Extron SMB 210 Series Manual

Extron SMB 210 Series Manual
e
NT:
RTA.com for thtion
lla
IMPO
on
.extr
insta
s.
,
www
ation
uide
Go to te user g specific
d
le
n
p
a
,
m
s
co
on
ti
c
u
instr
SMB Table Clamp Kit • Setup Guide
The SMB Table Clamp Kit secures Extron SMB boxes to table edges. The kit includes the
following items:
#6-32
Screws
Footpads
18” Cable Wrap
Clamp
Cable Shield & Rivet
(SMB 210 Series only)
SMB Table Clamp Compatibility
The chart below lists the number of recommended clamp kits for each SMB model.
Table Clamp range is 0.38” to 2.00” (10 mm to 51 mm).
SMB 210 Series
SMB 110 Series
SMB Model
SMB Model
Clamp Quantity
Clamp Quantity
SMB 111
1
SMB 211
1
SMB 112
1
SMB 212
1
SMB 113
1
SMB 213
1
SMB 114
2
SMB 214
1 or 2
SMB 115
2
NOTE:
Footpads are required if only
one clamp is used for the SMB 213
and SMB 214.
Installation
Follow these steps to install the clamp kit.
SMB 213
Clamp
1
2
If needed, apply the additional
anti-pivot footpads to the left
and right sides of the SMB
bottom panel.
Fasten the clamp
to the SMB using
the two provided
#6-32 mounting
screws.
#6-32 mo
screws.
SMB Table Clamp Kit • Setup Guide (Continued)
NOTE:
The cable shield below is compatible
only with SMB 210 Series boxes, except
for the SMB 211 which can not fit the cable
shield.
Clamp
Fasten the clamp
to the SMB using
the two provided
#6-32 mounting
screws.
Insert the tab
Route cables outof the cable
shield into the
the rear of the SMB
behind
and secure them groove
to
the clamp using athe SMB.
zip tie. Optionally,
use the cable wrap
to dress cables.
Cable
Shield
3
Route cables out
the rear of the SMB
and secure them to
the clamp using a
zip tie. Optionally,
use the cable wrap
to dress cables.
5 S
Secure the cable
Plastic
Rivet
s
shield
to the
clamp using the
included rivet.
Table
he tab
able
nto the
behind
B.
cable
e
g the
vet.
4
3
2
Table
Clamp
Screw
6
Clamp
Screw
Tighten the clamp
to the table edge.
6
For information
on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related
Tighten
the clamp
topics,
see edge.
the Extron Safety and Regulatory Compliance Guide on the Extron website.
to
the table
© 2017-2019 Extron Electronics — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
68-2877-01
Rev. D 04 19
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement