Digital Watchdog DWC-MF21M4TIRDMP MEGApix® 2.1MP/1080p ultra-low profile vandal dome IP camera Installation Guide

Digital Watchdog DWC-MF21M4TIRDMP MEGApix® 2.1MP/1080p ultra-low profile vandal dome IP camera Installation Guide

DWC-MF21M4TIRDMP

Quick Start Guide

QSG Manual L-Wrench Template Sheet for installing by Bolt & Nut Template Sheet for installing by Plate

WHAT’S IN THE BOX

1 Set Mount Bolt & Nut – 2pcs 1 Set Mount Plate 1 Set Screw & Plastic Anchor – 3pcs 1 Set 1 Set 1 Set 1 Set Attention: This document is intended to serve as a quick reference page for initial set-up. It is recommended that the user read the entire instruction manual for complete and proper camera usage.

Tel: 866-446-3595 / 813-888-9555 Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday digital-watchdog.com

STEP 1 – PREPARING TO MOUNT THE CAMERA

1.

The mounting surface must bear five times the weight of your camera.

2.

Do not let the cables get caught in improper places or the electric line cover to be damaged. This may cause a breakdown or fire.

3.

For the installation process, remove the dome cover from the camera module by loosening the three (3) screws on the dome. Use the wrench provided with the camera.

4.

Using the mounting template sheet or the camera itself, mark and drill the necessary holes in the wall or ceiling.

STEP 2 – CABLING THE CAMERA TO EXTERNAL DEVICES

5.

Pass the wires through the mount bracket and make all necessary connections.

a.

NETWORK CONNECTIONS – If you are using a PoE Switch, connect the camera using an Ethernet cable for both data and power.

b.

NETWORK CONNECTIONS – If you are using a non-PoE switch, connect the camera to the switch using an Ethernet cable for data transmission and use a power adapter to power the camera.

Power Requirements DC 12V PoE IEEE 802.3af / PoE Class 2 Power Consumption LED Off: 3.6W, 300mA LED On: 4.3W, 360mA (IR models only)

STEP 3 – INSTALLING THE CAMERA

6.

For soft installation surfaces, use the included metal mount plate. Fix the mount plate on the mounting surface using the included screws. Then, press the bottom case onto the mount plate. The three bezels on the case will align and snap lock onto the plate.

7.

Use the camera’s 3-Axis gimbal to adjust the camera’s tilt and angle. The camera’s maximum tilting angle is 70.

8.

Assemble the dome cover over the camera body and detach the protecting film from the dome bubble.

Template Sheet

4 5 2 1

Quick Start Guide

POWER NETWORK

Reset Button

3

Attach the main body to the mount bracket by tightening the lock screw using the six-angle wrench. To install the camera’s SD Card, locate the SD card slot in the back of the camera module. Insert a Class 10 SD card into the SD card slot by pressing the SD card slot. To remove the SD Card, press the card inward to release from the card slot.

Resetting the camera: To reset the camera, use the tip of a paper clip or a pencil and press the reset button. Pressing the button for five (5) seconds will initiate a camera-wide reset of all the settings, including network settings.

NOTE:

Please refer to DMP guide for additional information on integration and camera control.

Rev Date: 03/19 Copyright © Digital Watchdog. All rights reserved. Specifications and pricing are subject to change without notice.

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement