e 125 EUGENE O'NEILL DRIVE TITLE TRACJACK UNDERCOVER & ORTRONICS ©". ~ ==, TEL: 860—445—3800 SINGLE GANG FAX: 860—405—2990 MOUNTING SCREW HOLE (2) 6-32 x 1” INTERNAL DS MOUNTING SCREWS Ne ¡A DESIGNATION a“ ? (1) TAMPER PROOF | 2 TRACJACK COVER SCREW | LOCATIONS 1—4 (1) STANDARD | | | DU COVER SCREW Na | Eas (2) DESIGNATION — E > MOUNTING — (2) DESIGNATION CU SCREW HOLE NV — || — 1 ESION BOTTOM TRACJACK LOCATIONS BEFORE MOUNTING BASE TO WALL: FOR TRACJACK OPENINGS 1-4 FEED CABLE THRU EACH OPENING. FOR BOTTOM LOCATION CABLE SHOULD BE LACED THRU ONE OF THE ADDITIONAL CABLE ENTRANCE OPENINGS IN BASE. BASE \ TERMINATE TRACJACKS FOR LOCATIONS 1—4 AND SNAP MOUNT WITH TAB UP INTO BASE. CONNECTOR MAY BE LOCATED IN EITHER OF THE 2 BOTTOM POSITIONS. TERMINATION SLIDE MODULE (FROM OUTSIDE IN) INTO SLOTS OF BOTTOM THE UNUSED POSITION WILL BE USED AS CORD EXIT FOR TRACJACKS POSITION. 1—4 POSITIONS. AFTER > > N \ BASE CLIP SLOT / / COVER CLIP A COVER INSTALLATION NOTES: - 7 SLIDE COVER CLIP INTO BASE AT BOTTOM AND ROTATE COVER UP TO CLOSE. SECURE COVER WITH SCREW AS SHOWN. TO REMOVE THE COVER UNSCREW AND USE A SCREWDRIVER TO PRY CLIP OPEN AT THE BOTTOM OF THE COVER. INSTRUCTION SHEET # | REV. | ECN # SHEET DWN.BY: DATE CHK.BY: DATE APP.BY: DATE OR-71601448 00 1 of 1 LEVESQUE 05/09/05 G.L. 05/24/05 MEM 05/24/05
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021