunnel Snap Radius Insert End Stops Internal Tunnel Radius Control Insert with Screw End Stops

For more information, visit www.wiremold.com/ds4000.

ELECTRICAL WIRING – Top Channel.

COMMUNICATION CABLING – Top Channel COVER INSTALLATION:

Hook corners as shown and snap into place.

FITTING COVER REMOVAL – Fitting Cover can be removed using two methods:

Cover Removal with 650RT Cover Removal with Screwdriver

To make the Fittings fully tamper resistant, use part no. DSTRK.

Step 1.

Locate Dimple on Fitting and use as guide to drill 3/16" [5mm] hole for Tamper Resistant Screw.

Step 2.

Install Tamper Resistant Screw through drilled hole in the Cover into the tab with hole on the Fitting Base.

Step 3.

Installation complete.

For more information, visit www.wiremold.com/ds4000.

© Copyright 2006 Wiremold / Legrand All Rights Reserved

Wiremold / Legrand

U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251 Canada: 570 Applewood Crescent • Vaughan, Ontario L4K 4B4 1-800-723-5175 • FAX 905-738-9721

43270 – January 2006 – For latest specs visit www.wiremold.com

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement