Beko HCP61310 Owner Manual

Beko HCP61310 Owner Manual
User Manual
HCP 61310 I
HCP 61310 IH
HCP 61310 W
HCP 91310 I
HCP 91310 W
HCP 61310 X
Please read this manual first!
Dear Customers!
Thank you for selecting a Beko product. We hope that you get the best results from
your product which has been manufactured with high quality and state-of-the-art
technology. Therefore, please read this entire user manual and all other accompanying
documents carefully before using the product and keep it as a reference for future use.
If you handover the product to someone else, give the user manual as well. Follow all
warnings and information in the user manual.
Remember that this user manual is also applicable for several other models. Differences
between the models are explicitly described in the manual.
Meanings of the Symbols
Following symbols are used in the various section of this manual:
Important information and useful hints about
WARNING: Warnings for dangerous situations concerning the safety of life and property.
Warning for electric shock.
This product has been manufactured in environmentally friendly facilities.
This appliance conforms to the
WEEE regulation.
This product does not contain
1Important safety and
environmental instructions
1.1 General safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
1.2 Compliance with WEEE Directive and disposing of the waste product . . . . . . . . . . . . . . . . . . . . . . 9
Compliance with RoHS Directive: . . . . . . . . . . . . . . . 9
1.3 Package information . . . . . . . . . . . . . . . . . . . . . . . . 9
2 Use
2.1 Ducting version . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
2.2 Filter version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
3 Installation
3.1 Electrical connection. . . . . . . . . . . . . . . . . . . . . . .10
4 Mounting
5 Operation
6 Cleaning and maintenance
6.1 Cleaning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
6.1.1 Grease filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
6.1.2 Charcoal filter (filter version only) . . . . . . .12
6.2 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
6.2.1 Replacing lamps. . . . . . . . . . . . . . . . . . . . . . . . . .12
Hood / User Manual
3 / EN
1 I mportant safety and environmental
Closely follow the instructions set •• Note: the elements marked with
out in this manual. All responsibility, the symbol “(*)” are optional
for any eventual inconveniences, accessories supplied only with
damages or fires caused by not some models or elements to
complying with the instructions in purchase, not supplied.
this manual, is declined. The hood is •• Before any cleaning or
conceived for the suction of cooking m a i nte n a n ce
o p e rat i o n ,
fumes and steam and is destined disconnect hood from the
only for domestic use.
mains by removing the plug or
disconnecting the mains electrical
1.1 General safety
•• It is important to conserve this •• Always wear work gloves for all
booklet for consultation at any installation and maintenance
moment. In the case of sale, operations. This appliance can
cession or move, make sure it is be used by children aged from
together with the product.
8 years and above and persons
•• Read the instructions carefully: with reduced physical, sensory
there is important information or mental capabilities or lack of
about installation, use and safety. experience and knowledge if they
•• Do not carry out electrical or have been given supervision or
mechanical variations on the instruction concerning use of
product or on the discharge the appliance in a safe way and
understand the hazards involved.
•• Before proceeding with the •• Children shall not be allowed to
installation of the appliance verify tamper with the controls or play
that there are no damaged all with the appliance.
components. Otherwise contact •• Cleaning and user maintenance
your dealer and do not proceed shall not be made by children
with the installation.
without supervision.
6 / EN
Hood / User Manual
1 I mportant safety and environmental
•• The premises where the appliance
is installed must be sufficiently
ventilated, when the kitchen
hood is used together with other
gas combustion devices or other
fuels. The hood must be regularly
cleaned on both the inside
and outside (AT LEAST ONCE A
•• This must be completed in
accordance with the maintenance
instructions provided in this
manual. Failure to follow the
instructions provided in this user
guide regarding the cleaning of
the hood and filters will lead to the
risk of fires.
•• The flaming of foods beneath the
hood itself is severely prohibited.
The use of exposed flames is
detrimental to the filters and
may cause a fire risk, and must
therefore be avoided in all
circumstances. Any frying must
be done with care in order to make
sure that the oil does not overheat
and ignite.
•• CAUTION: Accessible parts of
the hood may become hot when
used with cooking appliances.
Hood / User Manual
•• For lamp replacement use only
lamp type indicated in the
Maintenance/Replacing lamps
section of this manual.
•• WARNING! Do not connect
the appliance to the mains until
the installation is fully complete.
With regards to the technical and
safety measures to be adopted for
fume discharging it is important
to closely follow the regulations
provided by the local authorities.
•• The ducting system for this
appliance must not be connected
to any existing ventilation system
which is being used for any other
purpose such as discharging
exhaust fumes from appliances
burning gas or other fuels.
•• Do not use or leave the hood
without the lamp correctly
mounted due to the possible risk
of electric shocks.
•• Never use the hood without
effectively mounted grids. The
hood must NEVER be used as a
support surface unless specifically
•• Use only the fixing screws supplied
with the product for installation
or, if notm supplied, purchase the
correct screws type.
7 / EN
1 I mportant safety and environmental
•• Use the correct length for the
screws which are identified in the The symbol
on the product, or
Installation Guide.
on the documents accompanying
•• In case of doubt, consult an the product, indicates that this
authorised service assistance appliance may not be treated
as household waste. Instead
centre or similar qualified person.
•• WARNING! Failure to install it should be taken to the
the screws or fixing device appropriate collection point for
in accordance with these the recycling of electrical and
instructions may result in electrical electronic equipment. Disposal
must be carried out in accordance
•• We will not accept any with local environmental
responsibility for any faults, regulations for waste disposal.
damage or fires caused to the For further detailed information
appliance as a result of the regarding the process, collection
nonobservance of the instructions and recycling of this product,
please contact the appropriate
included in this manual.
department of your local
•• This appliance is marked according authorities or the local department
to the European directive 2012/19/ for household waste or the shop
EC on Waste Electrical and where you purchased this product.
Electronic Equipment (WEEE). By Appliance designed, tested and
ensuring this product is disposed manufactured according to:
of correctly, you will help prevent
potential negative consequences •• Safety: EN/IEC 60335-1; EN/IEC
for the environment and human 60335-2-31, EN/IEC 62233.
health, which could otherwise be •• Performance: EN/IEC 61591; ISO
caused by inappropriate waste 5167-1; ISO 5167-3; ISO 5168; EN/
IEC 60704-1; EN/IEC 60704-2handling of this product.
13; EN/IEC 60704-3; ISO 3741; EN
50564; IEC 62301.
8 / EN
Hood / User Manual
1 I mportant safety and environmental
•• EMC: EN 55014-1; CISPR 14-1;
EN 55014-2; CISPR 14-2; EN/IEC
61000-3-2; EN/IEC 61000-3-3.
Suggestions for a correct use in
order to reduce the environmental
impact: Switch ON the hood at
minimum speed when you start
cooking and kept it running for few
minutes after cooking is finished.
Increase the speed only in case
of large amount of smoke and
vapour and use boost speed(s)
only in extreme situations.
Replace the charcoal filter(s)
when necessary to maintain a
good odour reduction efficiency.
Clean the grease filter(s) when
necessary to maintain a good
grease filter efficiency. Use the
maximum diameter of the ducting
system indicated in this manual to
optimize efficiency and minimize
Hood / User Manual
1.2 Compliance with WEEE
Directive and disposing of the
waste product
This product complies with EU WEEE
Directive (2012/19/EU). This product
bears a classification symbol for waste
electrical and electronic equipment
This product has been manufactured with high
quality parts and materials which can be reused
and are suitable for recycling. Do not dispose of
the waste product with normal domestic and
other wastes at the end of its service life. Take it to
the collection center for the recycling of electrical
and electronic equipment. Please consult your
local authorities to learn about these collection
Compliance with RoHS
The product you have purchased complies with EU
RoHS Directive (2011/65/EU). It does not contain
harmful and prohibited materials specified in the
1.3 Package information
Package of the product is made of
recyclable materials in accordance with
our National Legislation. Do not dispose
of the packaging materials together with the
domestic or other wastes. Take them to the
packaging material collection points designated by
the local authorities.
9 / EN
The hood is designed to be used either for
exhausting or filter version.
2.1 Ducting version
2.2 Filter version
In the case of not being able to discharge the
fumes and the steam of cooking outside, the
hood in the lter version can be used mounting the
F deflector on the flue and one or more carbon
filters (on the basis of the model possessed). The
fumes and steam are recycled into the kitchen
through upper grill H.
The hood is equipped with a top air outlet B for
discharge of fumes to the outside (exhaust pipe
and pipe fixing clamps not provided). Connect
the hood and discharge holes on the walls with a
diameter equivalent to the air outlet (connection
Attention! If the hood is not
flange). Using the tubes and discharge holes
supplied with carbon lter, then it
on walls with smaller dimensions will cause a
must be ordered and mounted.
diminution of the suction performance and a
drastic increase in noise. Any responsibility in the The models with no suction motor only operate
matter is therefore declined.
in ducting mode, and must be connected to an
external suction device (not supplied).
Attention! If the hood is supplied
with carbon lter, then it must be re- The connecting instructions are supplied with the
peripheral suction unit.
Fig. 3
The minimum distance between the supporting
surface for the cooking equipment on the hob and
the lowest part of the range hood must be not less
than 65 cm from electric, gas or mixed cookers. If
the instructions for installation for the hob specify
a greater distance, this must be adhered to.
3.1 Electrical connection
The mains power supply must correspond to the
rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood to a
socket in compliance with current regulations and
positioned in an accessible area, after installation.
10 / EN
If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area,
after installation, apply a double pole switch in
accordance with standards which assures the
complete disconnection of the mains under
conditions relating to over-current category III, in
accordance with installation instructions.
Warning! Before re-connecting
the hood circuit to the mains supply
and checking the efficient function,
always check that the mains cable is
correctly assembled.
replacement must be undertaken
by the authorised service assistance
centre or similar qualified person.
Hood / User Manual
4 Mounting
Expansion wall plugs are provided to secure the
hood to most types of walls/ceilings. However, a
qualified technician must verify suitability of the
materials in accordance with the type of wall/
ceiling. The wall/ceiling must be strong enough
to take the weight of the hood. Do not tile, grout
or silicone this appliance to the wall. Surface
mounting only.
The hood is fitted with a control panel with
aspiration speed selection control and a light
switch to control cooking area lights.
Use the high suction speed in cases of
concentrated kitchen vapours. It is recommended
that the cooker hood suction is switched on for 5
minutes prior to cooking and to leave in operation
during cooking and for another 15 minutes
approximately after terminating cooking.
Hood / User Manual
11 / EN
6 Cleaning and maintenance
6.1 Cleaning
6.2 Maintenance
Clean using ONLY the cloth dampened with neutral
liquid detergent. DO NOT CLEAN WITH TOOLS OR 6.2.1 Replacing lamps
INSTRUMENTS. Do not use abrasive products. DO Fig. 1
Disconnect the appliance from the electricity.
6.1.1 Grease filter
Warning! Prior to touching the
light bulbs ensure they are cooled
Traps cooking grease particles.
The grease filter must be cleaned once a month
using non aggressive detergents, either by hand Replace the old light bulb with the one of the same
or in the dishwasher, which must be set to a low type as specified in the feature label or near the
light lamp on the hood.
temperature and a short cycle.
When washed in a dishwasher, the grease filter Remove cover A to access the lamp housing A.
may discolour slightly, but this does not affect its If the lights do not work, make sure that the lamps
filtering capacity.
are fitted properly into their housings before you
To remove the grease filter, pull the spring release call for technical assistance.
Fig. 1
6.1.2 Charcoal filter (filter
version only)
Fig. 2
It absorbs unp leasant odou rs caused by cooking.
The saturation of the charcoal lter occurs after
more or less prolonged use, depending on the
type of cooking and the regularity of cleaning of
the grease filter.
In any case it is necessary to replace the cartridge
at least every four mounths.
The charcoal filter may NOT be washed or
regenerated. Remove the grease filters.
Fit the charcoalfilters over the motor.
Align the pins R on the cowl with the slots S, then
turn the filter clockwise until it locks in place.
Reverse the above procedure to remove the
charcoal filters. Refit the grease filters.
12 / EN
Hood / User Manual
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF