Extron VMK 1 Manual

Extron VMK 1 Manual

VMK 1 • Setup Guide

Go to

IMPOR

www

TANT

.extro

complete user guide and installation instructions befor n.com

:

for th e e connecting the touchpanel to the power sour

Overview

The VMK 1 is a VESA mount adapter allowing the TLP Pro 725M and TLP Pro 1025M touchpanels to be installed onto an off-the shelf VESA MIS-D 75mm standard mount. This guide provides instructions for experienced professional installers to mount and install the TLP Pro 725M or TLP Pro 1025M using the VMK 1.

ATTENTION:

• All structural steps and electrical installation must be performed by qualified personnel in accordance with local and national building codes and electrical codes.

• Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualifié, conformément aux codes du bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.

B A TO P INS TA LL VM W M4 SC K IN RE 1 CL WS UD ED 33-2689-01 A ww CA BL E E XIT A VESA mount nut insert (4) B Insertion Hooks C Tongue C Figure 1.

VMK 1 Features

1

VESA Mount

2

VMK 1

3

Mounting Screws

TO P INS VM M4 K 1 WIT SCR CLU EWS DED CAB EXIT 6 4

TLP Pro 725M

5 IN M CA BL E E XIT 33-2689-01 www

Ethernet Cable

e

TLP Pro 725M Rear

6 Figure 2.

VMK 1 Installation and Isometric View

1

VMK 1 • Set up Guide Mounting a VMK 1 to the VESA mount

This section and the following section refer to

f gure 2

on page 1 for its call outs.

1. 2. 3. Install the VESA mounting arm in a stable location (see the third party instructions that came with the VESA mount).

Hold the VMK 1 ( 3 ) over the VESA mounting plate ( 2 ).

Use a Philips-head screwdriver to fasten the included M4x8mm support screws ( 1 ).

Mounting a VMK 1 to the TLP Pro Touchpanel

1. 2. 3. 4. Route the ethernet cable and connect it to the touchpanel before attaching to the VMK 1 adapter mount ( 4 ). The VMK 1 adapter mount has four hooks ( 3 ) one on each corner. Position the touchpanel ( 5 ), so the hooks fit into the touchpanel’s four rear slots (see the

TLP Pro 525, 725, and 1025 Series User Guide

).

Slide the touchpanel down slightly, so the hooks are secure in the slots.

The tongue at the bottom of the VMK 1 adapter mount ( 6 ) sits in the groove at the bottom of the touchpanel. Fasten the touchpanel to the VMK 1 by tightening the lock screw. 0.39” (10 mm)

SIDE VIEW

Figure 3

Gap Between Touchpanel and VMK 1 Mount

NOTE:

There is a 10mm max gap between the VMK 1 mount and the back of the TLP touchpanel. Inserting mounting screws longer than the provided M4 screws may damage the touchpanel. See figure 3.

2

© 2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.

www.extron.com

68-3296-01 Rev. A 10 18

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement