Extron TLP Pro 525M Template

Extron TLP Pro 525M Template

Cut-out Template for the Extron

TLP Pro 525M, TLS 525M, and TLC Pro 526M Series Page size: 8.5" x 11" Print scale 1:1 Do not shrink.

WALL WALL NORTH AMERICA EU /MK

TOP

MK

SURFACE CUT-OUT AREA

MK EU /MK NORTH AMERICA WALL WALL

Outer Edge of TLP Pro 525M Mounting Plate (Do not cut this line)

3.56" H x 5.59" W (90 mm H x 142 mm W)

Outer Edge of TLP Pro 525M Front Bezel (Do not cut this line)

4.03" H x 5.95" W (102 mm H x 151 mm W)

For complete installation instructions, see the

TLP Pro 525M, 725M, and 1025M Series Setup Guide

or the

TLC Pro 526M, 726M and 1026M Series Setup Guide

(at www.extron.com).

1. Confirm the product to be installed.

2. Before printing, double-check the print settings and make sure the page is not scaled.

3. Cut the red line and remove the surface cut-out area (gray) from the template.

4. Measure the gray dotted lines to make sure they have the dimensions shown.

5. Place the template. Use a level to ensure it is at the correct angle and make sure that there is enough room for the touchpanel.

6. Mark the position on the mounting surface where the touchpanel is being installed.

7. Double-check dimensions and position, then cut the opening.

P/N 68-3207-01 Rev. B

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement